Providing and erecting Street light poles at GTU Entrance road at Lekawada, Dist. Gandhinagar

NAME OF WORK :- Providing and erecting Street light poles at GTU Entrance road at Lekawada,Dist.Gandhinagar

FUND HEAD :- Deposited Work

ITEM ISSUE AMOUN

QTY PARTICULARS

SIGNATURE OF THE CONTRACTOR DEPUTY EXECUTIVE ENGINEER

CAPITAL PROJECT ELECTRICAL SUB DN NO.22

Name of Work: Providing and erecting Street light poles at GTU Entrance road at Lekawada,Dist.Gandhinagar

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Mains with ISI marked, 1.5KV grade electrolyte multi stranded, annealed

copper conductor with heat resistant PVC insulated conforms to IS 694, IEC - 227 erected in existing

pipe of following size (Specifically for control panel, relays, power switchgears, motor starters &

control wiring) with required size of copper lugs, nuts and bolts if required.

25 Mtrs. (f) One wire 10.00 sq. mm 115.14 Fifteen And Mtr.

20 Mtrs. (h) One wire 25.00 sq. mm 295.93 Mtr.

Supplying and erecting Flexible PVC insulated multi strand multi core 1.1 kv grade ISI marked copper

2 720 Mtrs. wires of following size to be erected as directed. 58.58 Mtr.

e) 1.50 Sq.mm 3 core round PVC sheathed

Providing & Erecting following Shockproof tissino type accessories erected on 3 mm thick PC Twenty Two

3 2 Nos. (Polycarbonate) sheet in PVC/ Metal/Wooden Box. erected on wall/ ceiling. 22.22 And Paise Each

(8) Bakelite lamp holder Twenty Two

Supplying and erecting led lamps with following wattage capacity of 220 to 240 voltage, minimum Rupees One

15000 burning hours life, 500 V in built-surge protection,Polycarbonate diffuser, mounting suitable for Hundred

4 2 Nos. E14 / E27 / B22 lamp holders, pf >= 0.5 112.11 Twelve And Each

(A) LED Lamps integral type, with PC diffuser suitable LAMP holder Paise Eleven

(ii) 5 to 8 watts Cat-III Only

Supplying and erecting LED street light / Flood light fittings with High power White LEDs wattage of

Watt and above assembled on single MCPCB, efficiency more than 130 lm/w and corrosion free High

pressure die cast aluminum housing with smooth finish powder coated and heat sink extruded

aluminium with diffuser and Polycarbonate optics/ lenses, with toughened glass with company

mark/name engraved or embossed 160 to 270 V,Power Factor more than 0.95, THD < 10 %, CCT

3000 K to 5700K,Uniformity ratio >0.45, Luminaire efficacy> 100 lumens/watt . LED driver efficiency >

5 72 Nos. 6695.29 Ninety Five Each

85 %.( fittings required LM-79 & LM-80 certificates)(NOTE: Below description have shown ranges of

Wattage capacity of LED fittings.The Engineer incharge may select any wattage capacity between the

(A) Street Light (IP-65), Surge protection -4KV integral and ,Light must have 440VAC line supply with

over-voltage protection.

(v) 120 - 159 watts Cat-lll

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Approved make Four pole moulded case circuit breaker having breaking Thousand

capacity ICU of 25 KA. at 415 V,having normal current rating up to 25 A to 100A. with Fixed thermal & Seven

6 1 Nos. magnetic release suitable to work on A.C. supply 50 c/s. with all internal connections, spreader tinned 6790.23 Hundred Each

copper & complete erected in existing 16 G.M.S. housing. Ninety And

ICS=100% of ICU only Cat III Paise Twenty

Supplying and erecting triple pole & neutral 440V / 500V panel mounting Copper Busbars with four

equal Nos. of electrolyte bus having current density not more than 1.6 Amp. / sq.mm (Rated current /

Rn. cross section area) duly wrapped with colour insulating tape for phase sequence of following current Rn.

7 0.5 1961.42 Hundred Sixty

Mtr. carrying capacity, erected with necessary bus bar supports /insulators, main cable socket to each bar, Mtr.

erected in existing cubical panel with necessary connections.

