BEAUTIFICATION/ PLACE MAKING WORK NEAR DINDOLI VARIGRUH IN T.P.S. NO. 62 (DINDOLI-BHESTAN-BHEDWAD) IN SOUTH EAST ZONE (LIMBAYAT), SURAT. (2ND ATTEMPT)

NAME OF WORK: Beautification/ Place Making Work near Dindoli Varigruh In T.P.S. No. 62 (Dindoli-

Bhestan-Bhedwad) In South East Zone (Limbayat), Surat.

Item S.O.R 2023-2024 & M.R.

SOR Description

No. Qty. Rate Unit Amount

Boring holes 3.5 mt.deep in ordinary soil ( for cast in situ

piles) & disposal of the surplus excavated soil as

directed within a lead of 50 M. For following diameter

Providing & laying cement concrete 1:1.5:3 (1 cement :

sand : 3 graded stone agg. 20 mm nominal size) & curing

2 SMC (6) comp. Includ.cost of form work but exclu. Cost of 11.73 4127.14 C.M

reinforcement for reinforced concrete work in : (A)

Foundation, footing, Base of columns and Mass concrete.

Providing & laying C.C 1:3:6 (1cement :3 coarse sand :6

3 SMC (5) Crushed stone agg 20m.m Nominal size)&curing comp. 4.84 3005.76 C.M

excl. cost of form work in :(a) foundation & Plinth

Providing and laying controlled cement concrete M.250 and

SMC Design curing complete excluding the cost of formwork and

Mix reinforcement for reinforced concrete work in (D) Columns,

Pillars posts and struts, upto floor two level.

(1)Having c/s area up to 0.08s.m 8.90 7073.18 C.M

(2) Having c/s area more than 0.08 sq. mt. & upto

(3) Having cross sectional area more than 0.12 sq. mt. 0.00 5744.18 C.M

Providing& laying ordinary cement con. 1:1.5:3 (1cement:

1.5 sand: 3 graded graded stone agg. 20mm nominal size)

5 SMC (14) finishing smooth curing etc. comp. Incl..Costof form work 42.06 10,831.75 C.M

but excl.Cost of reinforcement forR.C.C.Work in:

Providing & fixing M.S.Grills of required pattern to

wooden frames of window etc. At all floor levels with M.S.

flats at required spacing & frame around square or round

bars with round headed bolts & round headed bolt sand

nuts or by screw sincl. Priming coat of Red lead paint

Providing & construction brick work using Fly Ash bricks

having crushing strength not less than 35 Kg./sq.cm. in

foundation & plinth in C.M. 1:6 (1 cement:6 sand ) etc.

comp. - Ground Floor

Providing & Applying 20mm. Th. Heavy Roller plaster on

walls or similar surfaces at all floor levels consisting of

mm av. Th. Backing coat of C.M. 1:3 (1 cement:3 sand) &

SMC (28) 8 mm. th. Finishing coat of C.M. 1:1 (1cement: 1 sand)

8 apply thick cement slurry and apply roller horizontal as 551.83 324.00 S.M

well as vartical ( two times ) up to good quality and size of

grain in elevation as per directed by engineer incharge.

Box Cutting the road surface to proper slope and camber for

making base includinng removing the excavated stuff and

9 Ground 137.93 104.20 C.M

depositing on the road side slope as directed up to 50 mt.

Item S.O.R 2023-2024 & M.R.

SOR Description

No. Qty. Rate Unit Amount

Providing & laying Granular sub base (GSB)confirming

to Grading-V of Table 400.0 of compacted thick of

150mm with specified graded stone metal and sand mixed

SMC (9) in place and laid with mechanical means spreading

10 Ground with motor grader and compacting with vibratory roller 137.93 1418.04 C.M

development having minimum 80-100 KN static weight to acheve

desired density of 98% of MDD including all material,

labour, machinery with all leads and lift etc. complete.

Providing & filling in plinth with yellow soil or selected

11 SMC (11) soil in layers of 20 cm. Th'. Incl. watering, ramming & 1070.45 289.06 C.M

consolidation etc. complete.

