Restoration of rain damages to FIS Raugi in G.P. Raugi in Tehsil Distt. Kullu HP

Excavation in foundations, trenches etc.in all kind of soil in all leads and lifts such as pick work, jumper work in saturated/unsaturated soil including bailing out water, blasting work in hard/ soft rock or chiseling in hard/soft rock where blasting is prohibited in all lifts stacking the excavated earth not more than 3 mtrs clear from the edge of excavation and then returning the stacked soil in 15 cm layers when required into plinths sides of each deposited layer by ramming and watering and then disposing of all surplus excavated earth foundations etc., consolidating as directed within all leads and lifts and handing over the useable materials available from excavation to department free of cost to the entire staisfaction of Engineer-in-charge with in all leads and lifts.

Providing, laying, jointing and testing of HDPE pipes in trenches to required grades as per IS: 4984-1995 latest with up to date amendments of following OD pipes, material grade and class of pipes. The jointing of pipes should be done by way of butt fusion welding as per relevant IS code and specifications including all fittings and accessories complete in all respect.

90mm dia PE-80, PN-6.0

75m dia PE-80, PN-6.0

Providing and laying cement concrete 1:5:10 (1 cement: 5 sand: 10 graded stone aggregate 40mm nominal size with 15% plum and curing complete excluding the cost of form work in retaining wall/ breast wall. The size of plum shall usually be 150mm to 300mm as per HPPWD specification in all respect and as per direction and to the entire satisfaction of Engineer-in-charge.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5 mm so as to give a rough finish including centering shuttering and propping etc. Height of propping and cetering below supporting floor to seiling not exceeding 4 mtrs and removel of th same for the same for in situ reinforcement concrete and plain concrete concrete work including all leads and lifts.

Vertical surface such as walls (any thikness) portions and the like including attached pilaster buttersses plinth and stiring course and the like

Providing and fixing double flanged Cast Iron Sluice valve of follwing dia PN-1.0 of Leader/Kirloskar/Kilburn/Kartar/all approved make conforming to as per IS: 14846-2000 with MS flanges IS: 6392-1971 with hand wheel (and other accessories) with upto amendment as per class PN-1.00 to with standing nominal seat pressure of 10.00 Kg/cm2 flange table-5 including welding of MS flange in two layer i/c carriage in all leads & lifts as per direction and to the entire satisfaction of Engineer-in-Charge.