LAC-ADS-Malappuram LAC- Project No.25408- Installation of Passanger Lounges ( Bus waiting Sheds) at 6 Different Locations of the Constituency-General Civil Work

Bus waiting shed -Near KSRTC Depot

50.6.1.5 Solid block masonry using pre cast solid blocks ( Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 Part I of 1979 for super structure up to floor two level thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etc complete

13.1.1 12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

10.2 Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

10.28 Providing and fixing stainless steel (Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete, i/c fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer-in- charge, (for payment purpose only weight of stainless steel members shall be considered excluding fixing accessories such as nuts, bolts, fasteners etc.)

50.10.2 Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

OD318303/2025-2026 Providing and fixing pre-coated 0.35mm thick or nearest available thickness powder coated trafford sheet roofing up to any pitch and fixing with polymer coated j or L hooks , bolts and nuts 8mm dia GI plain and bitumen washers or with self drilling fastener or EDPM washers etc. complete. excluding the cost of purlins, rafters and trusses and including to size and shape wherever required.

11.20.3 Chequerred precast cement concrete tiles 22 mm thick in footpath & courtyard, jointed with neat cement slurry mixed with pigment to match the shade of tiles, including rubbing and cleaning etc. complete on 20 mm thick bed of cement mortar 1:4 ( 1 cement : 4 coarse sand).Dark shade pigment using ordinary cement

OD318870/2025-2026 Providing and fixing I st quality wall clading tiles of latarate finish (thickness to be specified by the manufacturer), of approved make, of any size as approved by Engineer -in-Charge, in skirting, risers of steps and dados, over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 coarse sand) and jointing with grey cement slurry @ 3.3 kg per sqm, including pointing in white cement mixed with pigment of matching shade complete.

OD299771/2025-2026 Providing and fixing Ceiling with 7.5 mm thick prelaminated PVC ceiling pannels fixed using 25x25mm aluminium angle as perimeter section (outer) and for vertical stay, 25mmx25mm aluminium square tube at 75cm c/c for horizontal frame work including cleat angle, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-charge.

OD299807/2025-2026 Supplying and fixing 30 cm size projected stainless steel letters for name board including the cost of all materials and labour charges etc complete

Electrical works

OD300185/2025-2026 Providing and fixing LED ceiling lamps-26 Nos of 10W, necessary wirings with all conncected fixtures,FM radio system,mobile phone charging ports,500W solar panel,24V,100Ah Lithium battery,MPPT 40A/24V charge controller and all necessary installations like panel supporting frame work with GI tubes,storage for battery etc complete

OD300330/2025-2026 Providing and fixing LED ceiling lamps-4 Nos of 10W, necessary wirings with all conncected fixtures,200W solar panel,12V,60Ah Lithium battery,MPPT 20A/12V charge controller,FM Radio system ,Charging ports and all necessary installations like panel supporting frame work with GI tubes,storage for battery etc complete

Bus Waiting Sheds at Other Five Locations

2.8.1 Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.8 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources)

4.1.4 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (1 Cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 40 mm nominal size derived from natural sources)

4.3.1 Centering and shuttering including strutting, propping etc. and removal of form work for:Foundations, footings, bases for columns

50.6.1.5 Solid block masonry using pre cast solid blocks ( Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 Part I of 1979 for super structure up to floor two level thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etc complete

13.1.1 12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

10.2 Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

10.28 Providing and fixing stainless steel (Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete, i/c fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer-in- charge, (for payment purpose only weight of stainless steel members shall be considered excluding fixing accessories such as nuts, bolts, fasteners etc.)

50.10.2 Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

OD318531/2025-2026 Providing 10 mm thick heavy duty fiber cement board roofing up to any pitch and fixing with self drilling fastener and EPDM washers etc. complete (excluding the cost of purlins, rafters and trusses), including cutting sheets to size and shape wherever required.(Based DSR 50.12.3.1)

OD318532/2025-2026 Providing and fixing Shingles of approved quality,pattern and shades over roof on a bed of asphaltic underlayment,including fixing with nails etc. complete.

11.20.3 Chequerred precast cement concrete tiles 22 mm thick in footpath & courtyard, jointed with neat cement slurry mixed with pigment to match the shade of tiles, including rubbing and cleaning etc. complete on 20 mm thick bed of cement mortar 1:4 ( 1 cement : 4 coarse sand).Dark shade pigment using ordinary cement

OD318864/2025-2026 Providing and fixing I st quality wall clading tiles of latarate finish (thickness to be specified by the manufacturer), of approved make, of any size as approved by Engineer -in-Charge, in skirting, risers of steps and dados, over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 coarse sand) and jointing with grey cement slurry @ 3.3 kg per sqm, including pointing in white cement mixed with pigment of matching shade complete.

OD300274/2025-2026 Providing and fixing Ceiling with 7.5 mm thick prelaminated PVC ceiling pannels fixed using 25x25mm aluminium angle as perimeter section (outer) and for vertical stay, 25mmx25mm aluminium square tube at 75cm c/c for horizontal frame work including cleat angle, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-charge.

OD300211/2025-2026 Supplying and fixing 30 cm size projected stainless steel letters for name board including the cost of all materials and labour charges etc complete