NIT-03/CHANGP/KRANTI/25-26/03

Cement concrete with 30mm graded shingles excluding shuttering in ground floor (a) 1:3:6 proportion (B) with NB varity (P-34,SL-22(II),PWD)

Hire charge of shuttering with centering and necessary staging up to 4m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs beams and columns lintels curved straight including fitting fixing and stricking out after complition of work (up to roof of ground floor) (a) 25mm to 30 mm thick hard wooden shuttering asdicision and direction of Eng-in Charge (PWD-Sl-36, P-42) (a) IN FOUNDATION

125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in ground floor.(PWD Building, P-16, SL-16)

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface], 1:4, 10mm (PWD Building-Page-189,SL-01)

Fitting Fixing Gate (MS Flat Bars)(a) M.S.or W.I. Ornamental grill of approved design joints continuously welded with M.S, W.I. Flats and bars of windows, railing etc. fitted and fixed with necessary screws and lugs in ground floor.(i) Grill weighing above 10 Kg./sq.mtr and up to 16 Kg./sq. mtr. (PWD Building P-105, Item No-16)

Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.( (This item is applicable to new work or old work when the original surface has been exposed by removal of old paint.))

Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary :(a) On timber or plastered surface :ii) Two coats (white in shade)

(c) 60 mm thick interlocking designer concrete paver block M-35 grade for light-traffic zone,commercial & office complex,tourist resort as per IS: 15658-2006 (over 20-40 mmmedium sand bed on 250mm thk WBM/ WMM base course &250 mm thk bound gnaular /granular sub-base course including cost of sand for sand bed but excluding cost of base ,sub-base course & subgrade preparation.) (PWD Building -Page-75, Item-48,C),(I) Colour and decorative

Installation of Child Friendly Play Equipment (Lumpsum)

Installation of concrete Precast Chair fitting fixing all complete at site

Dismantling all types of masonry excepting cement concrete plain or reinforced, stacking serviceable materials at site and removing rubbish as directed within a lead of 75 m. a) In ground floor including roof.(PWD Building-Page No-10, Item NO-1)

Earthwork in excavation from borrow pits (land owned/arranged by the Department) and depositing in layers of 250 mm. including breaking clods in embankment works and to fill up back of abutments, depressions and ruts with an initial lead up to 50 m and initial lift up to 1.5 m making bunds at top as directed dressing complete. (Borrow pit measurement) (PWR ROAD , PAGE-237, ITEM NO-3.01) (ii) In mixed soil (i,e. clay mixed with kankar, pebbles, moorum etc.)

P-265, I-8.07:-Providing & fixing Concrete Sign Board as per IRC specification of size 900 x 750 x 37 mm. thick made with RCC 1:1½:3 with pakur variety stone chips reinforced with double layer IRC febric (75 x 75 mm. mesh) and fixed with necessary nuts & bolts on two RC precast posts 100 mm. x 150 mm. of height 2.65 m. of which top 750 mm. is of section 100 x 13 mm. and 1.90 metre above GL & 0.75 metre below GL including digging hole, repacking the same with cement concrete 1:3:6 with jhama khoa or with local stone chips etc. complete including painting two coats on both faces lettering sign marks etc. as per direction of the Engineer-in-Charge. (The rate is inclusive of cost of reinforcement, concrete, shuttering, nuts & bolts, washer etc. complete.)

Add:- GST @ 18%

Add:- Labour Welfare Cess @ 1%