(A) Suitable for 100 Amp. Capacity

Supplying and erecting KITKAT pattern porcelain cut-out fuse with base of following current capacity

erected on existing block board.

9 Nos. (iv) 63 A 500 V 146.45 Each

Forty Five Only

Providing and erecting Miniature circuit breaker single pole 0.5A to 2A system and having breaking

9 72 Nos. 297.95 Ninety Seven Each

capacity 10 KA to be erected in existing box. confirming to IS 8828/1996 with ISI Mark Cat.III

providing and erecting Miniature circuit breaker single pole 6A to 25A suitable to operate on 240 V

10 9 Nos. A.C. system and having breaking capacity 10 KA to be erected in existing box. confirming to IS 123.22 Each

8828/1996 with ISI Mark Cat.III

Providing and erecting Approved make RCCBs conforming to IS: 12640 and having sensitivity of 30- Rupees Two

100 mA and Short Circuit withstand capacity of 10 KA and suitable for operation on 3 phase and Thousand Nine

11 3 Nos. neutral 415V,50Hz. having characteristic of quick action & tripping with all advance feature & do not 2900.72 Hundred And Each

incorporate any electronic component for following Max. rating erected as directed. Paise Seventy

(ii) 40Amps. FP Cat. III Two Only

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing , erecting , fabricating the M.S. structure as per requirement on site incorporating proper size

of M.S. angles,square,round, flats, bars, channels, sections complete with cutting, welding, grinding &

12 100 K.g 77.77 And Paise Kg.

finishing duly painted with one coat of red oxide with erection on site as per direction of engineer in

charge with necessary grouting, cementing, plastering & finishing complete.

Providing and erecting Pipe type earthing having 150 cms.long and 2.5 cms. dia. galvanised iron pipe Hundred Sixty

13 36 Nos. with coupling and buch buried in specially prepared earth pit complete with necessary 8 SWG earth 368.65 Eight And Each

wire. Paise Sixty

14 36 Nos. For using salt and charcoal / coke as required for pipe type earthing. 171.70 Seventy One Each

Providing and erecting XLPE (IS:7098)(I)-88 ISI armoured cable multistrand Aluminium conductor for

15 1300 Mtrs. 1.1 KV. to be laid on wall with necessary clamps or in existing trench / pipe of following size of cables 183.82 Mtr.

(A) 4 core 16 Sq. mm

Making trench in soft soil of suitable width of 90 cm deep for laying cable or locating the fault all over

16 1100 Mtrs. 55.55 Five And Paise Mtr.

the run and back filling the same and making the surface as normal ground.

Fifty Five Only

Making trench in Hard Murrum / Tar Road of suitable width of 90 cm or required depth for laying any

size of cable or locating the fault all over the run and back filling the same and making the surface as

17 100 Mtrs. 432.28 Two And Paise Mtr.

(B) If additional machinery like hammer driller or JCB use [Add]

Drilling the road without breaking the road surface (Asphalt) for laying of cable for feeding power

18 100 Mtrs. supply by making up to following size of holes at both ends complete. 492.88 Mtr.

(A) Up to 100 mm bore dia

Providing & laying approved make Double walled corrugated pipes (DWC) of polyethylene(conforming

to IS 14930 II )with necessary connecting accessories of same material at required depth in existing

19 1300 Mtrs. 73.73 And Paise Mtr.

trench for laying of cable. below ground / road surface for enclosing cable

(B)63mm outer dia

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Solder less crimping type Aluminium lugs conforming to IS suitable for cable of

following size evenly crimped with high pressure tool & connected to switchgear terminals with

20 288 Nos. 15.15 And Paise Each

brass/cadmium plated nut bolts in an approved manner.

Supplying and erecting approved make Octagonal pole made from HR sheet steel. The pole should be

made as per IS. and shall be coated with hot dip galvanizing as per IS 2629/2633/4759, suitable

suspend local wind speed with integral Junction box consist of terminal plate of min 6mm Hylam

sheet, standard profile 35mmX7.5mm Din-Rail for MCB Mounting, stud type terminal and arrangement

21 36 Nos. 17276.05 Hundred Each

for cable termination to be erected With Suitable foundation (Included) as per details given by

manufacturer considering site requirement.

