204/2425 MINI MCF CONSTRUCTION OF KADAMPANAD GP

Amount

Mini MCF

2.8.1:Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes

10.25.1:Item Shifted to Sub head 14 as item 14.73 Item Shifted to head 14 as item 14.74 Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.In stringers, treads,landings etc. of stair cases, including use of chequered plate wherever required, all complete

OD406624/2023-2024:Providing and fixing Aluminium powder coated profile sheet ( size, shape and pitch of corrugation as approved by engineer incharge) 0.40 mm ( + 0.05%) . Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12 m as directed by Engineer incharge. The sheet shall be fixed using self drilling/ self tapping screws of size ( 5.5 x 55 mm ) with EPDM seal complete up to any pitch in horizontal/vertical or curved surfaces excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required

OD406625/2023-2024:Providing and fixing aluminium sheet roofing accessories 0.40mm (+0.05%) and polyester top coat 15 - 18 microns using self drilling/ self tapping screws complete Ridge plain (500 - 600 mm)

13.52.1:Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturer's specifications including appropriate priming coat, preparation of surface, etc. complete.On steel work

KAMARUDEEN N

Bidder Name

KAMARUDEEN N

SHIBUKUMAR S