tender_Solarlight_Kasar_2026

Solar Street – 18W AIO, >=180 Lumen/Watt (non – hybrid) Supply, Fixing, Testing and Commissioning of 18 watt ALL-IN-ONE Solar Street Light “MADE IN INDIA” with IP 65 Protection for fixture; High performance potted electronic driver * MPPT Charge Controller Instant light with low running temperatures, Operating temperature: -0 °C to + 50 °C, Average life L70B50: 50000 hours, Back up 48 hrs with Intelligent Dimming PIR Sensor :For Movement detection Housing & Finish Powder Coated Aluminium Extruded Housing for effective thermal management, sturdiness, excellent corrosion resistant. Light Source High efficiency long life LED module with SMD LED package mounted on MCPCB. Lumen efficacy of LED >190 lm/W. Optics High efficiency polycarbonate UV stablized cover with integrated Lens to ensure Asymmetrical batwing light distribution. Driver In Built DC-DC type Potted MPPT Charge Controller Solar PV Module :- Mono Crystalline Solar Panel 40WP@STC Battery LIFePO4 with BMS 12.8 V 18 Ah Protections: a. Over-Charge protection b. Deep-discharge protection c. Over current protection d. Short circuit protection e. Over voltage protection f:-Low voltage Indication g:-Charging Indication Mounting Suitable for side entry, pole mounting with bracket arm OD 76 mm Max. MPPT controller and solar panel should be of same make( brand) IK08 (Third party NABL report), LM79,LM80 Reports. BIS OF SOLAR PANNELand battery. Fixture should be with Low voltage indicator of red color LED and charging indicator of green color LED, for the safety of the complete system fixture should have following protections:- Over-Charge protection Deep-discharge protection Over current protection Short circuit protection Over voltage protection. Make: To be approved before installation.

Brick work in C.M 1:5 mSupply, installation and erection into true verticle position of decorative ornamental mast pole with suitable arrangement on top for one solar led street light. Total height of the pole with bracket shall be 6000 mm nominal above the ground. The pole shall be made out of mild steel tube in multiple sections as per attached drawing. The different sections shall be joined together through flanges and swaging joints and are welded to get stable structure. The bottom section shall be of 300mm dia in taper x 4mm thickness x 0.5 mm long , top section shall be 60.1mm dia (grooved to dia 108 mm and swaged ) x 4.0mm thickness x 1500mm long. The base plate shall be of diameter 320mm and thickness 12mm and joined with the pole by welding joint with the help of stiffeners. The cast iron decorative embellishments shall be fixedwith the pole with the help of SS grub screws as shown in attached drawing. The cast iron embellishments fitted in pole shall be made in single casting, joining of two parts with bolts will not be accepted. Embelishments shall be made of cast iron. The decorative pole shall be machined and polished properly to give it a smooth surface. The decorative pole shall be duly pre-treated by shot blasting process and coated with high end epoxy primers and top coat in UV ray resistant polyurethane/Polyester coating in approved colour shade. The coating on the pole and bracket shall be baked in oven at required temperature and parameters. The DFT of coating on pole shall be 90 microns (minimum). The coating on pole shall pass minimum 500 salt spray hours. Wind pressure calculation shall be done as per IS 875. Including constructio of shallow foundation of RCC of dimensions 600mmX 600mm X 1000mm depth. including foundation bolts and nuts. Make- to be approved before installtion from Engineer In Charge.ix including all labour charges etc complete