Deposit Work NRNM Beautification of Sakrani Mata Temple in Tehsil Dharampur Distt. Mandi HP

Amount

Excavation in foundation, trenches etc. in all kinds of soil such as pick work, jumper work, blasting work in soft / hard rock, chiselling in soft / hard including wedging out of a rock where blasting is prohibited and stacking the excavated earth up to all lifts, stacking the excavated soil up to all lead clear from the edge of excavation and then returniing the stacked soil in 15 centimeters layers when required in to plinths, sides of foundation etc. consolidating each deposited layer by ramming and waterng and then disposing of all surplus excavated earth as per direction and to the entire satisfaction of Engineer- in- charge up to leads and lifts.

Providing and laying cement concrete 1:4:8 (1 cement :4 sand :8 graded stone agg. 40mm nominal size) On curing complete excluding cost of form work in foundation and plinth in all lead and lifts as per direction and to the entire satisfaction of the Engineer-in-Charge.

Providing and laying cement concrete 1:2:4 (1 Cement : 2 Sand :4 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in:

Foundation and plinth complete as per direction and to the entire satisfaction of Engineer-in-Charge.

Lintels, beams, girders, bressumers and cantilevers upto floor two level within all lead and lifts as per direction and to the entire satisfaction of Engineer-in-Charge.

Column, pillar,posts and struts upto floor two level as per direction and to the entire satisfaction of Engineer-in-Charge.

Suspended floors roofs, landings and shelves and their supports, balconies, beams, girders, bressumers and cantilevers upto floor two level. as per direction and to the entire satisfaction of Engineer-in-Charge.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a fair finish including centring, shuttering strutting and propping etc. with wooden batten and ballies, in all heights of propping and centring below supporting floor to ceiling not exceeding 4 mtrs and removal of the same for insitu-reinforced concrete and plain concrete work in :-

Foundation, footings basis of columns etc. and mass concrete.

Flat surfaces such as soffit of suspeneded floors, roofs, landing like floors etc. upto any thickness

Beams, cantilever, girder and lintels sides and soffit of beams, beam hunchimg, cantilever, bressumers and lintels in any depth in all height from floor.

Columns, pillars, posts and struts Square, rectangular or polygonal in plan.

Providing laying of Tor steel reinforcement for RCC work including bending binding and placing in position including wire upto all floor level as per direction and to the entire satisfaction of Engineer-in-Charge.

Bhushan Sharma (BID ID -500210)

UDEY KUMAR (BID ID -500933)

Naveen Kumar (BID ID -500957)