Providing and erecting Street light poles at Heliped Campus ,Sector-17,Dist.Gandhinagar

NAME OF WORK :- Providing and erecting Street light poles at Heliped Campus ,Sector-17,Dist.Gandhinagar

FUND HEAD :- Deposited Work

ITEM ISSUE AMOUN

QTY PARTICULARS

SIGNATURE OF THE CONTRACTOR DEPUTY EXECUTIVE ENGINEER

CAPITAL PROJECT ELECTRICAL SUB DN NO.22

Name of Work: Providing and erecting Street light poles at Heliped Campus ,Sector-17,Dist.Gandhinagar

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Providing and erecting Mains with ISI marked, 1.5KV grade

electrolyte multi stranded, annealed copper conductor with

heat resistant PVC insulated conforms to IS 694, IEC -

1 erected in existing pipe of following size (Specifically for

control panel, relays, power switchgears, motor starters &

control wiring) with required size of copper lugs, nuts and

bolts if required.

200 Mtrs. (f) One wire 10.00 sq. mm 115.14 Fifteen And Mtr.

50 Mtrs. (h) One wire 25.00 sq. mm 295.93 Mtr.

Supplying and erecting Flexible PVC insulated multi strand Rupees Fifty

multi core 1.1 kv grade ISI marked copper wires of following Eight And

2 1981 Mtrs. 58.58 Mtr.

size to be erected as directed. Paise Fifty

e) 1.50 Sq.mm 3 core round PVC sheathed Eight Only

Providing & Erecting following Shockproof tissino type Rupees Twenty

accessories erected on 3 mm thick PC (Polycarbonate) Two And Paise

3 8 Nos. 22.22 Each

sheet in PVC/ Metal/Wooden Box. erected on wall/ ceiling. Twenty Two

(8) Bakelite lamp holder Only

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Supplying and erecting led lamps with following wattage

capacity of 220 to 240 voltage, minimum 15000 burning

hours life, 500 V in built-surge protection,Polycarbonate

diffuser, mounting suitable for E14 / E27 / B22 lamp

4 8 Nos. 112.11 Twelve And Each

(A) LED Lamps integral type, with PC diffuser suitable

(ii) 5 to 8 watts Cat-III

Supplying and erecting LED street light / Flood light fittings

with High power White LEDs wattage of 3 Watt and above

assembled on single MCPCB, efficiency more than

lm/w and corrosion free High pressure die cast aluminum

housing with smooth finish powder coated and heat sink

extruded aluminium with diffuser and Polycarbonate optics/

lenses, with toughened glass with company mark/name

engraved or embossed 160 to 270 V,Power Factor more

5 283 Nos. than 0.95, THD < 10 %, CCT 3000 K to 5700K,Uniformity 5581.26 Each

ratio >0.45, Luminaire efficacy> 100 lumens/watt . LED

driver efficiency > 85 %.( fittings required LM-79 & LM-80

certificates)(NOTE: Below description have shown ranges

of Wattage capacity of LED fittings.The Engineer incharge

may select any wattage capacity between the ranges

shown.) (A) Street Light (IP-65), Surge protection -4KV

integral and ,Light must have 440VAC line supply with over-

voltage protection. (iv) 90 - 119 watts Cat-III

Providing and erecting Approved make Four pole moulded

case circuit breaker having breaking capacity ICU of 25 KA.

at 415 V,having normal current rating up to 25 A to 100A.

with Fixed thermal & magnetic release suitable to work on

6 4 Nos. 6790.23 Hundred Each

A.C. supply 50 c/s. with all internal connections, spreader

tinned copper & complete erected in existing 16 G.M.S.

ICS=100% of ICU only Cat III

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Supplying and erecting triple pole & neutral 440V / 500V

panel mounting Copper Busbars with four equal Nos. of

electrolyte bus having current density not more than

Amp. / sq.mm (Rated current / cross section area) duly

Rn. wrapped with colour insulating tape for phase sequence of Rn.

7 2 1961.42 Hundred Sixty

Mtr. following current carrying capacity, erected with necessary Mtr.

bus bar supports /insulators, main cable socket to each bar,

erected in existing cubical panel with necessary

(A) Suitable for 100 Amp. Capacity

Supplying and erecting KITKAT pattern porcelain cut-out

8 fuse with base of following current capacity erected on

existing block board.

