Improvement / Repair to different water supply schemes in Kalaban Section pertaining to small /petty works of Distt. Capex, M AND R, BADP/ TSP and other deposit works falling under the jurisdiction of PHE Sub Division Mendhar.

Amount

Cleaning jungle including uprooting of rank vegetation, grass, brushwood, trees and saplings of girth upto 30cm measured at hieght of 1m above ground level and removal of rubbish upto a distance of 50m outside the periphery of the area cleared.

Earth work in excavation by manual means in tranches for foundation, drains, pipes, cables etc. (Not exceeding 1.5m in width) and for shafts, wells, cess pits and the like not exceeding 10 Sqm on plan, depth upto 1.5m, including disposal of excavted earth upto 1 mtr from cutting edge, disposal earth is to be levelled and neatly dressed in: all kinds of soils.

Earth work in excavation by mechanical means (Hydraulic excavator) over areas (Exceeding 30cm in depth, 1.5mtr in width as well as 10 Sqm on plan) including disposal of excavated earth, lead upto 50m and lift upto 1.50m, disposal earth is to be levelled and neatly dressed in: all kinds of soils.

Filling available excavated earth (excluding rock) in trenches plinth sides of foundation etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering lead upto 50m and left upto 1.5mtr. (Deduct for not rolling an

Dismentling manually/mechanically including stacking of serviceable material and disposal of unserviceable material within 50mtr lead: a) Water bound macadam road.

b) Bituminous road

Dismantling of G.I.pipe (external work) incl. excavation and refilling trenches after taking out pipes manually/by mechanical means incl. stacking of pipes within 50mtr lead: a) 15mm to 40mm nominal bore

b) Above 40mm nominal bore

Deployment of extra fitters/Mazdoor for restoration of damaged G.I.pipes, rethreding of pipes, locating/traces of blockages/leakages and Cleanical of Digwell/GSR/OHT. A) Mazdoor

b) Fitter

Laying & Fitting of G.I.pipes complete excluding cost of pipes and earth work. 15mm dia G.I.pipe

20mm dia G.I.pipe

25mm dia G.I.pipe

32mm dia G.I.pipe

40mm dia G.I.pipe

50mm dia G.I.pipe

65mm dia G.I.pipe (L)

65mm dia G.I.pipe (M)

80mm dia G.I.pipe (L)

80mm dia G.I.pipe (M)

100mm dia G.I.pipe (L)

100mm dia G.I.pipe (M)

Fixing/replacement of CI Sluice valves/Check valves complete with bolts, nuts, rubber insertions etc. (Sluice Valves/Check Valves to be supplied by the department) 150mm dia G.I.pipe (Rate to be quoted by the bidder)

100mm dia G.I.pipe (Rate to be quoted by the bidder)

80mm dia G.I.pipe (Rate to be quoted by the bidder)

65mm dia G.I.pipe (Rate to be quoted by the bidder)

50mm dia G.I.pipe (Rate to be quoted by the bidder)

Provoding/Fixing/replacement of GM Gate Valves/Brass stop Cocks complete incl. bends, collars, unions & other allied items 150mm dia G.I.pipe (Rate to be quoted by the bidder)

100mm dia G.I.pipe (Rate to be quoted by the bidder)

80mm dia G.I.pipe (Rate to be quoted by the bidder)

65mm dia G.I.pipe (Rate to be quoted by the bidder)

50mm dia G.I.pipe (Rate to be quoted by the bidder)

40mm dia G.I.pipe (Rate to be quoted by the bidder)

32mm dia G.I.pipe (Rate to be quoted by the bidder)

25mm dia G.I.pipe (Rate to be quoted by the bidder)

20mm dia G.I.pipe (Rate to be quoted by the bidder)

Making connection of G.I.distribution branch with G.I.main of following sizes by providing and fixing Tee, incl. cutting and threadin the pipe etc. complete. 25 to 40mm nominal bore

50 to 80mm nominal bore

Fabrication of joints GI/DI/NS (complete job) and involves and following items. Earth Work Excavation, Cutting of pipes with Hack- Saw, Refilling of exacavated earth 90% earth work item, disposal of unserviceable material with in 500 mtr by head load, demolishing of concrete / tiles/ bituminious/ WBM:- (a) 25 mm dia to 50 mm dia (Rate to be quoted by the bidder)