(H) 9 Mtr. Long 70 mm Top X 155 mm bottom dia, 3 mm thickness with 260mmX260mmX16mm base

plate, 4-M24 Bolts and 750mm long with necessary G.I. J Bolts .Approx Pole weight 97 kg

Providing and erecting Street Light pole bracket comprising main B Class GI pipe of 4.2 cm/require

outside dia. complete with suitable B Class G.I. sleeve tubing of approx. 45cms.length and suitable for

76.5 mm /80mm / required size of pole top having sufficient fasteners for fixing the brackets and

22 36 Nos. 1002.93 And Paise Each

having spread of 1.5.mtr. length with 110 deg.with vertical plane & suitable welded stays, reducer and

with check nuts complete painted with one coat of Red oxide / PU base primer and two coats of

Aluminium / PU paint. paint with following nos of arms. [B] Double Arm Bracket 1.5 Mtr

Supplying & erecting IP 55 grade following size section pillar fabricated from joint less M.S. Sheet with

angle iron legs made from jointless M.S. Angle with cable clamps to be buried in ground to have Rupees

appropriate erection to work uniform until erected with cement concrete foundation and 45 cm high Sixteen

bricks work finishing with plaster etc. hinged double door internally supported on both side, with Thousand Six

internal and outside looking arrangement with look and keys in duplicate 35 x 35 x 5 mm M.S. Angle of Hundred

23 1 Nos. 16691.26 Each

Two Nos. one is welded and other with nut and bolt for erecting Bakelite sheet. Painting the Section Ninety One

Pillar inside and out side with three tank powder coated paint. section pillar roof should be without And Paise

joint with water leakage proof & tested as per IP 55 test & followed by IS 2147 of 1962 Twenty Six

(A) 150 X 90 X 75 cm section pillar fabricated from 14 Gauge MS Sheet with angle iron legs 95 cm Only

long made from 40 X 40 X 6 mm thick MS angle.

24 1 sq.mtr Supplying and erecting HYLAM sheet on existing angle iron frame.for following thickness. (E) 10mm 1927.08 Sq.mtr

Supplying & erecting approved make Digital time switch having lithium cell 6 years operative and

operate battery backup 1 channel day clock with 14 memory programme, suitable to operate on 240V

25 1 Nos. + 5%, 16A with, floating contacts Minimum switching setup time 1 minimum & LCD display. Also 3168.37 Each

comprised permanent ON/OFF switching. Programming switches & housed in fire proof thermoplastic

enclosure & transparent cover erected as required with necessary connection erected as directed.

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting AC-3 duty 3 pole power contactor with 2 NO & 2 NC aux contacts complete Hundred

26 1 Nos. 12297.76 Each

with 415V/220V operating coil suitable for (L&T, BCH,T.C., Siemens, C&S make).(E) for 110 A rating Ninety Seven

Total Amount Rs.

Total Amount Rs.

In Words:- Rupees Seventeen Lakh(s) Eighty Six Thousand Six Hundred Forty Nine And Paise Sixty Only

I / WE am / are willing to carry out the work ………………………………% above / below percent (Should be written in figures and words) of the Estimated rates

mentioned above. Amount of my / our tender works out as under.

Estimated Amount Estimated Amount Put to

Put to Tender Tender

Net Total Rs.______________________ Net Total Rs.____________

Name of Work: Providing and erecting Street light poles at GTU Entrance road at

Lekawada,Dist.Gandhinagar

SR NO MATERIALS /ITEM Make/ Brand

1 Mains and Wires KEI, RR Kabel, Finolex , Polycab, Havells

LED LIGHT FIXTURES (Indoor and outdoor) & Phillips, LT, Wipro, jaquar, Havells, Lukar, Halonix, Bajaj,

DRIVERS Pyrotech

ABB, LAURITZ KNUDSEN ,SIEMENS, LEGRAND,

3 LT SWITCHGEARS

4 LT CABLES KEI, RR Kabel, Finolex , Polycab, Havells

Dy.Exe.Engineer Exe.Engineer

C.P.Elect.Sub.Div.22 C.P.Elect.Division

Gandhinagar Gandhinagar