Providing and Erecting Highmast Pole at Tandol Hot-Mix Plant at Tandol Taluka Himatnagar Dist. Sabarkantha.

:: SCHEDULE-B ::

Name of Work:- Providing and Erecting Highmast Pole at Tandol Hot-Mix Plant at Tandol Taluka Himatnagar Dist. Sabarkantha.

Qty Item Unit Rate in Figure & Word Amount

providing and erecting Mains with ISI marked electrolyte stranded copper conductor, Non PVC

Zero Halogen free fire retardant insulated copper conductor, insulated wire (HRFR) conforms Rupees One hundred

1 84.1 Mtrs. to IS-694, erected in existing pipe with 1.5sq. mm copper conductor of same specifications for Mtr. 128.27 Twenty Eight Paise

earth continuity of following size.[j] 3 wire 2.5 sq.mm Twenty Seven Only

Supplying and erecting LED street light / Flood light fittings with High power White LEDs

wattage of 3 Watt and above assembled on single MCPCB, efficiency more than 130 lm/w and

corrosion free High pressure die cast aluminum housing with smooth finish powder coated and

heat sink extruded aluminium with diffuser and Polycarbonate optics/ lenses, with toughened

glass with company mark/name engraved or embossed 160 to 270 V,Power Factor more than

Rupees Eight Thousand

0.95, THD < 10 %, CCT 3000 K to 5700K,Uniformity ratio >0.45, Luminaire efficacy>

2 6 Nos Each 8201.20 Two hundred One Paise

lumens/watt . LED driver efficiency > 85 %.( fittings required LM-79 & LM-80

certificates)(NOTE: Below description have shown ranges of Wattage capacity of LED

fittings.The Engineer incharge may select any wattage capacity between the ranges shown.) (B)

Flood Light (IP-65), Surge protection -4KV integral and ,Light must have 440VAC line supply

with over-voltage protection. (vi) 160 - 199 watts Cat-lll

providing and erecting Approved make Three Phase & Neutral LT Heavy Duty Switch

Disconnector Fuse Unit Cubical type for panel mounting complete with operating mechanism Rupees Four Thousand

3 1 Nos suitable to operate on 415V A.C. , 23A duty With HRC fuses of suitable load confirming to IS. Each 4442.99 Four hundred Forty Two

13947 (Part I & III). of following capacities.(c) 100Amp/125 Amp Cat-III Paise Ninety Nine Only

Providing and erecting Approved make Four pole moulded case circuit breaker having breaking

capacity ICU of 25 KA. at 415 V,having normal current rating up to 25 A to 100A. with Fixed Rupees Six Thousand

4 1 Nos thermal & magnetic release suitable to work on A.C. supply 50 c/s. with all internal connections, Each 6790.23 Seven hundred Ninety

spreader tinned copper & complete erected in existing 16 G.M.S. housing. ICS=100% of ICU Paise Twenty Three Only

Providing & erecting 240 V MCB double pole switch for lighting Load (B Curve) having 10 KA Rupees Three hundred

5 3 Nos breaking capacity & confirms to IS : 8828 in existing box having following capacity (B) 40 Amp. Each 325.22 Twenty Five Paise

Cat-III Twenty Two Only

Providing & erecting 415 V MCB Four Pole for Motor & Inductive Load (C Curve) having 10KA

Rupees Eight hundred

6 1 Nos breaking capacity & confirms to IS :8828 in existing box having following capacity (c)63 Amp. Each 811.03

Eleven Paise Three Only

Qty Item Unit Rate in Figure & Word Amount

Providing and erecting Annealed bare Copper wire 4.064mm to 1.626mm. Rupees Seven hundred

7 3 Kgs. Kg. 794.87 Ninety Four Paise Eighty

Supplying & erecting earth pit of minimum bore dia.150mm size approved make Earthing

Electrode consisting Pipe-in-Pipe Technology as per IS 3043-1987 made of corrosion free hot

dipped G.I.Pipes having Outer pipe dia of 50mm having 80-200 Micron galvanising, Inner pipe

dia of 25 mm having 200-250 Micron galvanising, connection terminal dia of 12mm with

constant ohmic value surrounded by highly conductive compound with high charge dissipation

suitable for following type of applications with chamber and heavy duty cover. (A)(approved Rupees Four Thousand

8 1 Nos make OEM has to submit test certificate including value of earth resistance of installation duly Each 4591.46 Five hundred Ninety One

stamped and signed by agency and officer Incharge has to ensure the value of earthing Paise Forty Six Only

resistane mentioned in test Certificate) & having back filling compound of (B) Inner chemical

(CCM Compound)- Resistivity:- 0.2 ohm / meter testing as per IEC 62561-2017, Voltage drop:-

< 1 volt at no load & dry form, Sulphar content:- <2%(C) Back fill Compound :- Earthing

compound should be

Providing and erecting XLPE(IS:7098)(I)-88 ISI armoured cable multistrand Aluminium Rupees Two hundred

9 110 Mtrs. conductor for 1.1 KV. to be laid on wall with necessary clamps or in existing trench / pipe of Mtr. 264.62 Sixty Four Paise Sixty

following size of cables(B) 3 1/2 core 35 Sq. mm ( 16 Sq. mm 1/2 core) Two Only

Making trench in soft soil of suitable width of 90 cm deep for laying cable or locating the fault all Rupees Fifty Five Paise

10 75 Mtrs. over the run and back filling the same and making the surface as normal ground. Mtr. 55.55

Fifty Five Only

Providing & laying approved make Double walled corrugated pipes (DWC) of

polyethylene(conforming to IS 14930 II )with necessary connecting accessories of same Rupees Sixty Two Paise

