Loading…
Loading…
Tender Value
₹20.6 L
EMD Value
₹20,500
Closing Date
16 May 2026, 6:00 pmClosed
Similar tender results from the same govt authority in the past 3 years.
Executive Engineer’s office, Valsad (R&B) Division,
Reparing and Renovation of GERI Office Building & Campus area Valsad. Ta.Valsad Dist. Valsad. (Machinary Foundation work Door widow flooring material store area and other miscellanious work)
303381
02 Of 2026-27
Open
Civil - All
Valsad
8 documents required · 8 mandatory
₹900
Executive Engineer, Valsad (R&B)Division, Valsad
₹20,500
8 May 2026
8 May 2026
8 May 2026
16 May 2026
8 May 2026
Name of work :-
Reparing and Renovation of GERI Office Building & Campus area ,Valsad.Ta.Valsad Dist. Valsad.(Machinary
Foundation work,Door ,widow,flooring,material store area and other miscellanious work)
Bill of Quantities
(A) Percentage Rate Tender (Up to INR 50 Cr. )
Memorandum showing items of work to be carried out
Ite Quantity Unit Estimated Total Amount
Ite Quantity Unit Estimated Total Amount
No. Item of work In figure estimated
Rs. Ps. quantities
1 Providing and fixing pre-cast Rubber Dye / steel Dye inter locking 254 Smt 686.9
concrete block 60mm thick with grade of concrete M300 pnumatic
compressed / vibrated mechanically and as per approved design
Confirming to IS 15658 : 2006 including 35 mm Sand layer for levelling
and filling the joint with sand in proper line and level as per guidlines of
IRC : SP 63-2018 etc. Complete.
2 Providing and laying cement concrete 1:2:4 (1- Cement : 2- Coarse sand : 39 Cum 3683.34
4- graded stone aggregates 20 mm nominal size) and curing complete
excluding cost of formwork in (A) Foundation and Plinth.
3 Removing, Repairing and Refixing existing Alluminium window frame with 127 No 580.75
glass of all size shutter/frame, replacing all old Mosquite Net fixtures with
new locks, screws etc. including repairing the shutter/frame with Rates
includes all labour charges for removing, repairing & refixing the window,
4 all materials,
Removing, transport
Repairing cost,
and taxes existing
Refixing etc.and Alluminium
fix engineer in
ventilation 6 No 348.45
frame with glass of all size shutter/frame, replacing all old fixtures with
new locks, screws etc. including repairing the shutter/frame with Rates
includes all labour charges for removing, repairing & refixing the
Ventilation, all materials, transport cost, taxes etc.and as directed by
engineer in charge etc complete.
5 Providing & laying Synroof Hi Build 1mm thick ecetrometric, premium 411 Sqmt 828.2
quality acrylic coating as a water proofing membrane finished which
6 Providing & laying Synroof Hi Build 1mm thick ecetrometric, premium 74 Rmt 665.48
quality acrylic coating as a water proofing membrane finished which
consists a coat of bitumat primer & 80 CSM membrane on terrace with
ultra violet resistance working upto any height with 5 years guarantee
against any leakage etc. complete per detail specification & as directed by
Engineer-in-charge.
7 Steel work, welded in built up sections framed work including cutting, 62.02 Qt. 9047.86
hoisting, fixing in position and applying a priming coat of red lead paint.
(A)In beams and joists, channels angles Tees, flats, with connecting plates
or angle cleats as in main and cross beams. Hip and jack rafters, purlins
conneted to common rafters and the like
8 Providing U.P.V.C sheet roofing fixed with glavanished iron J or L Hooks, 156 Smt 959.75
Bolts and G.I. limpet washer or G.I. limpet washer. filled with white lead
complete. (1) 2.50 mm thick sheet.
