Providing and erecting E.I for under space development of Raksha Shakti Bridge,Gandhinagar

NAME OF WORK :- Providing and erecting E.I for under space development of Raksha Shakti Bridge,Gandhinagar

FUND HEAD :- Civil Deposite Work

QTY PARTICULARS AMOUNT

SIGNATURE OF THE CONTRACTOR DEPUTY EXECUTIVE ENGINEER

CAPITAL PROJECT ELECTRICAL SUB DN NO.22

Name of Work: Providing and erecting E.I for under space development of Raksha Shakti Bridge,Gandhinagar

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Mains with ISI marked, 1.5KV grade electrolyte multi stranded, annealed

copper conductor with heat resistant PVC insulated conforms to IS 694, IEC - 227 erected in

existing pipe of following size (Specifically for control panel, relays, power switchgears, motor

starters & control wiring) with required size of copper lugs, nuts and bolts if required.

50 Mtrs. (f) One wire 10.00 sq. mm 91.91 And Paise Mtr.

30 Mtrs. (h) One wire 25.00 sq. mm 236.34 Thirty Six And Mtr.

Supplying and erecting Flexible PVC insulated multi strand multi core 1.1 kv grade ISI marked Rupees Forty

2 60 Mtrs. copper wires of following size to be erected as directed. 46.46 Six And Paise Mtr.

e) 1.50 Sq.mm 3 core round PVC sheathed Forty Six Only

Providing & Erecting following Shockproof tissino type accessories erected on 3 mm thick PC Twenty Two

3 2 Nos. (Polycarbonate) sheet in PVC/ Metal/Wooden Box. erected on wall/ ceiling. 22.22 And Paise Each

(8) Bakelite lamp holder Twenty Two

Supplying and erecting led lamps with following wattage capacity of 220 to 240 voltage, minimum Rupees One

15000 burning hours life, 500 V in built-surge protection,Polycarbonate diffuser, mounting suitable Hundred

4 2 Nos. for E14 / E27 / B22 lamp holders, pf >= 0.5 112.11 Twelve And Each

(A) LED Lamps integral type, with PC diffuser suitable LAMP holder Paise Eleven

(ii) 5 to 8 watts Cat-III Only

Supplying and erecting LED street light / Flood light fittings with High power White LEDs wattage of

3 Watt and above assembled on single MCPCB, efficiency more than 130 lm/w and corrosion free

High pressure die cast aluminum housing with smooth finish powder coated and heat sink extruded

aluminium with diffuser and Polycarbonate optics/ lenses, with toughened glass with company

mark/name engraved or embossed 160 to 270 V,Power Factor more than 0.95, THD < 10 %, CCT

3000 K to 5700K,Uniformity ratio >0.45, Luminaire efficacy> 100 lumens/watt . LED driver efficiency

> 85 %.( fittings required LM-79 & LM-80 certificates)(NOTE: Below description have shown ranges

of Wattage capacity of LED fittings.The Engineer incharge may select any wattage capacity

between the ranges shown.)

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

(B) Flood Light (IP-65), Surge protection -4KV integral and ,Light must have 440VAC line supply Thousand

20 Nos. 8453.70 Each

with over-voltage protection. (v) above 120 to 160 watts Cat-lll Four Hundred

Supplying and Erecting Of L.E.D. type High bay fixture having Power Consumption of following watts

with, Input Voltage 110 - 290 V.AC with full efficiency, Power Factor > 0.9 with 50/60 HZ, CCVC

6 44 Nos. LED Driver used for maximum power saving, Best Quality Aluminium alloy housing and aluminium 5752.96 Each

Dome for better heat dissipation, CCT Cool white (6000K), CRI 80, Beam angle > 120 degrees,

working temperature -20 deg c to +55 deg c, Body IP 65 (B) 90 to 150 watts

Providing and erecting Approved make Four pole moulded case circuit breaker having breaking Thousand

capacity ICU of 25 KA. at 415 V,having normal current rating up to 25 A to 100A. with Fixed thermal One Hundred

7 1 Nos. & magnetic release suitable to work on A.C. supply 50 c/s. with all internal connections, spreader 6173.12 Seventy Each

tinned copper & complete erected in existing 16 G.M.S. housing. Three And

ICS=100% of ICU only Cat III Paise Twelve

Supplying and erecting triple pole & neutral 440V / 500V panel mounting Copper Busbars with four Rupees One

equal Nos. of electrolyte bus having current density not more than 1.6 Amp. / sq.mm (Rated current Thousand

Rn. / cross section area) duly wrapped with colour insulating tape for phase sequence of following Nine Hundred Rn.

