14/EDCB/2025-26

Amount

The work of safe carriage of the following material from CB Ganj store center to work site under the jurisdiction of EDD-Baheri Approx. distance upto 100 Km. Including safe loading and unloading.

PCC Pole 8.5 Mtr

ST Pole 11 Mtr

ST Pole 13 Mtr

AB Cable 3x50 sqmm

AB Cable 3x95 sqmm

AB Cable 3x120 sqmm

ACSR Weasal Conductor

Other Line material

Erection of Single/Double pole in H.T/L.T lines including fitting of all accessories as per RESSPO Norms

PCC Pole 8.5 Mtr (Single)

Grouting of following Pole with 1:4:8 mixture in size(450x450x1500mm.) including cost of cement/BB & sand Required as per RESSPO Norms

PCC Pole 8.5 Mtr (Single)

The work of Driving the earthing electrode and making connections with 6 S.W.G. GI wire as per RESSPO Norms

Construction of T/F plinth 2x2x1 m3 for mounting 250 KVA T/F including foundation work (below ground 0.5 M), Brick work, RCC slab of 4” thickness and plastering in 1:6 ratio with 02 Nos channel pieces of 1.5 mtr long of size 100x50x6 mm compete in all respect

Cage fencing of 250 KVA Plinth mounted transformer in Town areas to avoid electrical human/cattle accidents by fabrication of cage (1 Inch Sq wiremesh) made of 10 No gauge in suitable size angle iron frame of size 7.5'(L)x5'(W)x8’(H) by strenghtening of wire mesh 20x3 mm M.S. flat haorizentally as well as vertically, Grouting the panel with 1:2:4 cement/coorse send/brick ballast. The Frame should be bolted on angles at the four corners so that frame may be un-bolted/bolted at the time of replacement of the transformer. Provision of 1 gate should be there for maintenance of the transformer. Painting (1 coat of red oxide + 2 coat of Bus green enamel paint). The wire mesh should be earthed with 50x6 mm MS earthing strip with existing earthing of Transformer Body. All men, material and T&P provided by the contractor to complete the fabrication, transportation and installation.

Laying, Stringing & Sagging of Following Conductor complete in all respect

AB Cable 3x50 Sq mm

AB Cable 3x95 Sq mm

AB Cable 3x120 Sq mm

ACSR Weasal Conductor

The work of digging of pits, erection of Stay Clamp, Insulator etc.

Grouting of stays, 1:4:8 cc ratio (600x600x300mm.) as per RESPO norms.

Fixing of 3 Phase Distribution Box

Gaurding at Road Crossing Complete in all respect

Supply and Fixing of Following Material as per RESPO norms complete in all respect (would be Provided by contractor through approved vendors of Discom at his own cost)

LT Clamp Nut & Bolt

Holding Clamp for T Off, Cross Arm and Expouser Pole

PG Clamp

Piercing Connector

F Clamp with Nut & Bolt

X-Arm Clamp with Nut & Bolt

Eye Hook Clamp

j Hook Clamp

Eye Hook WITH Suspension Clamp

Eye Hook WITH Dead End Clamp

Earthwire Clamp

Distribution Clamp

M/S HINA ELECTRICALS (BID ID -5533809)

M/S BEG ENTERPRISES (BID ID -5535116)