Work Related Electrical Network Modification on Road Under EDD (North), Dehradun.

Amount

De-Centralized Material

PP & Clamp(Made of MS Flat 65x6mm) with Nut&Bolt

Braceing Clamps for ST Pole SP-55

Holding Clamps Sp-55

Dead End Clamps with I hook

Stay Clamps for ST Pole SP-55

LT CLAMP WITH N&B ST Pole SP-55

LT CLAMP WITH N&B ST Pole SP-21

SHACKLE INSULATOR 100x115 mm with N&B

DIST. Box with N&B AB Cable 3 PH. -8Way

Inslated PRC(IPC 120-120 sq mm)

Inslated PRC(IPC 120-16 sq mm)

Supply of MS Nut& Boult off size

11 KV 3X185 SQMM CABLE END TERMINATION JOINTING KIT FOR OUT DOOR

11 KV 3X 185 SQMM STRAIGHT THROUGH CABLE JOINT KIT

LT 3.5X240 SQ MM CABLE END TERMINATION JOINTING KIT FOR OUT DOOR

GI STRIP SIZE 40X6 MM

AL LUGS SUITABLE FOR RACOON

MS BOLTS & NUT WITH WASHER

SUPPLY OF 140 MM DIA PE80 HDPE PIPE HIGH-DENSITY POLYETHYLENE PIPE

SUPPLY OF 125 MM DIA PE80 HDPE PIPE HIGH-DENSITY POLYETHYLENE PIPE

Labour

Cartage of ST pole and PCC Poles from store centre to construction site with loading, unloading at both points. (loading, unloading pluse carriage per pole) and proper

ST Pole SP-72

other Stock Material

Head load cartage of following Poles from road to site (Rates are per pole / KM

ST Pole SP-55

ST Pole SP-21

other Stock Material

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus

Erection of following Single support pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

ST Pole SP-55

ST Pole SP-72

ST Pole SP-21

Erection of following Double support pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

Erection of following Four Pole support pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

ST Pole SP-55

Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement: 4 graded stone 20mm nominal size: 8 coarse sand) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO construction

Muffing of poles size 0.45 cm x 0.60 cm radious with cc 1:3:6 it (1 cement: 3 coarse sand: 6 graded stone 10mm nominal size) block size 45cm height from ground level including cost of cement, stone and sand etc.

Earthing of support with M.S. Earth rod of 2.5 meter long by hamming of M.S. Rod to proper depth and connecting the earth electrode with the help of G.I. wire as per construction manual

Excavation of earth for stay pit of size 0.6x0.6x1.2 mtr in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

stay Set 16 x 1800 mm for11 KV line

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement: 4 graded stone 20mm nominal size : 8 coarse sand) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper lalignment, leveling as per RESSPO Manual.

Fabrication of M.S. channel & Angle iron after cutting in required sizes with drilling of holes upto good finish for tpo channel, braking and special type bracket etc. as per RESPO shedule and local approved drawing.

Fixing of Triagular type bracket 11 KV Line

Dismentaling of existing LT/HT line. Including disc fitting, Insulator, Clamps,Nut&Bolt and consumer cinnection and street light connection etc. including rolling of conductor and cartage back from site to JE Store.

SP-55 Single Pole

SP-33 Single Pole

SP-21/23 Single Pole

SP-55 Double Pole

SP-55 Four Pole

Rail pole

Dismantling of T/F from double pole/plinth including opening of all connection circuts & earthing strip etc.

Dismentaling of L.TPMO/Fuse set on double pole structure

Dismenting of 11kv Line with earth wire

ACSR Raccoon Conductor

ACSR Rabbit Conductor

AAAC 70 sq mm

Dismenting of LT Xlpe Arial Bunch Cable 3x120+1x95+1x16 sq mm

Dismentling of LT Line 3 P 5W (Rabbit)

Dismenting of Tree phase Distrubution box with clamp& Nut & bolt

Loading, unloading and Carriage of LT PRMC from Store to pit site & Installation on the double pole with the help of nut bolt & Clamp and making to pass LT cable from T/F to PRMC.

Making special type separate earting for neutral/body of power distibution T/F by digging 3x4x12 f deep pit at corner of swithchyard with duly provide 1 no coal lron earth plates of size 18"x18:x1/2" jointing them with 6" long bolt duly coverod with layer of softcoal 60kg. and 20kg. (Total 80kg) connecting them with the main erath mat, the earth plate shall be connected with 35x6mm GI strip and GI strip shall be laid upto the neutral and T/F body separately (Including supply of steel).

Chemical Earthing:Earthing of distribution transformer including digging of pit of size 2.5 Mtr depth and make hole of size 150 mm. Placing of earthing electrode (to be supplied by contractor as per drawing No. A) as drawing B, connecting the same with G.I. Strip (to be supplied by contractor ) of size 35x6 mm as per drawing C for a minimum lenght 6 m. treatment of soil with highly condctive substance as per IS 30343 complete in all respect, result of earthing resistance to be recroded in M.B. before and after installation of earthing. The earth resistance after earthing should be less than 1 Ohm.

