Estimate For Linking of sangatpura Distributory RD 51040 with Pond at Village Sadarpura Dist Ludhiana

Earth work in excavation in foundations trenches etc. in all kinds of soil where Pick-Jumper work is not involved and not exceeding 2.0 metres depth including dressing of bottom and sides of trenches, stacking the excavated soil clear from the edge of excavation and subsequent filling around masonry in 15 cm, layers with compaction including disposal of all surplus soil as directed within lead of 30 metres.

Excavation by mechanical means(JCB or Hydraulic excavator) in trenches for pipe lines with straight or open cutting in streets or open area including trimming and dressing sides levelling of beds of trenches to correct grade, cutting joint holes, refilling consolidation,watering , including the cost of dewatering of rain water, diversion for traffic, night signals. providing & fixing caution boards, crossing over trenches for access to the houses, watching, fencing, etc. and removal of surplus soil out side/inside the town involving lead upto 15 meter complete in all respect.Earth work upto 1.5 m Depth for

Cement concrete 1:4:8 with stone aggregate 40mm gauge mixing by mechanical means using concrete mixer volumetric type

Cement concrete 1:2:4 with stone Ballast or Shingle mixing by mechanical means using concrete mixer volumetric type

First class burnt brick work laid in cement sand mortar 1:6 in foundation and plinth

10mm thick Cement Plaster 1:4

10mm thick Cement Plaster 1:4 on floors

RCC work hand mixed 1:2:4 for slab including Steel Reinforcement upto 60 kg per cum

Centering and shuttering for flat surfaces such as suspended floors, roofs, landings, chajjas,shelves etc.

Supply of RCC NP-2 pipes of 250 mm i/d pipe as per rates of controller of Stores

Lowering in trenches to correct gradient and alignment,jointing into trenches for all depths and laying out the same to correct alignment, gradients, levels etc.

Providing & fixing C.I/D.I Flanged end, stem of SS (AIS 1410) and Bronze(gunmetal) working parts Sluice Valves ISI marked 14846-2000, including jointing , testing & cost of Nut ,Bolt & insertion sheet, all carriage complete (with the approval of Engineer incharge) Class PN-1.6 as per ISI 250 mm i/d Sluice Valves flanged

Supply & installation of Flowmeter 250mm dia Mechanical type

Foot Rest for Manhole. Providing orange colour safety footrest of minimum 6mm thick plastic encapsulated as per IS:10910 on 55.00 29-35-1 12mm dia steel bar confirming to IS: 1786 having minimun cross section as 23mm x 25mm and over all minimum length 263mm and width as 165mm with minimum 112mm space between protruted legs having 2mm tread on top surface by ribbing or chequering besides necessary and adequate anchoring projections on tail length on 138 mm as per standard drawing and suitable to with stand the bend test and chemical resistance test as per specification and having manufacturers permanent identification mark to be visible even after fixing, including fixing in manholes with 230x150x75cm cement concrete block 1:2:4 (1 cement: 2 sand: 4 stone aggragate) complete as per design.