11 80 Mtrs. Mtr. 62.62

material at required depth in existing trench for laying of cable. below ground / road surface Sixty Two Only

for enclosing cable (A)50 mm outer dia

Providing and, fixing heavy duty flange type brass double compression type cable gland with

Rupees Seventy Five

12 4 Nos rubber ring for PVC insulated armoured cable complete with out going tails, insulating tape etc Each 75.75

Paise Seventy Five Only

for following size of cables.(B) 3 & 1/2 core 35/50 Sq. mm

Solder less crimping type Aluminium lugs conforming to IS suitable for cable of following size

Rupees Twenty Paise

13 16 Nos evenly crimped with high pressure tool & connected to switchgear terminals with brass/cadmium Each 20.20

plated nut bolts in an approved manner. (D) 35/50 Sq.mm.

Providing cement concrete. foundation or for concrete filling in 1:3:6 ratio with 20 to 25 mm Rupees Four Thousand

Cu. stone metal duly plastered with necessary curing for pole muffing or any other purpose. Cu.

14 2 4511.67 Five hundred Eleven

Paise Sixty Seven Only

Qty Item Unit Rate in Figure & Word Amount

Supplying & erecting approved make Digital time switch having lithium cell 6 years operative

and operate battery backup 1 channel day clock with 14 memory programme, suitable to

operate on 240V + 5%, 16A with, floating contacts Minimum switching setup time 1 minimum & Rupees Three Thousand

15 1 Nos LCD display. Also comprised permanent ON/OFF switching. Programming switches & housed Each 3168.37 One hundred Sixty Eight

in fire proof thermoplastic enclosure & transparent cover erected as required with necessary Paise Thirty Seven Only

connection erected as directed.

Supplying, erecting, testing, commissioning approved make M.S. Polygonal High Mast Pole

having following general Specification.

(a) Polygonal Section fabricated from M.S. Plate confirms BSEN 10025 & Hot deep galvanized

minimum 65/86 micron (as per IS 2629 /1985) Lantern carriage with ring and rubber lines for

erection of luminaries of suitable site.

(b) Maximum telescopic section not more than four

(c) Double drum gear pipe motorized winch with 6mm dia S.S. Rod (For 16 mtr and above size)

(d) Approved make L.E.D. aviation light = 1 No. Lightening arrestor = 1 No. with necessary

wiring of 2.5 sq.mm 5 core ISI copper cable Unarmoured.

16 (e) Bottom most section suitable for mounting reversible motor and switchgears having door not

more than 1400mm x 300mm with waterproof gasket & hinges & locking arrangement.(f) Pole

structure comprises suitable size of reversible motor, cable and necessary switchgears with

control panel. (g) bottom section shall have suitable size of thickness supports ribs foundation

bolts nuts etc.(h) Item not comprises the cost of lanterns.(i) Necessary Cement Concrete

foundation as per IS including testing & commissioning of the entire structure for following size

of High Mast poles

[1] High Mast 12 Mtr. TOP A/F 105 mm, BOTTOM A/F 360mm, No. of Sec. No. - 1, Bottom

Rupees One Lakh Sixty

Thickness - 3 mm, Size of Base Plate - Dia 520 mm x 20 mm thick, Foundation Bolt Size M24 x

Two thousand Eight

1 Nos 850 mm, Qty - 6 Nos., Suitable for mounting Fitting of Light - 6 Nos. Each 162858.46

hundred Fifty Eight Paise

Qty Item Unit Rate in Figure & Word Amount

Providing and erecting AC-3 duty 4 pole A.C. Coil with 2 NO & 2 NC aux contacts complete with Rupees Five Thousand

415V/220V operating coil suitable for (L&T, BCH,T.C., Siemens, C&S make).(C) for 60 / 70 A Seven hundred Twenty

17 1 Nos Each 5728.72

rating Eight Paise Seventy Two

Rupees Two Lakh Ninety Nine thousand Six hundred Eighty Two Paise Thirty Nine Only

I/ We am/are willing to carry out the work at_________% above / below percent (should be written in figure & words) of the estimated mentioned above. Amount of my / our tender

works out as under.

Estimated amount put to Estimated amount put to

(a) I/we hereby declare that we have visited the site and fully exquisite myself/ourselves with the Local situation regarding materials labour and other factors pertaining to work before

submitting Tender.

(b) I/we hereby declare that we have carefully studies the conditions of contracts. Detailed Specification and other tender document of this work and agree to execute the same accordingly.

1 If required and found necessary material to be used for this work and brought at site will have to sent to Govt.approved laboratory. The qualified agency/ manufacturer of

Particular product under testing will have to pay/ bear necessary charges.

2 All works shall be carried out as per public works Department hand book and other Specification.

3 Rates are inclusive of 1% Labour cess in tender amount so 1% of total amount of bill will be deducted from the bill.

3 Rates are inclusive of 1% Labour cess in tender amount so 1% of total amount of bill will be deducted from the bill.

4 The material to be used in this work must be as per instruction by under liason of Engg. In charge.The agency will have to agree to carried out the work as per brand/make

demand of concern deptt.

5 Contractor must have registration in "E-2" & above class registered under elect. (R & B) division and having similar type of work experience .

6 The agency will have to agree to carried out the work as per brand/make demand of concen Deptt.If instead so by concern Deptt.

Sign of Dy. Executive Engineer Executive Engineer

Contractor Himatnagar Elect.(R&B) Sub-Division. Himatnagar Elect.(R&B) Division.

Himatnagar. Himatnagar.