M/o Road (Mastic work and Maintenance of Chauraha Intersection Connecting to Expressway on 45M wide Road Parallel to Expressway From sec-126 to 128) Noida

providing and applying tack coat hot straight run bitumen og grade 80/100 : on bituminious surface @ 0.50 kg/sqm

providing and laying danse graded Bituminous macadam with higher capacity batch type HMP using crushed aggregates of specified grading. Premixed with bituminous binder @4.5 percent by weight of total mix and filler, transporting the hot mix to work site, laying with Hydrostatic paver finisher with sensor contral to the required grade. level and alignment, rolling with smooth wheeled,vibratory and tandem rollers to achieve the desired compaction and density compaction as per MORTH specification, clause No.505 comlete in all respects.

providing and laying Bituminous concrete with higher capacity batch type hot mix plant using crushed aggregates of specified grading. Premixed with bituminous binder @5.4 percent of mix and filler, transporting the hot mix to work site, laying with Hydrostatic paver finisher with sensor contral to the required grade. level and alignment, rolling with smooth wheeled,vibratory and tandem rollers to achieve the desired compaction and density compaction as per MORTH specification, clause No.507 comlete in all respects.

Providing and laying C.C. pavement of mix M-25 with ready mixed concrete from batching plant. The ready mixed concrete shall be laid and finished with screed board vibrator , vacuum dewatering process and finally finished by floating, brooming with wire brush etc. complete as per cifications and directions of Engineer-incharge. (The panel shuttering work shall be paid for separately). (Note:- Cement content considered in this item is @ 330 kg/cum. Excess/less cement used as per design mix is payable/ ecoverable separately).

Providing and laying bitumen mastic wearing course (as per specifications) with industrial bitumen of grade 85/25 conforming to IS : 702 prepared by using mastic cooker and laid to required level and slope including providing antiskid surface with bitumen precoated fine grained hard stone chipping of approved size at the rate of 0.005 cum per 10 sqm and at approximates spacing of 10cm centre to centre in both directions, pressed into surface protruding 1mm to 4mm over mastic surface, including cleaning the surface, removal of debris etc. all complete. ( Considering bitumen using 10.2% as per MORTH specification .) 40 mm thick

Providing and fixing post delineators made of ABS round body fitted with 2 nos 100 mm dia high reflective reflectors and mounted on MS pipe of 65 mm dia duly powder coated anti-rust and anti theft steel to be installed as per direction of Engineer-in-charge.

providing wall putty on new surface with approved quality material of berger/ Jk/ birla or similar make 2 coats

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade :Two or more coats on new work

Construction of granular sub-base by providing close graded Material, mixing in a mechanical mix plant at OMC, carriage of mixed Material to work site, spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to achieve the desired density, complete as per clause 401

Road Marking with hot applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface. Providing and Laying of hot applied thermoplastic compound 2.5mm thick including reflectorising glass beads @ 250gm per sqm area, thickness of 2.5mm is exclusive of surface applied glass beads as per IRC:35-2015 The finished surface to be level, uniform and free from streaks and holes.