Mtr. current carrying capacity, erected with necessary bus bar supports /insulators, main cable socket to Sixty One And Mtr.

each bar, erected in existing cubical panel with necessary connections. Paise Forty

(A) Suitable for 100 Amp. Capacity Two Only

Providing and erecting Miniature circuit breaker single pole 0.5A to 2A system and having breaking

9 20 Nos. 270.68 Seventy And Each

capacity 10 KA to be erected in existing box. confirming to IS 8828/1996 with ISI Mark

Providing & erecting 415 V MCB Four Pole for Motor & Inductive Load (C Curve) having 10KA Hundred Sixty

10 3 Nos. breaking capacity & confirms to IS :8828 in existing box having following capacity (b)40 Amp. 668.62 Eight And Each

Cat.III Paise Sixty

Providing , erecting , fabricating the M.S. structure as per requirement on site incorporating proper

size of M.S. angles,square,round, flats, bars, channels, sections complete with cutting, welding,

11 50 K.g 77.77 Seven And Kg.

grinding & finishing duly painted with one coat of red oxide with erection on site as per direction of

engineer in charge with necessary grouting, cementing, plastering & finishing complete.

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Pipe type earthing having 150 cms.long and 2.5 cms. dia. galvanised iron Hundred Sixty

12 5 Nos. pipe with coupling and buch buried in specially prepared earth pit complete with necessary 8 SWG 368.65 Eight And Each

earth wire. Paise Sixty

13 5 Nos. For using salt and charcoal / coke as required for pipe type earthing. 171.70 Seventy One Each

Providing and erecting XLPE (IS:7098)(I)-88 ISI armoured cable multistrand / Solid Aluminium Hundred Forty

14 1600 Mtrs. conductor for 1.1 KV. to be laid on wall with necessary clamps or in existing trench / pipe of 140.39 And Paise Mtr.

following size of cables (C) 4 core 10 Sq. Mm Thirty Nine

Making trench in soft soil of suitable width of 90 cm deep for laying cable or locating the fault all Five And

15 300 Mtrs. 55.55 Mtr.

over the run and back filling the same and making the surface as normal ground. Paise Fifty

Making trench in Hard Murrum / Tar Road of suitable width of 90 cm or required depth for laying Hundred

any size of cable or locating the fault all over the run and back filling the same and making the Thirty Two

surface as normal ground. And Paise

(B) If additional machinery like hammer driller or JCB use [Add] Twenty Eight

Drilling the road without breaking the road surface (Asphalt) for laying of cable for feeding power

17 100 Mtrs. supply by making up to following size of holes at both ends complete. 492.88 Mtr.

(A) Up to 100 mm bore dia

Providing & laying approved make Double walled corrugated pipes (DWC) of

polyethylene(conforming to IS 14930 II )with necessary connecting accessories of same material at

18 700 Mtrs. required depth in existing trench for laying of cable. below ground / road surface for enclosing 62.62 Mtr.

(A) 50 mm outer dia

Providing and erecting Solder less crimping type Aluminium lugs conforming to IS suitable for cable Rupees

of following size evenly crimped with high pressure tool & connected to switchgear terminals with Thirteen And

19 80 Nos. 13.13 Each

brass/cadmium plated nut bolts in an approved manner. Paise

(B) 10 Sq.mm Thirteen Only

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Supplying & erecting approved make SMC press moulded composite FRP. loop-in, loop-out Rupees Five

approx. 2mm thick box complete with Bakelite connector strip 5way(3P+N+E),DIN rail for mounting Hundred

