Special repair of wall near Bldg No P-105 (New KLP) at Tank Chowk of Yol Cantt under AGE B/R-II of GE (KH) YOL

Amount

PART-I:- Demolition of brick work or stone/ boulder masonry built in cement mortar including all quoins arches, pillars including removal of debris to a distance exc 1.5 km but n.exc 2 km, complete all as specified and as directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc., complete all as specified and as directed.

Earth work in excavation any type of soil by mechanical means (Hydraulic excavator) means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5m, as directed by Engineer-in-charge.

Forming embankments including raising (or lowering) earth, spreading in layers n exc. 30cm thick; watering, ramming/rolling and finishing to required size, shape, etc., n exc. 1.5m high from base (solids), complete all as specified and as directed.

Forming embankments including raising (or lowering) earth, spreading in layers n exc. 30cm thick; watering, ramming/rolling and finishing to required size, shape, etc., exc 1.5m and n exc. 3m high from base (solids), complete all as specified and as directed.

Plain cement concrete M-10 nominal mix, C-2, using 40mm graded mechanically crushed stone aggregate as in foundation, filling and mass concrete, complete, all as specified.

TMT bars 10mm dia and over, cut to length, bent to shape required including cranking, bending, spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.

Reinforced cement concrete (design mix) M-20 (using 20mm graded crushed stone aggregate as in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete, all as specified.

Reinforced cement concrete (design mix) M-20 (using 20mm graded crushed stone aggregate as in retaining walls, basement walls, ballast walls and the like; any thickness; above top of footing, complete all as specified and directed.

Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter, for roughly finished flat surfaces of concrete, complete all as specified and directed.

Formwork to faces of walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc.; vertical or to batter rough finished surface of concrete, complete all as specified and directed.

PVC (SWR) pipes single socketed, in any length with rubber ring joints, as in weep holes/ fixed in retaining wall of bore 110mm low density of pressure rating 10 kg/sqcm, complete, including taking out old pipe, complete all as specified and directed.

Returning filling in including spreading, levelling, watering and well ramming in layers not exc. 25cm thick each layer of soil, complete all as specified and directed.

Wire netting of galvanised steel wire 1.40mm Size of mesh in 20mm dia fixed with tinned tacks of wire staples, complete all as specified and directed.

Supply only Coarse aggregates Granite, Trap or Basalt, grading l 40mm size, complete all as specified and directed.

Fly ash brick work with old size bricks having crushing strength not less than 75 Kg/Sqcm, straight or curved on plan exceeding 6 metre mean radius built in cement mortar 1:6 (1 cement : 6 coarse sand), complete all as specified and directed.

Rendering cement plaster 15mm thick in cement mortar 1:4 (1 cement : 4 coarse sand) in two layers (10mm thick first layer and 5mm thick second layer) on external fair faces of brick wall or on concrete surfaces, surface finished even and smooth without using extra cement, complete all as specified and directed.

Mild steel framed work such as grills, gratings, etc with ends of bars shouldered and/ or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed ballusters walk ways; railings; framework of water tanks and similar work conforming to Fe.290. Gde-E-165, complete all as specified and directed.

Applying two coats of synthetic enamel paint over a coat of red oxide on new steel or steel based surfaces of any description, exceeding 10cm width or girth including preparation of surfaces, complete all as specified and directed.

Two coats of cement base paint on newly plastered surface of walls including preparation of surface, complete all as specified and directed.

Excavation in trenches n exc 1.5 metre wide & n exc 1.5 metre in depth for foundation etc or for shafts, wells, cesspits manholes, pier holes, cable etc n. exc 10 Sqm on plan n exc 1.5 metre in depth and getting out in any type of soil, complete all as specified.

Plain cement concrete M-10 nominal mix, type C-1 using 20mm graded mechanically crushed stone aggregate as in surface channel and drains including necessary form work, complete all as specified and directed.

Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. For roughly finished flat surfaces of concrete, complete all as specified and directed.

Removing excavated material exc 250m but not exc. 500m and depositing where directed at a level not exc. 1.5m above the starting point, complete all as specified and directed.

Extra for forming fair finished drain or channel 30cm inner girth in cement concrete using extra cement including forms, moulds, mitred/stopped etc., complete all as specified and directed.

Add or deduct for each 25 mm girth or part thereof over or under 30cm ditto, complete all as specified and directed.

Removal of surplus soil to be distance n.exc 50m and depositing where directed at a level n.exc 1.5m high from the starting point, complete all as specified and directed.

Cutting of roads for laying of pipe of any size and repair to road cutting by providing soling with broken boulders or quarried stone and applying cold emulsion mixed with aggragate as per manufacturer's instructions including necessary compaction by rolling etc. complete all as specified and as directed by Engr-In-Charge. Note:- Pipe shall be measured and paid seperately.

Taking up or down 40/50mm bore, steel tubing and connections, including cleaning for refixing or removal from site, complete all as specified and directed.

Mild steel galvanised medium grade 40mm dia tubing with all fitting; laid in trenches, across road or on pole, complete all as specified and directed.

Gun metal, globe or gate valves, screwed down, high pressure with crutch or butterfly handle, screwed both ends for 40mm bore iron pipe or for unions and fixed in repair, complete all as specified and directed.

Drilling and tapping GI water mains (in position for branch connection of internal bore 40mm) including all fittings provision of clamps, nuts, bolts etc., complete all as specified and directed.

M/S AMOLAK SINGH AND SONS

MM Constructions

Ms Sunil Kumar

M/S VIG AND COMPANY