Street Light on NH72 to NH73 By Pass Mandi Road (Road ID 871) (Length 1.73 K.M) (Pdg. Street Light) Shahzadpur Distt. Ambala.

Amount

1 :- Wire 1.5 Sq.mm ISI marked, FRLS PVC insulated, Single coe copper conductor Cable. EL003

:- 10 Sq.mm ISI marked, FRLS PVC insulated, Single coe copper conductor Cable. EL007

2 :- BRASS COMPRESSION GLANDS. Single compression Gland: Brass 10 Sqmm to 16 Sqmm Cable 2 to 4 core. EL154

:- Single compression Gland: Brass 25 Sqmm to 50 Sqmm Cable 2 to 4 core. EL155

3 :- ALUMINIUM LUGS Aluminium Lugs/terminals 16Sqmm EL163

:- Aluminium Lugs/terminals 25Sqmm EL164

4 :- HDPE Pipe 10KG/cm2 63mm dia EL229

5 :- MCCB ,DISTRIBUTION BOARDS, MCB's, RCCB's, CHANGE OVER etc. Supply and erection of Modular case circuit breaker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work. 4 pole MCCB 6 amp to 100 amp 23.22.1.9

6 :- MCCB Enclosure made of Sheet Steel suitable for mounting MCCB of following ratings MCCB up to 125 A FP 23.22.2.1

7 :- Supply and erection of miniature circuit Breaker/isolator 240/415 V in the existing distribution board including making necessary connections:- 6 amp. to 32 amp Single Pole 23.22.5.1

8 :- Supply and election of Goodridge Almirante type M.S. pedestal made of 50 mm *50 mm * 6 mm angle Iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and looking arrangement with the Godrich type handle including round bars. The to covering should have a downward overhang of 75 mm on all sides of pedestal, having two sets of water proof ventilation holes of suitable size on the sides, at top and bottom, each set containing four No’s. holes to discharge the heat produced by suitable size to make it water proof . The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embedded upto the entire depth in 1:2:4 cement concrete block, projected 75 mm all around the pedestal and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in charge of the work. M.S. pedestal of size 750 mm wide, 1200 mm high, 300 mm deep and bottom totally open , duly embedded in cement concrete block of size 900 mm*450 mm*200 mm above ground level , having a base of size 1050 mm* 600 mm* 250 mm below ground level. 23.27.3

9 :- EARTHING AND LIGHTENING ARRESTOR Earthing with GL earth pipe 4.5 m long and 40 mm dia with masonry enclosures on the top etc. (but without charcoal or coke and salt) as required. 24.1.1

:- Extra for using salt and char coal/coke for pipe earth electrode as required. 24.1.2

:- Providing and laying earth connections from earth electrode with 4.00 mm dia G.I. wire in 15 mm dia G.I. pipe from earth electrode as required. 24.1.11

:- Providing and fixing 4.00 mm dia G1. Wire on surface or in recess for loop carthing as required. 24.1.13

10 :- LT CABLE Note:additional cable in same trench : 50% of Main cable cost Laying of underground cable in pipe /existing open/closed tench tc as required:- 16 Sq mm to 35 sqmm 2 to 4 Core 24.2.4.2

11 :- Supply and erection of copper lugs including crimping etc. entire satisfaction of Engineer-in- Charge of the work. 1.5 sqmm 24.2.6.1

:- Supply and erection of suitable compression type brass cable glands for underground Cable :- 10 sqmm to 16 sqmm Cable 2 to 4 Core 24.2.7.2

:- 25 sqmm to 50 sqmm Cable 2 to 4 Core 24.2.7.3

12 :- STREET LIGHT Supply and erection of 32mm dia metre 1.5 m long bracket (B-class) making an angle of 10° to 15° with horizontal plane for mounting street light fitting fixing of GI. bracket on wall with 2 nos. 32 mm x 3 mm thick M.S. clamps including cost of cutting, welding of G.I. pipe complete with cement sand mixture, bolts and nuts etc. including necessary connections. 24.4.3

13 :- Erection of street light fitting on the pole including the cost of petty material required (irrespective of height/length of bracket) At Pole above 4.5 metres but upto the height of 7 metres. 24.4.4.2

14 :- Supply of Hot Dip Galvanized octagonal pole of 3mm thickness, with base plate including cost of nut and bolts , earthing studs, Integral Cable termination arrangement 5 mm thick Bakellite base plate on suitable welded MS/GI bracket 32 A four way connector 2 no 10 A SP MCB , end cover and all accessories as supplied by the manufacture, including Providing RCC foundation of M25 grade (1 Cement:1 Stone aggregate: 2 Coarse sand) i/c excavation, steel reinforcement (Fe 500) @ 70 kg/cum of concrete contents, concrete cover 50mm, anchor bolts etc. over a bed of PCC 1:5:10 of required dimensions for octagonal poles of various heights as per following specifications complete in all respects and as per directions of Engineer-in-charge. 7 Mtr Long pole with top dia 75 0mm and bottom dia 150 mm with base plate of size 300 x 300 x 20 mm 24.4.8.5

15 :- Supply of 72 watts LED Street light with all labour and material required to complete the job in all respect upto entire satisfaction of Engineer-in-charge of work (Make:Philips/Bajaj/Crompton/ Panasonic/Surya). NS-1

16 :- Supply of 16 Sq. mm 4 Core Cable Armoured under ground cable ,loose in existing pipe or trenches, make as per approved list complete with necessary connections complete in all respect including all material required to complete the job in all respect & up to the entire satisfaction of the Engineer in charge of the work. NS-2

17 :- Supply of 25 Sq. mm 4 Core Cable Armoured under ground cable ,loose in existing pipe or trenches, make as per approved list complete with necessary connections complete in all respect including all material required to complete the job in all respect & up to the entire satisfaction of the Engineer in charge of the work. NS-3

Som Nath Contractor

GLOBAL POWER TECH

J.B.S.Electrical Co.