20 20 Nos. mob & hinged doors as per requirement having locking arrangements with mounting clamp with 515.10 Fifteen And Each

nuts, bolts & washers suitable for erection on pole with cable clamps& earth bolt of following size of Paise Ten

box. (B) 250mm x 200mm x 100mm [deep] Only

Supplying & erecting IP 55 grade following size section pillar fabricated from joint less M.S. Sheet

with angle iron legs made from jointless M.S. Angle with cable clamps to be buried in ground to Rupees

have appropriate erection to work uniform until erected with cement concrete foundation and 45 cm Sixteen

high bricks work finishing with plaster etc. hinged double door internally supported on both side, with Thousand Six

internal and outside looking arrangement with look and keys in duplicate 35 x 35 x 5 mm M.S. Angle Hundred

21 1 Nos. 16691.26 Each

of Two Nos. one is welded and other with nut and bolt for erecting Bakelite sheet. Painting the Ninety One

Section Pillar inside and out side with three tank powder coated paint. section pillar roof should be And Paise

without joint with water leakage proof & tested as per IP 55 test & followed by IS 2147 of 1962 Twenty Six

(A) 150 X 90 X 75 cm section pillar fabricated from 14 Gauge MS Sheet with angle iron legs 95 cm Only

long made from 40 X 40 X 6 mm thick MS angle.

22 2 sq.mtr Supplying and erecting HYLAM sheet on existing angle iron frame.for following thickness. (E) 10mm 1927.08 Sq.mtr

Supplying & erecting approved make Digital time switch having lithium cell 6 years operative and

operate battery backup 1 channel day clock with 14 memory programme, suitable to operate on

240V + 5%, 16A with, floating contacts Minimum switching setup time 1 minimum & LCD display.

23 3 Nos. 3168.37 Sixty Eight Each

Also comprised permanent ON/OFF switching. Programming switches & housed in fire proof

thermoplastic enclosure & transparent cover erected as required with necessary connection erected

Supplying & erecting power contactor ,AC3 duty for time switch complete erected as per direction

24 3 Nos. 2782.55 Hundred Each

Cat III (D) 4 pole 440V 40 Amp.

Fifty Five Only

Total Amount Rs.

Total Amount Rs.

In Words:- Rupees Nine Lakh(s) Seventy Two Thousand Nine Hundred Thirty Six And Paise Three Only

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

I/We am/are willing to carry out the work at(No above rates allowed) ____________% below __________________

__________________percent (Should be written in figures and words) below the tendered rates mentioned above.

Amount of my/our tender works out as under :

Put to Tender Rs. 0.00 Put to Tender Rs.

Deduct ______ %

(Please strike out whichever is not applicable)

1 I/We hereby declare that I/We have visited the site, fully exquisite myself/ourselves with the local situation regarding materials and other factors pertaining to the

work before submitting this tender.

2 I/we hereby declare that I/We carefully studied the conditions of specifications and other tender documents of this work and agree to execute the same accordingly.

3 A tender with any overwriting in percentage (should both in word and figures) rejected out right.

4 Insertions and/or corrections in the percentage quoted ( both in word and figures) resulting into increase in the value of the work shall be rejected outright unless it

is authenticated by the office opening the tender at the time of opening of tender.

5 Dismentaling the existing material taken by contractor as mention rates.

Dy.Exe.Engineer

Sign of Contractor C.P.Elect.Sub.Div.22

Name of Work: Providing and erecting E.I for under space development of Raksha Shakti

Bridge,Gandhinagar

MATERIALS /ITEM Make/ Brand

1 Mains and Wires KEI, RR Kabel, Finolex , Polycab,

LED LIGHT FIXTURES (Indoor and

2 Phillips, LT, Wipro, jaquar

outdoor) & DRIVERS

ABB, LAURITZ KNUDSEN , LEGRAND, C&S,

3 LT SWITCHGEARS

Indoasian, Schneider

4 LT CABLES KEI, RR Kabel, Finolex , Polycab

Dy.Exe.Engineer Exe.Engineer

C.P.Elect.Sub.Div.22 C.P.Elect.Division

Gandhinagar Gandhinagar