36 Nos. (iv) 63 A 500 V 146.45 Each

Forty Five Only

Providing and erecting Miniature circuit breaker single pole Hundred

0.5A to 2A system and having breaking capacity 10 KA to Ninety Seven

9 283 Nos. 297.95 Each

be erected in existing box. confirming to IS 8828/1996 with And Paise

ISI Mark Cat.III Ninety Five

providing and erecting Miniature circuit breaker single pole Hundred

6A to 25A suitable to operate on 240 V A.C. system and Twenty Three

10 36 Nos. 123.22 Each

having breaking capacity 10 KA to be erected in existing And Paise

box. confirming to IS 8828/1996 with ISI Mark Cat.III Twenty Two

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Providing and erecting Approved make RCCBs conforming

to IS: 12640 and having sensitivity of 30-100 mA and Short

Circuit withstand capacity of 10 KA and suitable for

operation on 3 phase and neutral 415V,50Hz. having

11 12 Nos. 2900.72 Hundred And Each

characteristic of quick action & tripping with all advance

feature & do not incorporate any electronic component for

following Max. rating erected as directed.

(ii) 40Amps. FP Cat. III

Providing , erecting , fabricating the M.S. structure as per

requirement on site incorporating proper size of M.S. Rupees

angles,square,round, flats, bars, channels, sections Seventy Seven

12 1000 K.g complete with cutting, welding, grinding & finishing duly 77.77 And Paise Kg.

painted with one coat of red oxide with erection on site as Seventy Seven

per direction of engineer in charge with necessary grouting, Only

cementing, plastering & finishing complete.

Providing and erecting Pipe type earthing having

cms.long and 2.5 cms. dia. galvanised iron pipe with

13 274 Nos. 368.65 Eight And Each

coupling and buch buried in specially prepared earth pit

complete with necessary 8 SWG earth wire.

For using salt and charcoal / coke as required for pipe type

14 274 Nos. 171.70 Seventy One Each

Providing and erecting XLPE (IS:7098)(I)-88 ISI armoured Rupees One

cable multistrand Aluminium conductor for 1.1 KV. to be Hundred Eighty

15 6425 Mtrs. laid on wall with necessary clamps or in existing trench / 184.83 Four And Paise Mtr.

pipe of following size of cables Eighty Three

(A) 4 core 16 Sq. mm Only

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Making trench in soft soil of suitable width of 90 cm deep

for laying cable or locating the fault all over the run and

16 4500 Mtrs. 55.55 Five And Paise Mtr.

back filling the same and making the surface as normal

Fifty Five Only

Making trench in Hard Murrum / Tar Road of suitable width

of 90 cm or required depth for laying any size of cable or

locating the fault all over the run and back filling the same

17 400 Mtrs. 432.28 Two And Paise Mtr.

and making the surface as normal ground.

(B) If additional machinery like hammer driller or JCB use

Drilling the road without breaking the road surface (Asphalt) Hundred

for laying of cable for feeding power supply by making up to Ninety Two

following size of holes at both ends complete. And Paise

(A) Up to 100 mm bore dia Eighty Eight

Providing & laying approved make Double walled

corrugated pipes (DWC) of polyethylene(conforming to IS

14930 II )with necessary connecting accessories of same

19 5851 Mtrs. 73.73 And Paise Mtr.

material at required depth in existing trench for laying of

cable. below ground / road surface for enclosing cable

(B)63mm outer dia

Providing and erecting Solder less crimping type Aluminium

lugs conforming to IS suitable for cable of following size

evenly crimped with high pressure tool & connected to

20 2192 Nos. 15.15 And Paise Each

switchgear terminals with brass/cadmium plated nut bolts in

an approved manner.

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Supplying and erecting approved make Octagonal pole

made from HR sheet steel. The pole should be made as

per IS. and shall be coated with hot dip galvanizing as per

IS 2629/2633/4759, suitable suspend local wind speed with

integral Junction box consist of terminal plate of min 6mm

Hylam sheet, standard profile 35mmX7.5mm Din-Rail for

MCB Mounting, stud type terminal and arrangement for

21 274 Nos. 9011.22 Eleven And Each

cable termination to be erected With Suitable foundation

(Included) as per details given by manufacturer

considering site requirement.(D) 6 Mtr. Long 70 mm Top X

135 mm bottom dia, 3 mm thickness with

200mmX200mmX12mm base plate, 4-M20 Bolts and

600mm long with necessary G.I. J Bolts .Approx Pole

Providing and erecting street light pole bracket comprising

main B Class GI pipe of 4.2 cm/require outside dia.

complete with suitable B Class G.I sleeve tubing of approx.

