REPAIR AND MAINTENANCE OF FENCING, FOOTPATH/ HARDSTANDING, BOUNDARY WALL GATE PILLAR ETC RAIWALA MIL STN UNDER AGE (I) RAIWALA

Amount

Dismantling of posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion from natural ground and making good disturbed ground complete all as specified and directed.

Excavating post holes or similar holes, each not exceeding 0.5 Cu. M, getting out in Soft/ disintegrated soil,

M & L for Plain Cement Concrete Type D2 1:4:8 (using 20 mm graded stone aggregate) in foundations, filling and mass concrete.

M & L for Removing excavated materialls and depositing at a distance n. exc 50 Mtr at a level n exc 1.5 m above the starting point all as directed.

S & F of mild steel work as in, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe – 290 Gde E -165 complete all as specified and directed.

--Ditto-- as per above item but except material but incl fabrication

Dismantling fencing wire mesh any type

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc., including provision of binding wire.

Supply only Chain link MS Galvanized fencing, any size or type

Mild steel round bars 10 mm dia., and over cut to length, bent to shape required, including with screwed ends, nuts, washers and mild steel plates for walls etc. king rods and straining bolts confomiing to Fe-290 Gde-E-165

S&F in repair galvanised 2 strand, steel barbed wire 2.24mm dia, barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossing with and provision of galvanised mild steel wire staples or steel pins etc as directed. Note :- Each line of horizontal / vertical / diagonal wire to be measured for the purpose of payment.

M&L for removal of vegitation growth and bushes etc n.exc. 30cm girth including cutting of trunk portion, protruding over ground, digging out roots, filling holes and leveling off ground, stacking of serviceable material and removing of unserviceable material to a distance n exc. 50m and clearing the site complete all as specified and directed.

Restraining resecuring including making good staples etc galvanised 2 strand, steel barbed wire 2.24mm dia, barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossing with and provision of galvanised mild steel wire staples or steel pins etc as directed. Note :- Each line of horizontal / vertical / diagonal wire to be measured for the purpose of payment.

Dismantling structural steel work including doors, gates any description complete all as specified.

S F for framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete

M&L for preparation of new surfaces of steel of any description over 10cm in width or girth apply two coats of synthetic enamel paint over a coat of Red oxide primer complete all as specified.

M&L preparation of old painted steel surfaces of any descripton over 10cm width or girth and applying one coat of synthetic enamel paint First quality all as specified and directed .

Demolition of cement concrete (un-reinforced) in Ground floors and paving n.exe 15cm thickness ( below or above ground level ) including removal of rubbish out side complex (MOD land), complete all as specified and directed.

M & L for Plain Cement Concrete Type D2 1:4:8 (using 20 mm graded stone aggregate) in sub base of flooring/ hard standing /footpath

Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-40 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand; complete.

Providing, cement concrete Type B1 1:2:4 (20 mm graded aggregate) in kerbs or mud stops, rounded or chamfered on edges

Demolition of brick work built in cement mortar in any description and position complete all as specified and directed.

Brick work with sub-class `B' bricks, straight or curved on plan exceeding 6 M mean radius built in cement mortar 1:6

Brick work with sub-class `B' bricks, straight or curved on plan exceeding 6 M mean radius built in cement mortar 1:6, except brick work

M & L for PCC 1:3:6 type B0 (using 12.5 mm graded stone aggrgate) as in coping.

M&L Rendering 15 mm thick on fair faces of brick work or concrete walls surfaces in CM 1:6 finished to even & smooth without using extra cement.

M&L for applying two finshing coat of cement based paint over a coat of alkali resitant primer including Prepraing surface of old surface with complete removel of existing treatment complete all as specified and as directed by Engr-in-charge.

M&L for preparation of surfaces of new plaster surface of wall and applying two coat of cement base paint complete all as specified and directed.

Preparation Old painted concrete surface of any descroption surfaces exc. 10 cm width or girth and applying two coat of synthetic enemelled paint of any tint over a coat of primer incl. all preparation complete all as specified and directed.

TARUN ENGINEERING WORKS (BID ID -3417458)

RAMAN CONSTRUCTION CO. (BID ID -3417456)

M/s RP AGRAWAL (BID ID -3417489)