Erection, providing and fixing of wire mesh of size 50x35 mm around plinth and toe wall duly welded with frame of M.S angle iron 35x35x6 mm and strip of size 35x6 mm in mid of each side along with wire mesh (width of wire mesh 1.5 meter ) with the height of 0.5 meter above the plinth and 2 meter above the toe wall with 1 No. gate and locking arrangment in the toe wall size including grouting of 6 Nos. legs in the ratio in block of size 0.25x0.25x0.45 meter including gravlling of shingle of size 20 to 40 mm and complete painting of wire mesh with aluminium paint with two coat (Including the cost of cement and all material)

Construction of DTR Plinth

Installation / mounting of new Tranformer on plinth pole structure and fixing of channel / angle etc. and making all connections of Ht and LT side and its complete commissioning.

Mounting & Fixing of Fuse sets on double pole structures including making of connections complete work

Mounting & Fixing of TPMO on double pole structures including making of connections complete work

Mounting and Fixing of Lightning arrestor set (3 Nos.) on double pole structure including making all connections by G.I. strip size 35x6 mm to earth point complete work (excluding cost of G.I.Strip)

Dismentling of LT PRMC from Store to pit site & Installation on the double pole with the help of nut bolt & Clamp and making to pass LT cable from T/F to PRMC.

Dismentling of LT Cable from old LT cable from T/F to PRMC.

Errection of T/F base on Double Pole for 100/63 KVA complted

Laying, Spreading, Stringing and sagging of 11 KV / 33 KV line in 3 phase (3 Phase 3 wire) of the following wire as phase wire with G.I. earth wire complete including fixing of all accessories in 3 Nos. conductor in parallel with binding and jumpering as per profile and profile and sagging chart.

ACSR Raccoon Conductor

ACSR Rabbit Conductor

AAAC 70 sq mm

Laying of LT Line in three phase(3 phase 5wire) ACSR Raccoon conductor

Laying, Spreading, Stringing and sagging of LT AB Cable 3x120+1x95+1x16 sq mm

Fixing of three phase distribution Box with clamp

Laying and errection of LT PVC Cable including crimping of lugs of size 1x120 sq mm

Dismentling of 11 KV SECTIONALIZER on pole structure including of CT and PT Connection complted Work

Mounting & Fixing of 11 KV SECTIONALIZER on pole structure including of CT and PT Connection complted Work

MAKING OPEN TRENCH IN ROCKY AREA FOR LAYING OF 11 KV CABLE IN TRENCH AT 1.2 MTR DEPTH BELOW GROUND LEVEL AND LAYING OF HDPE PIPE

SUPPLY AND FIXING OF GI PIPE (WITH SOCKET) AT POINTS OF ROAD CROSSING, CABLE RISING AT POLE ETC FOR 11 KV CABLE

LAYING OF 11 KV CABLE IN HDPE PIPE, GI PIPE RISING ETC

MAKING OPEN TRENCH IN ROCKY AREA FOR LAYING OF LT CABLE IN TRENCH AT 1.2 MTR DEPTH BELOW GROUND LEVEL AND LAYING OF HDPE PIPE

SUPPLY AND FIXING OF GI PIPE (WITH SOCKET) AT POINTS OF ROAD CROSSING, CABLE RISING AT POLE ETC FOR LT CABLE

LAYING OF LT CABLE IN HDPE PIPE, GI PIPE RISING ETC

SUPPLY AND FIXING OF EARTHING FOR CABLE AT DIFFERENT POLE STRUCTURE BY 450X450X10MM G.J. PLATE VERTICALLY 3M BELOW THE GROUND LEVEL WITH ALTERNATE LAYERS OF CHARCOAL & SALT ATLEAST 200MM THICK AROUND CONNECTED WITH GI STRIP RUNNING TILL TOP OF POLE COMPLETE.

FIXING OF MS CHANNEL, ANGLE AND ALL ACCESSORIES ON EXISTING/ NEW DOUBLE POLE

FILLING & FIXING OF 11KV END TERMINATION CABLE JOINTING KIT (0/D) NOS

FILLING & FIXING OF 11KV STRAIGHT THROUGH CABLE JOINTING KIT

FILLING & FIXING OF LT END TERMINATION CABLE JOINTING KIT (I/D)

FIXING OF DANGER/NUMBER/NAME PLATE MAKING 11 KV SECTION POLE

LAYING/SAGGING/JUMPERING/STRINGING OF ACSR DOG CONDUCTOR

PAINTING OF NEW/EXISTING POLES WITH CHANNEL INCLUDING ONE COAT PRIMER AND TWO COAT SILVER PAINT AND RED ASIAN PAINT OF SUPERIOR QUALITY ON UPPER SIDE OF POLE

ST POLE SP-55

LAYING OF LT SERVICE CABLE (OVERHEAD)

Dismentling of stay Rod

Erection HT Section Pole

Back carriage of Dismentling Pole

ST POLE SP-55

ST POLE SP-33

ST Pole SP-21

Rail pole

SURYACONENGINEERS LLP (BID ID -406537)

PACIFIC INDIA (BID ID -405010)