9 Providing and fixing FRP frame size 100 x 50 mm and 35 mm thick FRP 34 Sqmt 2547.22
depress panel Single shutter having extra reinforcement on sides & edges
in Gel coat finish.The core of the shutter & frame is to be filed up with
injected fire retradat grade polyurethene foam done in situ along with
embeded wooden pieces for stiffening & also taking hinges &
fintures.The whole FRP frame & shutter is to be waterproof,
weatherproof ,termite proof & resistance to mild acid/alkali.Rates are to
be inclusive of S.S hinges with necessary screws & alluminum fixtures &
fastenings & fartener sleeve.Colour and Shade approved by Engineer-In-
10 Providing & fixing in position alluminum partition with standard extruded 75 Sqmt 2478.54
colored anodized alluminum of approved color alluminum pipe size
63mm x 38mm x 2mm thick make a frame vertical and horizontal grid
distance as shown in drawing with panel of 4 mm thick alluminum
composite Panel (ACP) sheet and 5mm thick transparent float glass as
directed with glass film fixed with transparent silicon rubber gasket in
panel with glazing clips 19 mm x 19 mm in size . partition opening door
shutter /sliding shutter having a styles 50 mm x 50mm x 2 mm thick in
style and top ,bottom and middle rails 85 mm x 50 mm x 2 mm thick size
with anodized alluminum heavy handle, stoppers, Aldrop, hinges , lock
door stopper fixtures and fastening with required all labour and
equipment and including rebar up to slab level in half partition and as per
detailed drawing as directed with all lead and lift.
11 Providing & Fixing in position standard extruded approved colour 141 Sqmt 2051.31
anodised Aluminum Ventilator with outer frame 65 x 25 mm Stander Box
Frame with 5mm thick Ground Glass Louvers and Fixed Mosquito Net For
ventilation including all required materials, fixtures, fastenning, labours
and equipments as per detailed drawing as directed. For Ventilators V,V1
Rupees Twenty Lakh Fifty Six Thousand Two Hundred Ten Only.
I/We am /are willing to carry out the work at…………% above/below percent (should be written in figures and words) at the
estimated rates mentioned above amount of my/your tender works out as under.
*Estimated Amount *Estimated Amount
put to Tender Rs. 2056210.00 put to Tender Rs.
Deduction …………….. % below………………… Add ………… % above Rs. …………….
1 The Contractor shall be exhibit board as per government circular No.BDG/3277/1657 N dated 26/01/1997 S (M.GUJ) with
detailed specification and details of work and amount Involved at site without any payment as directed by Engineer-In-
2 All work shall be carried out as per public work department hand book and other specifications of Division or as directed.
3 All columns in the Schedule should be filled in ink & the total of the entries in the last column should be struck by Contractor
under his sign.
4 Rates quoted include clearance of site (Prior commencement of work and its close) in all respects and hold good for work
under all condition, site, moisture/ weather etc.
5 The Boards stating the detailed specification & detailes of Work shal be provided by the contractor as per Government
Resolution T.No.1890-240- Dtd.18/11/1990 and directed by contractor at his own cost immediately on recommanding the
6 Testing of Material Shall be done as per the statement attached with specification,The material IS Tested in GERI by
Executive Engineer Surat and Bill for the testing charges shall be paid by Executive Engineer,1% of the Amount put to
7 1% of the Construction Cost Shall be deducted from the bill Amount of the contract as per the Buildig and other
Construction works walfare cess at 1996(Labour and Employment Department Letter No CWA-2004-1831-M(3)Dated
9/12/2005 notification Of Labour & Employment department dt.03/01/2005 & Labou & Employment Department Letter no
8 In Case of RCC items Where there is a change in Grade of Mix or Change as per Actual Mix design the cost of difference of
Cement Difference shall be deducted from the rate of original item at the rate of star rate mentioned in the tender.
9 Contractor are advised to visit site before loading tender rate.
10 Necessary wiring point and drainage point are installed at Site however any modification in electrical installation and
drainage & water supply connection and minor correction to perform experienced in Lab shall be done by contractor at his
Rates are inclusive of all the taxes (Excluding GST),Transport Charges,Octroi duty and storage Charges up to date.
12 The materials Covered for wiring should be got approved from the Engineer Incharge of the work.
13 GST and Income tax TDS will be deducted at a source while making payments of bills.
14 GST will be paid extra as per Govt. amendment.
15 The Materials on the work shall have to be used and carried out as specified in technical note.
I/We hereby Declare that I/we have Visited the site and fully Exquisite myself/ourselves with the local situation regarding
materials,Labour and other factors pertaininfg to work before submitting tender.
I/We hereby Declare that I/we have carefully Studied the condition of Contracts,Detailed Specification and other tender
Document of this work and agree to execute the same accordingly.
Deputy Executive Engineer
Valsad (R&B) Sub-Division
Signature of Bidder
Executive Engineer
Valsad (R&B) Division
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
RAW_HTML
6 GR.pdf
7 GR.pdf
BOQ.pdf
Building Booklet.pdf
NIIT.pdf
SBD.pdf
Specification.pdf
Download all tender documents and submit your bid