Annual Maintenance of Sadangi To Tarinisahi_Road_Overlaying on damaged existing CC_0.000 to 1.000 for the year 2026-27

Dismantling and removing cement concrete including stacking the useful materials for reuse and removing the debris within 50m lead etc. complete as per direction of Engineer-in-charge.

Construction of embankment with approved material obtained from borrow pit with all lift & leads, transporting to site by mechanical means within a lead of 5 Kms,spreading, grading to a required slope & compacting to meet requirement of table 300-2 & clause 305 of MoSRT & H specification for Road & Bridge work (AR - 06, P - 157, item no - 35)

Filling sand-Supplying & filling good clean river sand of approved quality including watering to complete saturation & ramming complete with all leads & lifts including cost, conveyance, royalty & taxes of all materials & cost of all labour & T&P required for the work etc. complete as per specification & direction of Engineer in charge.

Plain cement concrete M-15 grade in Foundation complete as per drawing and technical specification.

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.