Additional and alteration work at Amod Judge Quarter, Ta. Amod, Dist. Bharuch

Name of Work :- Additional and alteration work at Amod Judge Quarter, Ta. Amod, Dist.

BILL OF QUANTITIES

It. No. Description of Item Quantity Unit Rate in Figure Total

1 Providing and laying Cement concrete 1:2:4 (1-cement : 2 Coarse : 50.00 Cum. 3481.28

4 Fine Graded stone aggregates 20mm nominal size) and curing

complete excluding cost of Formwork (A) Foundation and plinth.

2 Providing and laying cement concrete flooring 1:2:4 (1-cement : 2- 129.00 Sqm. 330.88

coarse sand : 4-graded stone aggregate 20mm nominal size) laid in

one layer and finished with a floating coat of neat cement.

3 Providing and laying water proofing treatment with broken chine 129.00 Sqm. 747.29

mosaic flooring for terrace using 12 mm to 20 mm broken pieces of

glazed tiles to be laid over cement mortar 1:3 to plain or slope and

to be tempered to bring mortar creme out upto surface using white

cement including rounding off junctions and extending them upto

cm along the wall, clearing with water and oxalic acid etc. as

4 Providing and fixing "Y" shape concertina razor coil roll Fencing 10 140.00 Rmt. 734.27

mm c/c with 50 x 50 x 5 angle for "Y" and 35 x 35 x 5 angle for

bottom and sides as shown in drawing & G.I. barbed roll fencing

10cm C.C. spray and oil painting etc.

5 Providing & Fixing in position standard extruded Aluminium Three 10.20 Sqm. 1895.77

track (2 shutter + 1 mosquito net shutter) with standard Extruded

Colour Anodized Alluminium Section Equivalent to Jindal Series E

(30 mm) section Numbered: Frame-Bottom with Gutter-21203,

Frame Top & Side-20837, Shutter Top & Bottom 20993, Shutter

Inter Lock - 20550, shutter side (Handle) - 20553 with 5mm thick

transparent Tinted Float Glass with EPDM Rubber Gasket, Air Lock

strip and Finishing, joint with section sealant, with powder coated

standard Alluminium fitting. with as per window size including all

required materials labours and equipment's as per detailed drawing.

6 Providing and fixing pre-cast Rubber Dye/Steel Dye inter locking 242.00 Sqm. 685.42

Concrete Block 60mm thick with grade of concrete M300 pneumatic

compressed/vibrated mechanically and as per approved design

confirming to IS 15658:2006 including 35mm sand layer for levelling

and filling the joint with sand in proper line and level as per

guidelines of IRC:SP 63-2018 etc. Complete.

7 Finishing wall with weather proof Exterior Emulsion Paint on wall 260.00 Sqm. 114.53

surface (two coats) to give an even shade after thoroughly brushing

the surface to remove all dirt, and remains of loose powdered

materials. Etc complete.

8 Distempering (Two coats) with oil bound Distemper of approved 299.00 Sqm. 71.90

brand and manufacture and required shade on wall surfaces to give

an even shade, over and including a priming coat with distemper

primer of approved brand and manufacture after thoroughly

brushing the surface free from mortar dropping and other foreign

matter and also including preparing the surface even and sand

papered smooth.

9 Replacing old & us Flexible PVC wire by Supplying and erecting 21.00 Rmt. 46.46

Flexible PVC insulated multi strand multi core 1.1 kv grade ISI

marked copper wires of following size to be erected as directed.(e)

1.50 Sq.mm 3 core round PVC sheathed

10 Supplying and erecting LED street light / Flood light fittings with High 2.00 No. 6566.01

power White LEDs wattage of 3 Watt and above assembled on

single MCPCB, efficiency more than 130 lm/w and corrosion free

High pressure die cast aluminum housing with smooth finish powder

coated and heat sink extruded aluminium with diffuser and

Polycarbonate optics/ lenses, with toughened glass with company

mark/name engraved or embossed 160 to 270 V,Power Factor more

than 0.95, THD < 10 %, CCT 3000 K to 5700K,Uniformity ratio

>0.45, Luminaire efficacy> 100 lumens/watt . LED driver efficiency >

85 %.( fittings required LM-79 & LM-80 certificates)(NOTE: Below

description have shown ranges of Wattage capacity of LED fittings.

The Engineer in charge may select any wattage capacity between

the ranges shown.)(A) Street Light (IP-65), Surge protection -4KV

integral and ,Light must have 440VAC line supply with over-voltage

protection. (iv) above 90 to 120 watts cat-III

It. No. Description of Item Quantity Unit Rate in Figure Total

11 Supplying and erecting LED street light / Flood light fittings with High 1.00 No. 5599.44

power White LEDs wattage of 3 Watt and above assembled on

single MCPCB, efficiency more than 130 lm/w and corrosion free

High pressure die cast aluminum housing with smooth finish powder

coated and heat sink extruded aluminium with diffuser and

Polycarbonate optics/ lenses, with toughened glass with company

mark/name engraved or embossed 160 to 270 V,Power Factor more

than 0.95, THD < 10 %, CCT 3000 K to 5700K,Uniformity ratio

>0.45, Luminaire efficacy> 100 lumens/watt . LED driver efficiency >

85 %.( fittings required LM-79 & LM-80 certificates)(NOTE: Below

description have shown ranges of Wattage capacity of LED fittings.

The Engineer in charge may select any wattage capacity between

the ranges shown.)(B) Flood Light (IP-65), Surge protection -4KV

integral and ,Light must have 440VAC line supply with over-voltage

protection. (ii) above 48 to 60 Watts cat-III

672137.24 TOTAL

Rs. Six Lakhs, Seventy Two Thousand, One Hundred Thirty Seven and Twenty Four Paisa

I/We am/are willing to carry out the work @ ______________ % ______________

percent (should be written in figures and words) below / above, the estimated rates mentioned

above, amount of my/our tender works out as under :

Above all items of "Bill of Quantities" with Item Description, Unit, Qty, Rate & Amount have verified by me

and found order.

1 The Contractor shall exhibit a board with detailed specification and details of work as directed by the

Engineer-In-Charge for which no extra payment shall be made.

2 The labour cess will be deducted as per prevailing rules i.e. 1% of the work done.

3 GST and Income tax TDS will be deducted at a source while making payments of bills

4 In all R.C.C. Items in Rate Analysis Standard Cement Consumption has been taken as per Govt.

G.R.: PRC-10/2017 Cement Consumption/16/C, Date:11/05/2017 as stated in S.O.R. therefore in

R.C.C. items where there is a change as per actual mix design the cost of difference of cement

consumption have been deducted from the rate of original item at the rate of input rate mentioned in

all the tender.

5 The contractor will have to submit the mix design for different grades of cement concrete and

asphalt at his own cost before execution as directed and to be approved from the engineer in

Deputy Executive Engineer Executive Engineer

District (R&B) Sub Division Bharuch (R & B) Division

Bharuch Bharuch