(a) 65 mm dia to 100 mm dia (Rate to be quoted by the bidder)

(b) 125 mm dia to 150 mm dia (Rate to be quoted by the bidder)

Providing & laying in position cement concrete of specified grade excluidng the C/o centring & shuttering all work upto plinth level in 1:3:6 (1 cement: 3 coarse sand: 6 graded stone aggr. 20mm nominal size (Crusher)

Reinforced cement concrete work in arches, archribs, domes, valults, shells folded plate & frros having slope more than 15 upto floor five level excl. the C/o centring, shuttering, finishing & reinforcement with 1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggr. 20cm nominal size)

Reinforced cement concrete work (any thickness), incl. attached pilasters, buttresses, plinth and string courses, fillets, coloumns, pillars, piers, abutments, posts ans sturts, etc. upto floor five level excluding cost of centring, shuttering, finishing and reinforcement 1:1.5:3 (1 cement: 1.5 coarse sand: 3 graded stone aggr. 20mm nominal size (Crusher)

Centring and shuttering incl. strutting, propping etc. and removal of form work Foundation, footings, bares of column etc. for mass concrete

Extra for shuttering in circular works 20% for foundation

Centring and shuttering including strutting, propping etc. and removal of form work for Walling

Extra for shuttering in circular works 20% for Wall

Cement concrete flooring 1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggregate) finish with a floating coat of neat cement including cement slurry, but excluding the cost of nosing of steps etc. complete. 40mm thick with 20mm nominal size stone aggregate crushed

Providing & laying in position cement concrete of specified grade excluidng the C/o centring & shuttering all work upto plinth level in 1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggr. 20mm nominal size (Crusher)

Providing & laying in position specified grade of reinforced cement concrete excluding the C/o centring & shuttering, finishing & reinforcement all work upto plinth level in 1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggr. 20mm nominal size (Crusher)

Demolishinmg cement concrete manually/by mechanical means incl. disposal of material within 50mtr lead: 1:3:6 of richer mix

1:4:8 of richer mix

Reinforcement for RCC work incl. straightening, cutting, bending, placing in position and binding all complete (TMT)

Colour washing such as green blue or buff to give an even shade. New work (two or more coats) with a base coat of white washing with lime

12mm cement plaster of mix 1:4 (1 cement: 4 coarse sand)

Finishing walls with water proofing cement paint paint of required shade. Old work (One or more coat)

Push on joints to centrifugally (Spun) cast - Iron pipes or ductile Iron pipes including testing but excluding the cost of rubber gasket (Labor rate only) (a) 100 mm dia

(b) 150 mm dia

(c) 200 mm dia

(d) 250 mm dia

(e) 300 mm dia

Laying in position S&S or flanged CI special such as Tees, Bends, Collars, Tappers and capsetc (excluding cost of specials )

Locating / Tracing of blokages / leakages including excavation of pits

Brick work with common burnt clay FPS (non - modualar ) bricks of class designation 75 in foundation and plinth in : cement mortar 1:6

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering – All work up to plinth level1:4:8 (1 cement: 4 Coarse sand: 8 graded stone Agg. 40 mm nominal size) Crushed

Silt clearence from GSR inclkusive of initial leads and lift (50m and 1.5 m respectively) wet

Dismantling old plaster or skirting, raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead.

Demolishing R.C.C. work manually/by mechanical means including stacking of steel bars and disposal of unserviceable material within 50 metres lead

R C C work in beams suspended floor, roofs etc. Up to floor five level excluding the cost of centring shuttering, finishing and reinforcement with 1:2:4 (1: cement 2: coarse sand 4: graded stone aggregate 20mm nominal size)

Carriage of TMT Steel average distance 25 KM by Mechanical Transport

Carriage of Cement average distance 25KM Mechanical Transport

Carriage of Sand average distance 30 KM from nallah to site of work by Mechanical Transport

Carriage of Stone aggregate average distance 30 KM from crusher to site of work by Mechanical Transport

Carriage of cement by manual labour average distance 2.00 KM by head load

Carriage of steel by manual labour average distance 2.00 KM by head load

Carriage of sand/stone aggregate by manual labour average distance 2.00 Km by Head Load

Arjum Bi