Providing & laying cement concrete 1:4:8 (1 cement :

sand : 8 graded stone agg. 40 mm nominal size) & curing

comp. incl.cost of form work in (A) Foundation and Plinth

Providing & laying cement concrete 1:2:4 (1 cement:2

sand:4 graded stone agg. 20 mm nominal size)& curing

comp. Includ.cost of form work but exclu. Cost of

reinforcement for reinforced concrete work in : (A)

Foundation, footing, Base of columns and Mass concrete.

Providing & fixing IS Mark TMT Bar FE 500 / FE 500D

reinforcement for R.C.C. work incl. bending, binding &

placing in position etc. comp. Upto G.L./P.L..

Providing 100mm thick readymade C.C. kerb of strength M-

20 (size 300mm x 380mm) purchased from SMC's

approved paverblock manufacturer & setting in line, level

and in truly vertical position, including filling joints in

15 SMC (6) C.M. 1:1 (1 part of cement : 1 part of stone dust) smooth 327.00 228.00 C.M.

pointing in C.M. 1:1 (1 part of cement : 1 part of coarse

sand) including watering etc. complete and as directed by

engineer in charge.

Providing & applying two coats of weather shield max

paint (3 coats may be required in case of darker

colours.)of ICI Dulux or Apex Ultima of Asian Paint

including applying exterior acrylic primer coat as per

manufacturers specification and directions in shade and

colour approved by architects, on exterior surfaces of the

building including scaffolding, preparing the surface,

watering, curing etc. complete and as directed by the

architects and manufacturers.

Surface Preparation :

surface is thoroughly clean, dry and free from all loose

dirt, chalk, grease, fungi, algae and flaking paint. This can

16 SMC (17) be achieved by brushing with a wire/ stiff coir brush, 347.09 81.00 SM

followed by water jetting if required. Fill up all minor

cracks and defects with white cement and sand mixture

in the ratio 1:3. For application on previously painted wall,

previous coatings of paint must be thoroughly scraped

off and Clean the surface thoroughly using wire

Apply a liberal coat of exterior acrylic primer and allow it

to dry for 4-5 hours. Application of putty is not

Minimum 4-6 hours duration is required between each coat

of weather shield max paint

Providing & fixing interlocking type Cement Concrete

paver block of approved shape & design having 60 mm

thickness (M-40) purchased from SMC's approved

SMC (GD- paverblock manufacturer only on fine sand bedding. Item

17 includes leveling by using vibratory plates compacted

machine. Item also includes all materials, Labour,

euipments, tools, plants, watering, cleaning etc. complete.

Item S.O.R 2023-2024 & M.R.

SOR Description

No. Qty. Rate Unit Amount

For Road Junction 80 mm thick ( M-50) 459.76 714.00 SM

Painting two coat (inlcuding one coat of Primer) on new

steel and other metal surface with Epoxy paint, burshing to

18 RA-1 give an even shade including cleaning the surface of all 163.73 196.00 SM

dirt, dust and other foreign matters as per Insatruction by

Architect and Engineer-in-charge.

19 providing & Fixing natural stone sculpture as per below

manationed pic ( Minimum 3 to 5 Mock as per suggested by

engineer incharge ) , size ,shape,quality, only Item include

loding unloading Etc All as per directed by engineer

incharge. Min size 2.0m x2.5 x2.5 m

Providing& laying graniteslab18mmthick inflooring,

treadsof steps and landing laid on bed of 20 mm thick

cement mortar 1:6 (1 Cement : 6 coarse sand) or lime

mortar 1:1.5 laid and finished with flush pointing in white

or colour cement including rubbing and polishing complete.

(Basic Rate:Rs.1347.46/S.M.)

Providing & laying granite slab 18mm thick inskirting,

risersof steps, dedoandpillars laid on 10mm thick cement

mortar 1:4 (1 Cement : 4 Coarse sand) and finished with

flush pointing in white or colour cement including rubbing

& polishing comp.. (Basic Rate:- Rs.1347.46/S.M.

Consultancy Of Detailed Architecture drawings, Structure

22 drawing land scrap drawing / Electrical detailed etc as per 1.00 35000.00 job

engineer in charge