Providing, Installation, testing and commissioning of SPS 1000GPH X 120MH long with allied electro mechanical works at pumping station BGSB Universty Borewell.

Amount

Servo Controlled Voltage Stabilizer 15 KVA. Oil cooled, unbalance Type 415 Volt, 3 ph. Complete with transformer oil in copper windings with transformer oil. Input Range: 170V – 432 Volts. Output Voltage : 415 volts +/- 1%. Capacity : 15KVA Phase : 03 Make : Confirming to relevant ISO With all latest amendments Input voltage : (170-432 ) volt Output voltage : 415 volts +/- 1% Type : servo Correction Rate : 12 to 35 V/sec Regulation : +/- 1% Frequency : 48 to 52 Hz Cooling Method : Oil Cooled Efficiency : 95% High & Low cut off : Installed with standard Capacity By pass change over Switch : Yes MCCB : Heavy Duty Single phase preventer : Yes Material of Construction : The Core should be first quality ( CRGO) Silico Steel core, Conducting conductor should be off 99.95% of ctrolytic Copper MS Steel thickness of container 14/16 SWG. Transformer Oil to be used shall be of best quality Conforming of IS 335 with latest amendments. Voltage stabilizer shall be mounted on 02 pairs of H/D MS wheels for making shifting/ fixing easy. Voltmeter/Ampere meter Good quality ISI make

Providing installation, testing and commissioning of SPS 1000GPH discharge x 120MH (Percentage Head variation +10 -25) confirming to relevant ISO with all latest amendments with allied electro mechanical works at pumping BGSB Universty Bore well

Installation, testing and commissioning of Submersible Pump Set 1000GPH x 120MH along with allied electromechanical equipment at BGSB University Bore well , by way of fabrication of 40mm dia GI pipe nipples 10ft long welded with MS flanges-40mm dia at both ends-10nos and 20ft long welded with MS flanges-50mm dia at both ends-05nos, for making delivery of the pump. Fabrication of GI pipe nipple with threads at one end & MS flange at other end & fastening the threaded end of nipple with the delivery of pump. Fabrication of MS clamps 40mm dia. - 02 Nos. for holding submersible pump & nipples. Fabrication/ fitting of bed plate for resting of clamps for holding submersible pump & nipples. Coupling of pump motor with the help of coupling pulley. Lowering of pump motor set along with GI pipe nipples into the Bore well with the help of chain pulley block, ropes & skilled/unskilled labours. Providing/Fitting of MS bends 40mm dia. with MS flanges. Providing/Fitting of 40mm dia check valve and sluice valve -01no each with MS flanges, nut/bolts & washers, and interconnecting with the raising main with all allied welding work. Job includes providing/fitting of automatic sub control panel of suitable capacity (L&T make) & 4 mm square submersible cable -100 Double meter from motor to control Panel with proper thimbling & insulation. Complete job includes the cost of Testing & commissioning of submersible pump set, cost of material, carriage charges & labour charge at site.

Testing and commissioning of pumping Machinery and all other allied electromechanical works. Checking of all electrical connections, tapping and tightening all other connections. Plugging of leaking joints if any by way of welding, replacement of gaskets and tightening of nuts and bolts. Testing the machinery on full load. Complete job.

PERFECT ELECTRICAL WORKS

BEE AAR ENTERPRISES