SUPPLY OF TOOLS-NEEDLE NOSE PLIER, PLIER, WIRE CUTTER,SCREW DRIVER(2-IN-1), ELECTRICIAN KNIFE, CONTINUITY TESTER, PUNCH, HACKSAW SMALL, LT DIGITAL PEN, INSULATION TAPE(HT) AND LINE TESTER AS PER SPECIFICATION FOR CITY DIVISION, PGVCL PORBANDAR

Qty Unit Rate Amount

No. Technical Specification

NEEDLE NOSE PLIAR

1 Make-Taparia 6 inch with Heat-treated Jaws, Plastic 150 Nos. 270

Make-Taparia Length: 210 mm

Make-Taparia Length: 165 mm

SCREW DRIVER (X AND FLAT)

Make-Taparia Screwdriver 2 in

ELECTRICIAN KNIFE WITH FOLDABLE DESIGN

5 Make: Taparia Foldable design with strong and sturdy 30 Nos. 160

CONTINUITY TESTER

Continuity tester with light for checking electrical wire and

power between two points. Maximum 100 ohm resistance

Make: Taparia Punch with 10 no. star point

HACKSAW SMALL (WITH BLADE)

Make-Taparia With extra blade

LT DIGITAL ELECTRIC PEN

Make-Taparia With LED and voltage level indicator

INSULATION TAP (HT)

Test as per ASTM D 4325-20, Minimum 33 Kv/mm - type

tested and minimum 35 mm width and 9 meter length of

Make-Taparia 180mm

ESTIMATED TOTAL VALUE

1. As these tools are for use in electrical work, the quality of items supplied must be of standard/branded

make and BIS-certified (or ISI-marked, where applicable); sub-standard or inferior-quality products will

not be accepted.

2. Quote rates excluding taxes (i.e., GST). GST will be paid extra, over and above the quoted rates, on

submission of GST-compliant bills/invoices.

3. Submission of a sample is mandatory; samples will not be returned. Supplied items must conform to the

sample provided.

4. The supply order will be placed as per the actual requirement for each item.

5. Items supplied must conform to the technical details/specifications.

Executive Engineer

PGVCL, City D.O.,