General Fund

Supply and application of Thermo- Plastic Paint Supplying of hot applied thermoplastic road marking compound, 2.5mm thick including reflectorising glass beads @ 250 gms with Reflectorising Glass Beads on Bituminous Surface at 250 gms per Sqm area, thickness of 2.5mm is exclusive of surface applied glass bead as per IRC35, the materials should be of BERGER company/ BERGER equivalent and must comply with the following) White index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved Panel. In case of any major deviation, beyond acceptance limit. Department reserve the right to cancel or reject the total supplied consignment of the said material and will compell the vendor has to replace the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department) b) Luminance factor of the material should be in the range of 80-85% at 45 degree centigrade as per AASTHOM 249 c) Crack Resistance. The applied panel cured for 7 days under ambient condition and then should be tested as per BS3262, Part-1, 1989 and should pass at the range of 0 degree centigrade to 10 degree centigrade d) Adhesion: Strong. e) Softening Point : 102 Degree centigrade f) Dried film finish: Smooth and Uniform g) Night Vision: High as directed by the Engineer- in - Charge and confirming to IS: 164-1961 (1st revision reaffirmed in 1986) and clause confirming to IRC 35-1997

Providing and fixing of cautionary/warning sign of size 600 mm equilateral triangle made out of Type XI of ASTMD 4956-09 high intensity prismatic retro reflective sheeting confirming to IRC:67:2012 for full back ground of white colour and letters/logos done by screen printing in black colour ,boarders by screen printing in red colour and fixed over4 mm Aluminium coposite material sheet having minimum 0.5 mm thick aluminium skin on both sides with back side painted with grey colour and fixed over back support frame of 25 MM x 25 MM x 3 MMalround and fixing with 35 x 35 x 4MM mounted on a MS angle post 75 mm x 75 mm x 6 mm with clear heightof not less than 2.1 m from the ground level to the bottomof the board.The sign post should be painted with one coat of red oxide paint and 2 coats of synthetic enamelpaint Black and White colour with bands of 30 cm height.The sign post shall be firmly fixed with MS base angle 35 x 35 x 4 MM in to the ground by means of properly designed foundation with M15 grade cement concrete 45 cm x 45 cm x 60 cm, 60 cm below ground level as per approved drawing including cost and conveyance of all materials,equipment,machinery and labour with all leads and lift,loading charges necessary for satisfactory completion of the work as directed by the Engineer-in-Charge

(Curb Wall Paintings) Painting with two coats of water proof cement paint of apporved brand and shade over a base coat of approved cement primer grade II making making three coats in all to give an even shade after thoroughly brushing the surface to remove all dirt and remains of loose powdered materials, including cost and conveyance of all materials to work site, Scoffolding, Curing charges and all operational, incidental, labour charges etc. complete for finished item of work for external walls