45cms.length and suitable for 76.5 mm / 80mm. / require

size pole top having sufficient fasteners for fixing the

brackets and having spread of 1 mtr. length with suitable

rise as per site condition & suitable welded stiffener reducer

and nipple with check nut complete painted with one coat of

Red oxide / PU base primer and two coats of Aluminium /

PU paint. paint with following nos of arms.

265 Nos. [A] Single Arm bracket 1 Mtr 614.08 Fourteen And Each

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

9 Nos. [B] Double Arm Bracket 1 Mtr 829.21 Each

Supplying & erecting IP 55 grade following size section

pillar fabricated from joint less M.S. Sheet with angle iron

legs made from jointless M.S. Angle with cable clamps to

be buried in ground to have appropriate erection to work

uniform until erected with cement concrete foundation and

45 cm high bricks work finishing with plaster etc. hinged

double door internally supported on both side, with internal

and outside looking arrangement with look and keys in

23 4 Nos. duplicate 35 x 35 x 5 mm M.S. Angle of Two Nos. one is 16691.26 Each

welded and other with nut and bolt for erecting Bakelite

sheet. Painting the Section Pillar inside and out side with

three tank powder coated paint. section pillar roof should

be without joint with water leakage proof & tested as per IP

55 test & followed by IS 2147 of

(A) 150 X 90 X 75 cm section pillar fabricated from

Gauge MS Sheet with angle iron legs 95 cm long made

from 40 X 40 X 6 mm thick MS angle.

Supplying and erecting HYLAM sheet on existing angle iron Hundred

24 4 sq.mtr 1927.08 Sq.mtr

frame.for following thickness. (E) 10mm Twenty Seven

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Supplying & erecting approved make Digital time switch

having lithium cell 6 years operative and operate battery

backup 1 channel day clock with 14 memory programme,

suitable to operate on 240V + 5%, 16A with, floating

25 4 Nos. contacts Minimum switching setup time 1 minimum & LCD 3168.37 Each

display. Also comprised permanent ON/OFF switching.

Programming switches & housed in fire proof thermoplastic

enclosure & transparent cover erected as required with

necessary connection erected as directed.

Sr.N Rate in Rs.

Qty. Item Per Amount In Rs.

o. In Figure In Words

Providing and erecting AC-3 duty 3 pole power contactor

with 2 NO & 2 NC aux contacts complete with 415V/220V

26 4 Nos. 12297.76 Ninety Seven Each

operating coil suitable for (L&T, BCH,T.C., Siemens, C&S

make).(E) for 110 A rating

Total Amount Rs.

Total Amount Rs.

In Words:- Rupees Seventy Four Lakh(s) Forty Two Thousand Eight Hundred Ninety Two Only

I / WE am / are willing to carry out the work ………………………………% above / below percent (Should be written in figures

and words) of the Estimated rates mentioned above. Amount of my / our tender works out as under.

Estimated Amount Put to

Amount Put to Rs.=7442892.00 Rs.=7442892.00

Net Total Rs.______________________ Net Total Rs.____________

Less for the D.M

Name of Work: Providing and erecting Street light poles at Heliped Campus ,Sector-17,Dist.Gandhinagar

DM rate Rate Quoted By

Sr.no Item Qty. Per Total

Per Unit Agency

1 1.5 sq.mm 3 core Round PVC 126 Mtrs 4.95

2 St. light fitting 18 Nos. 322.86

3 MCB SP 18 Nos. 14.05

4 St light pole 7 Mtr 18 Nos. 622.80

5 St light Bracket single Arm 1 mtr 18 Nos. 50.85

6 Cable 4x16 with gland and lugs 360 Mtrs 9.96

Total DM Amount Rs.

Dy.Exe.Engineer

Sign Of Contractor CP Electrical Sub Div.22