Cleaning Food Preparation and Garden Maintenance of Rest Houses in babbanpur and Bharthala

Scraping of Cement Plaster

Dismentling of 2nd class mud roofing

Stripping and stacking slate or tiles of a roof and add for planks and battens

(a) Doors of area 3sqm and below

12.5 mm thick cement Plaster 1:4

Applying priming coat with cement primer in all shades on newly plastered or concrete exterior surface

Painting two or more coats excluding priming coat with synthetic enamel paint in all shades on wood work, metallic or plastered, concrete surface to give an even shade.

Providing and laying Rectified porcelain floor tiles 400mmx400mm or more of premium quality conforming to IS:15622 of approved make in all colours laid on 20mm thick bed of Cement mortar 1:4 for new flooring including pointing the joints with white cement and matching pigments etc.,complete

Reinforced cement concrete M-20 mechanically batch mixed using batch type concrete mixer as per IS:1791 and vibrated by needle vibrator but excluding steel reinforcement,centring and shuttering in Superstructure

Cold twisted deformed(Ribbed/Tor Steel Bar) Bars Fe 500 grade as per IS 1786-2008, for R.C.C works,where not including in the complete rate RCC including bending and placing in position complete

Centring and shuttering for flat surfaces such as suspended floors,roofs,landings,chajjas, shelves etc.

Cement concrete 1:2:4 gola 10cm×10cm concave quadrant along junction of roofs with parapet wall finished smooth,where specially specified

Providing and applying plaster of paris (ISI marked such as JK, Kohinoor, Maharaja etc.) punning 6mm thickness over plastered surface to prepare the surface even and smooth complete in all respect as per the directions of Engineer-in-charge.

Deodar wood chowkats including iron hold fasts iron hinges corner straps clears, stops wooden knobs fixed in position.

(b) Single Rebate (60mm x 100mm)

First class burnt brick work laid in cement sand mortar 1:3 in first storey upto 4 metres above plinth level

Dismantling brick work tile, masonry or tile lining in cement

Cement concrete 1:3:6 with stone ballast or shingle mixing by mechanical means using concrete mixer volumetric type

Precast Cement Concrete Kerb Providing and laying factory made rubber moulded smooth finish cement concrete Kerb M-20 grade 250mm high with bottom width 165mm and top width 115mm made over strong vibratory table and fixing with cement mortar 1:2 as per MORT&H specifications

Teak wood wire gauge shutters without spring (Single Leaf) 35mm thick

Providing & fixing in position Water Cooler without Stablizer of approved make (to the approval of Engineer-in-charge ) including carriage complete in all respect. Water Cooler Full Steel Body 40/80 ltr Capacity without Stablizer

Providing and fixing in position Chinaware extended wall hunged European type Water closet with P-trap or S-trap of approved make (to the approval of the Engineer-in-charge) with 10ltrs chinaware matching flushing cistern and seat cover complete in all respect.

Providing & fixing in position vitreous Chinaware white large flat back or angular lipped front urinal 610mm high of approved make (to be approval of the Engineer-in-charge)(610mm x 410mm x 380 mm) consisting of C.P.waste 32mm dia and CP brass spreader,complete.

Providing and fixing in position C.P. Brass basin mixer without pop-up waste system with 450 mm long flexible hose of approved make (to the approval of the Engineer-in-charge) complete in all respect

Providing and fixing in position 5mm thick bevelled edge mirror of superior glass (of approved make) complete with 4mm thick hard board backing fixed in with rawl plugs 50mm,C.P.brass screws and washers and S/S Studs on top complete in all respect (as required by the Engineer-in-charge) Size 550mm×400mm

(a) C.P.brass Pillar cock

(c) C.P.brass 15mm angular stop cock with adjustable wall flange

(e) C.P. Brass wall mixer with non telephonic shower arrangement.

(g) C.P.brass towel Rails size 15mm dia 610mm long

(i) C.P. Brass toilet paper holder with flap

(k) C.P.brass towel rack 600mm long with lower hanger

Providing & Fixing in position C.P. Brass extention piece 25mm long to 50mm long of approved make (to the approval of the Engineerin-charge) with various fixtures complete in all respects.

Providing & Fixing in postion CP brass khunti with 6 pegs of approved make (to the approval of the Engineerin-charge) complete in all respect.

Providing & Fixing in PVC flexible tube connection of approved make (to the approval of the Engineerin-charge) complete in all respect. PVC tube connection Size 15mm×450mm with C.P.brass nut

Providing and fixing in position gully traps fixed in cement concrete 1:4:8 complete with Grating 150mm x 150mm, cover and frame clear opening 300mm x 300mm and out of side size 330mm x 330mm and chamber including cost of all bricks work in cement morter 1:5 cement concrete 1:2:4 in coping around cover and frame etc. as per standard design minimum depth of water should be 150 mm with a minimum seal 50mm. 100mm internal Diametre H.C.I. gully trap with H.C.I. grating and cast iron cover weighing approximately 7.26kg. and frame clear opening 300mm x300mm and out of side size 330mm x 330mm

(a) 110mm o/d SWR UPVC pipe line laid complete

Providing & Placing in position on terrace ( at all floor levels) HDPE water storage tank of approved make (to the approval of the Engineerin-charge) with cover with suitable locking arrangement and making necessary holes for inlet outlet and overflow pipes, but without fittings and base support for tank complete in all respects. (Triple layer tank)

Providing and fixing in position automatic brass ball cock in tanks with rod and plastic ball (25mm i/d)

(a) Size 75mm×75mm

Providing and fixing in position storage type automatic electric water heater pressure/non pressure type thermostatically controlled, single phase, vertical wall mounted of approved make (to the approval of Engineer-in-charge) with thermostats, inner container of stainless steel complete with 1 mtr. three core flexible cord with plug,non return valve and pressure release valve complete including fixing and testing complete in all respect 25 litre capacity water heater

(a) 25mm i/d

Construction of brick masonary inspection chambers size as per given below upto 0.6 m average depth in 1:5 cement sand mortar, lime concrete with 40 percent lime mortar 2:3 in foundation, cement concrete 1:2:4 benching 12.50mm thick cement plaster 1:2 with a floating coat of 1mm thick og neat cement,R.C.C.1:2:4 slabs 100mm thick cement concrete topping 50mm thick with 455mm×455mm, 455mm×610mm in side light duly C.I. inspection chamber cover and frame (Weight as per specifications) painted with 3 coats of black bitumastic paint conforming to I.S.I complete as per standard design. Size 450mm×450mm in side with RCC 455mm×455mm cover and frame medium duty double seal."

(a) Wiring fan point with sheet metal fan box (shapehexagonal & sheet thickness not less than 1.60 mm) in PVC insulated copper conductor single core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade with steptype electronic fan regulator 100watts.

(c) Wiring call-bell point in PVC insulated copper conductorsingle core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade with bell push and electronic buzzer 230volts AC (including the cost of bell push, electronic uzzer & powder coated concealed metal box for electronic buzzer.

(e) Wiring 3 pin 16/20 amp. power plug control (shuttered) and switch

Supply and erection of PVC insulated FR single core Unsheathed copper conductor cable (ISI marked) suitable upto 1100 volts grade confirm to IS:694/1990 left bare in pipe or casing of suitable size complete in all respect as desired by the Engineer-in-charge Overall size 2.5sq.mm (Un-sheathed)

Any Other Items