Replacement of pipe culvert by V.R Bridge at RD 1150 on Khera Kalan, Sarasvati Tribytary in village Khera Khurd, block Sarasvati, Yamuna Nagar

Amount

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead up to 50 m and lift up to 1.5 m, as directed by Engineer-in-charge. All kinds of soil (HSR 4.12.1)

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil. (HSR 4.14.1)

Filling available excavated earth (excluding rock) in trenches, cum plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m. (HSR 4.32)

Brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: Cement mortar 1:3 (HSR 7.21)

Dressing bed and preparation of sub grade for lining by mechanical/ mannual means. (HSR 14.1)

Dressing side slopes and preparation of sub grade for lining by mechanical/ mannual means ( HSR 14.2)

PCC Grade M15 i/c centering and shuttering. (with concrete Mixer) Height up to 5m

RCC Grade M25, Height up to 5m including centering and shuttering ,With Batching Plant, Transit Mixer and Concrete Pump.

Providing and laying boulders apron on river bed for protection against scour with stone boulders weighing not less than 40 kg each complete as per drawing and Technical specification. Boulder Laid Dry Without Wire Crates. Including excavation for trimming for preparation of bed. Nominal excavation required for preparation of bed has been taken into account while making provision for labour.

Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect below plinth level Thermo- Mechanically Treated bars of grade Fe-500D or more.(HSR 6.33.6)

Providing and fixing in position 20 mm thick premoulded joint filler in expansion joint for fixed ends of simply supported spans not exceeding 10 m to cater for a horizontal movement up to 20 mm, covered with sealant complete as per drawing and MoRT&H specifications.(HSR 27.51.3).

Pointing on brick work or brick flooring with cement mortar 1 :3 (1 cement : 3 fine sand) ( HSR 11.25.1)

Providing and fixing in position caution iron board

Providing weep holes in Brick masonry/Plain/ Reinforced concrete abutment, wing wall/ retum wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 1 V :20H towards drawing force. Complete as per drawing and MoRT&H Specifications

Credit for existing brick work.

Credit of Existing RCC pipe of dia 1200 mm

The Swami Ji Co-Op L and C Society Ltd., Jind