CONSTRUCTION OF VERIOUS WORK PALANPUR NAGARPALIKAS AREA UNDER SJMMSVY UDP-88 2024-25 BACHAT GRANT

Sr.No Item Total Units QTY Amount

Demolition and disposal of unserviceable materials

1 with all lead and lift .(ii) unreinforced cement concrete. 623.02 CUM 1263.74

Box cutting the road surface to proper slope and

camber for making a base for road work including

removing the excavated stuff and depositing on the

road side slope as directed upto 50 mts. Lead.

LIME .MURRUM BULIDING RUBBISH EARTH MANURE OR

3 SLUDGE & EXECAVATED ROCK AND RUBBISH 103.26 CUM 2838.83

(2) EARTH 5 KM LEAD

Filling in foundation and plinth with murrum or selected

soil in layers of 20cm. thickness including watering,

ramming and consolidating etc. complete.

Providing and laying cement concrete 1:4:8 (1 Cement :

4 coarse sand :8 hand broken stone aggregates 40 mm

5 nomial size) and curing complete excluding cost of form 2653.42 CUM 964.84

work in (A) Foundation and plinth

Providing and laying controlled cement concrete M.200

and curing complete excluding the cost of formwork

and reinforcement for reinforced concrete work for C.C.

6 Road Including Compaction and finishing by trimix 4517.71 CUM 800.48

process including providing Construction Contraction

etc. completed as directed by engineer in charge.

Providing and fixing pre-cast Rubber Dye / steel Dye

inter locking concrete block 60mm thick with grade of

concrete M300 pnumatic compressed / vibrated

mechanically and as per approved design Confirming to

IS 15658 : 2006 including 35 mm Sand layer for levelling

and filling the joint with sand in proper line and level as

per guidlines of IRC : SP 63-2018 etc. Complete.

Providing and fixing pre-cast Rubber Dye / steel Dye

inter locking concrete block 80mm thick with grade of

concrete M300 pnumatic compressed / vibrated

mechanically and as per approved design Confirming to

IS 15658 : 2006 including 35 mm Sand layer for levelling

and filling the joint with sand in proper line and level as

per guidlines of IRC : SP 63-2018 etc. Complete.

Providing and fixing pre-cast concrete kerb stone of

gray cement based concrete block 30cm length,30cm

height and 15cm thick of M250 grade concret as per

9 approved design and including excavation for fixing in 374.92 RMT 35.00

proper line and level,filling the joint with C:M 1:3

(1cement:3fine sand) etc complete.

Tracing of old manhole

Providing premoulded asphalt filler joint as per drawing

Providing and fixing junction board of M.S plate and

angle as per standard IRC design including fixing in cc

1:4:8 with neccesary excavation, painting,figuring and

lettering on board etc

Drilling of 250/300 mm dia pilot bore hole inalluvial

strata by DR Rig

(G.W.S.S.& B. S.O.R. 2022-23 Section A I.N.-33-e

Conducting Electrologging Test of 250mm dia bore hole

incl. Carting and idle hours (G.W.S.S.& B. S.O.R. 2022-

23 Section A I.N.-5 (Page No. 6)

Reaming of 250/300 mm dia pilot bore hole to 550 mm

dia bore hole including assembling, jointig, lowering

15 housing casing, strainer pipe, Gravell packing, clay 348.00 Mts 90.00

packing etc.comp. (G.W.S.S.& B. S.O.R. 2022-23

Section A I.N.-33-e (Page No. 12)

Development of Each water bearing zones comes/across

up to the full depth of tube well (Size 200/250/300 mm

dia depth more then 150 mts ) by lowering 100 mm dia

dropline and 32 mm dia GI air line for each zone with

16 suitable capicity Aircompressor up to the availability of 27155.00 Job 1.00

send free discharge. (G.W.S.S.& B. S.O.R. 2022-23

Section A I.N.-33-e (Page No. 12)

Development of above mentoined by Aircompressor

1100 C.F.M / 300 PSI capacity up to 6 hrs minimum

17 untill sand free discharge of the bore wichever is lesser. 34662.00 Job 1.00

(G.W.S.S.& B. S.O.R. 2022-23 Section A I.N.-33-e

Slotting of 250 mm dia pipe having Slot of 6.75 cm x

Section C I.N.-2B-B (Page No. 26)

Slotting of 250 mm dia pipe having Slot of 6.75 cm x

Section C I.N.-2A-B (Page No. 26)

Supply of best quality of well sorted "Sevaliya" Gravell

20 having size of 4mm to 10 mm (G.W.S.S.& B. S.O.R. 2029.00 Cmt 8.00

2022-23 Section A I.N.-33-e

Supply of Clamp made from M.S. Plate with three holes

on either side with nuts & Bolts of Std make & Suitable

21 size 900mm x 100mm x 16mm Flat Suitable for 250 2017.73 Pair 1.00

mm dia Pipe. (G.W.S.S.& B. S.O.R. 2022-23 Section

H (Page No. 17)

Bore Plug having 100 mm height made from M.S. Plate

with three holes at equial distance on circumference for

nut Bolts type locking arrengement with nuts-bolts &

lock nuts of Std make Complete from 5mm thick MS

22 plate ( For Top Also ) Suitable for 250mm dia Pipe 1150.12 No 1.00

(G.W.S.S.& B. S.O.R. 2022-23 Section B I.N.-2-B-iii

MS Bail Plug having Length 0.45 Mt from Medium

class pipe as per I.S.S. Suitable for 250mm dia pipe

(G.W.S.S.& B. S.O.R. 2022-23 Section B I.N.4-A-c

Steel Bent Plate suitable to 250mm dia ERW Pipe size

23 Section B I.N.-5 -C (Page No. 18)

Flat P.V.C.Cable for sub pump detaild technical

spcification as per GWSSB rate contract Size 1 x 3 x

(Mech SOR 2022-23 p-34 it no 3.1 G) (Double Layer)

Electric motor driven borewell submersible pump set

confirming to IS 8034 and motor confirming to IS

9283 working at 3 phase 400 / 440 volt 50 Hz AC

26 supply & 2900 RPM. Cat 9.4 Discharge 1200lpm Head 79778.00 no 1.00

167m 75HP (Mech SOR 2022-23 p-33 it no 1)

Supplying of ERW pipes as below 250 mm dia ERW

blank pipes (7.10 mm thick) IS:4270/2001 (Rates are

Exclusive of GST) (G.W.S.S. & B. SOR 2022-23

Section B I.n.-7-B (Page No. 18)

Supply of various size of ISI marked Heavy duty GI

column pipe as per IS: 1239 part I with latest

28 amendment (Rates are Exclusive of GST) (G.W.S.S. & 1100.00 rmt 90.00

B. SOR 2022-23 sr no. 22 d) 100 mm (Page No. 25)