SPECIAL REPAIR TO AREA DRAINAGE IN VARIOUS LOCATION AT SECTOR A FATEHGUNJ UNDER GE (A) VADODARA.

Demolition of brick work or stone/block masonry built in cement mortar including all quoines arches,pillar etc but excluding ashlar facing , dressed stone work and precast concrete articles, all as specified and directed.

Demolition of cement concrete (un-reinforced) in ground floor and paving n.exc 15 cm thick below or above ground level complete all as specified.

Excavation in trenches n.exc 1.5m depth & 1.5m width for foundation in trenches n.exc 10 sqm plan & getting out in any type of soil

M&L Cement concrete Type D2 1:4:8(40mm graded stone aggregate) in foundations, filling and mass concrete all as spd and directed.

Use and waste of formwork for rough finished surfaces of walls, retaining walls, abutments, parapets and staircase railing and similar work including attached pillasters, buttresses, etc.; vertical or to better all as speciified and directed

Use and waste of formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick, fair finished and flat surface (Horizontal or sloping), all as specified and directed.

M&L for reinforced cement concrete (nominal mix) Type B1, 1:2:4 (20mm graded stone aggregate) in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and as directed.

M&L for reinforced cement concrete (nominal mix) Type B1, 1:2:4 (20mm graded stone aggregate) as in Walls, retaining walls, basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilaster and buttresses complete all as specified and as directed.

M&L for reinforced cement concrete (nominal mix) Type B1, 1:2:4 (20mm graded stone aggregate) as in Slabs supported on walls,beams and columns in floors, roofs, landings, balconies, canopies, deck slabs complete all as specified and as directed.

M&L for TMT bars 10mm dia and over , cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with the including mild steel wire (annealed) not less than 0.9mm dia or securing with clips all as specified.