CERTAIN REPAIR TO PLINTH PROTECTION, AREA DRAIN, PARKING AREA, ROAD,

Amount

Demolition of cement concrete in ground floors and pavings n.exc 15 cm thickness (below or above ground level) all as specified and directed.

M&L for 75 mm thick PCC 1:3:6 type C1 using 20 mm graded stone aggregate as in plinth protection, paving including finishing the surface even and fair complete all as specified and directed.

M&L for 100 mm thick PCC ( 1:3:6) type C-2,using 40mm graded stone aggregate as in hardstanding/path/sub base finished to an even and fair surfaces all as specified and directed.

M&L forming contraction (Dummy) joints 65 mm deep x 10 mm wide, filled with sealing compound Grade 'A' all as specified and directed.

Dismantling fencing wire mesh from concrete Post/struts complete all as specified and directed.

Supply only 2 mm dia MS galvanised coated Chain Link fencing 60 x 60 mm size complete all as specified and directed. Make:-Tata or Equivalent Note : Unit weight per square meter will be measured by Board of Officer

Fixing only chain link fencing including line wirers ,any mesh any type of standards, rails ,straining bolts etc including provn of binding wire complete all as specified and directed.

S&F Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut dia meter of neck 11 to 15mm and length of bolt exc 10cm and n exc 15cm long

S&F mild steel round bars 10mm dia cut to length, bent to shape as required and fixed in fencing confirming to Fe 410-Wor Fe 290 complete all as specified and directed.

S&F Mild steel work as in hand rails , half round or other section, balusters running bars, nosing to steps, wind ties, posts and struts in fencing including cutting tops to shape as required, drilling holes , notching for wire , flat iron fillets for securing wire mesh etc., including all necessary drilling, bolting or riveting etc & similar work conforming to Fe-290 Gde E-165 and all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed trusses all as specified and directed.

S & F MS work in railings ,balusters ,posts and struts in fencing etc including cutting tops to shape as directed ,including all necessary welding ,drilling bolting or riveting etc and similar work conforming to FE 290 Gde E-165 complete all as specified and directed.

S&F framed work as in doors or gates of angle or other section with gusset plates, rails, braces etc. complete drilled for fixing of steel sheeting or other covering. Doors etc to be prepared for hanging with and including hooks and hinges, also fastening and fixing complete conforming to Fe-410W (Gde-E-250), all as specified and directed.

M&L for preparation of new steel surfaces over 10cm width or girth and applying two coats of VX-polymer based anti-corrosive paint over a coat of anti corrosive primer complete all as specified.

Demolition of precast block masonry built in cement in cement mortar or cement lime mortar all as specified and directed.

M & L precast cement concrete block masonry with solid blocks ,exc. 10 cm in width and setting in CM 1:6 type C1 1:3:6 (20 mm graded stone aggregate) all as specified and directed.

M&L Pre-cast cement concrete block masonry with solid blocks, 10 cm thick and setting in CM 1:6 type C1 1:3:6 (20 mm graded aggregate) all as specified and directed.

M&L for rendering plaster 15mm thick in cm 1:4, and making surfaces fair and even complete all as specified and directed.

M&L for preparation of new plastered surfaces of walls and applying two coats of cement base paint over a coat of white wash complete all as specified and as directed.

Demolition floor, hearth or wall tiling including cement mortar bedding (but not backing ), removing serviceable tiles to store and rubbish off the premises.

M&L 20 mm thick screed bedding layers in cement mortar 1:6 for laying floor finishes tiles .

M&L chequered cement concrete tiles 30 cm x30 cm x 20 mm thick set, jointed and pointed in neat cement slurry in floors with grey cement and pigments all as specified and directed.

Demolition of cement concrete un-reinforced in in any position not otherwise specifically provided for all as specified and directed.

M & L Hard core broken stone or boulders of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick and watered and rammed to a true surface complete all as specified and directed.

M&L machine pressed precast concrete interlocking paver block of any shape and size conforming to IS-15658-2006 of 60mm thickness,M-35 grade fixed with grey cement and no pigments all as specified and directed.

Providing cement concrete type B0 1:2:4 (12.5 mm graded stone aggregate) as in kerbs, mud stops ,rounded or chamfered on edges all as specified and directed.

JESWIN BUILDERS (BID ID -3073783)

K R JOSEPH AND SONS (BID ID -3073832)

K.V.GEORGE AND COMPANY (BID ID -3066317)

SOORYA ASSOCIATES (BID ID -3065892)

STANDARD ENGINEERING (BID ID -3072785)

T K BUILDERS (BID ID -3066504)

WELTRONENGINEERINGSERVICES (BID ID -3079729)

ATC CONSTRUCTION (BID ID -3074506)