Providing Sewerage Scheme Kullu Manali Airport at Bhunter SH Providing, laying, jointing and testing of DI pipe distribution system and providing pumping machinery to lift the sludge from septic tank to main collection chambers

Amount

Excavation in foundations, trenches etc.in all kind of soil in all leads and lifts such as pick work, jumper work in saturated/unsaturated soil including bailing out water, blasting work in hard/ soft rock or chiseling in hard/soft rock where blasting is prohibited in all lifts stacking the excavated earth not more than 3 mtrs clear from the edge of excavation and then returning the stacked soil in 15 cm layers when required into plinths sides of each deposited layer by ramming and watering and then disposing of all surplus excavated earth foundations etc., consolidating as directed within all leads and lifts and handing over the useable materials available from excavation to department free of cost to the entire staisfaction of Engineer-in-charge with in all leads and lifts

Providing laying & Jointing of DI pipes in trenches confirming to IS 8329-2000 in standred lengths of 4 mtrs. To 6 mtrs. 100 mm dia Class- K-9 including testing and providing tyton (push on joints) to ductile iron and fittings with tyton rubber ring (SBR quality) conforming to IS 12820-1989 , including testing of joints. Earth work to be measured and paid for seperately) complete within all lead and lift as per direction and satisfaction of the Engineer in charge.

Providing and laying cement concrete 1:4:8(1cement:4sand: 8 graded stone aggregate 40mm nominal size) and curing complete excluding the cost of form work in foundation and plinth in all leads and lifts.

Providing and laying cement concrete work 1:1.5:3 (1cement 1.5sand: 3graded stone aggregate 20mm nominal size & curing complete excluding the cost of form work and reinforcement for reinforced concrete work in:

In foundations, footing bases of columns and the like and mass concrete work compele in all respect.

Columns pillars posts etc. up to floor two level.

Providing form work with steel plate 3.15 m.m thick welded with angle iron 30x30x5 m.m so as to givea fair finish including centering ,shuttering, propping etc. height of propping and centering below supporting floor to ceiling not exceeding 4 meters and

Vertical surface such as walls(any thickness) partitions and the like including attached pillasters, butteresses, plinth and string courses and the like. For Pillers

Providing and laying tor steel reinforcement for RCC work including bending, binding and placing in position complete up to floor two level including cost of binding wires and carriage of materials upto all leads & lifts as per the direction & entire satisfaction of Engineer-in-charge.

Providing and fixing of water proof PVC Cable 3 core as per IS-674-Part-ll-1964 suitable for above pump sets from transformer to starter subject to the approval of HPSEB authority as per the satisfaction of Engineer-in-charge. 6.00 sqmm

Providing and fixing of water proof PVC Cable 3 core as per IS-674-Part-ll-1964 suitable for above pump sets from starter to pump set subject to the approval of HPSEB authority as per the satisfaction of Engineer-in-charge. 4.00 sqmm

Providing and fixing of three phase starter (direct on line) of 3.00 HP of standard make such as L&T/MEI/Havels/AVON/Crompton/ Asian for above pump set with suitable capacity installed on a wooden switch board fixed on a wall capable of mounting a voltameter 0 to 440volts capacity and ampere meter of capacity 0 to 50 ampere of standard make as per the satisfaction of Engineer-in-charge.

Providing and fixing double flanged Cast Iron non return sluice valve Class-I IS: 780-1984 of Kirloskar/Leader/Bhel/Pelican/ Kartar make 100mm dia for the pipe line capable to withstanding normal seat pressure including cutting, welding, providing and fixing rubber/asbestos sheet of maximum thickness 3mm as per IS: 2712-1979 and providing and fixing MS nuts and bolts as per Table-17 of required number including carriage of material in all leads and lilfts.

Providing and fixing double flanged Cast Iron Sluice valve Class PN-1.6 of BS-1414-API-600 latest with uptodate ammendments of Kirloskar/Leader/Bhel/Pelican/ Kartar make 100mm dia of capable to withstanding normal seat pressure 10 kg/cm2 including providing and fixing rubber/asbestos sheet gasket maximum thickness 3mm thick as per IS: 2712-1979 and including carriage of material in all leads and lifts

Providing & fixing Non clog Vertical Sewage Submersible Pump with solids handling capacity of 50mm with SS CF8 M Impeller, Cl casing, SS 316 shaft, bronze casing wearing ring & bearing bush, TC mechanical seal, SS bearing, suitable for 3 Phase 415V, 50 Hz, AC supply, submersible motor having TEFC enclosure with class F insulation and IP 68 protection of recommended make such as Mather and Platt/ KSB /Beacon Weir/Kirloskar/BE/Jyoti as per ISO-9906, relevant IS and BIS standards with up to date amendments or latest edition as per satisfaction of Engineer in Charge. 4 Set 3 BHP

Laying , jointing & testing of GMS Tubes light grades ( to be levelled to grade ) in trenches including fitting with tees and other accessories , testing and commissioning complete as per the IPH Specifications within all leads and lifts as per the direction of Engineer-in-Charge.

25mm dia

Amit sood contractor

Roop chand

KUSHAL SINGH RAGHAV

Yash Pal