DEPOSIT RWSS PANAYAM Commissioning of Newly drilled Tube well at Panayam FHC Compound General Civil Work

Amount

Maintanance of existing Pump house , Bleaching powder room and Chlorine tank facility

50.6.1.4:Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand ) etc complete

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III)derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources)

13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

50.10.1:Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting,fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

50.10.2:Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

12.1.2:Providing corrugate G.S. sheet roofing including vertical/ curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete ( up to any pitch in horizontal / vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.0.80 mm thick with zinc coating less than 275 gm/m2

OD217237/2024-2025:Wiring the pump house and Providing 4 nos light point, 1 nos Fan point, 1 nos Exhaust fan point, 1 nos 16 Amps power socket and 1 nos CCTV point etc wiring the pump house using best quality copper wire with pvc pipe and fitting switches, sockets etc in two switch board and supply and fitting 2 nos. 20 w CFL bulbs, 2 nos LED tube set, 1 no. sealing fan,1 nos exhaust fan best quality as per IE rules.

OD223073/2024-2025:Supply of Steel Table and Plastic Chair

10.28:Providing and fixing stainless steel (Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete, i/c fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer-in-charge, (for payment purpose only weight of stainless steel members shall be considered excluding fixing accessories such as nuts, bolts, fasteners etc.)

Automation arrangement and KSEB Power allocation charges

OD217242/2024-2025:Installation charge for submersible pump controller kit., Supply of SIM , SIM kit and including plan for one year

OD217243/2024-2025:Supply and fixing M POWER module

OD221676/2024-2025:Supply and installation of 5 MB CC TV ( 5 MP Bullet motion sensor camara -2 nos) including 1 TB SATA 3.5 Inch Desktop Surveillance Internal Hard Disk Drive, necessary cables for connection , 4 channel DVR (5MP), PVC box HDMI cable, channel SMPS for CCTV output, Power Supply Adaptor for upto 4 CCTV cameras, Coaxial Pure Copper CCTV camara cable, 3/4g SIM Router, Stabilizer, UPS 500VA, providing plug point and switch for electric connection, including labour charges etc. Compleat as per direction of departmental officers ( Condition including 3yr product warranty plus on site service)

OD222880/2024-2025:Supplying First Aid Kit Class B, As per factory act 1948

OD228507/2024-2025:Supply of spare L&T MPowerPro, electric tester & safety mat and gloves

Supply and errection of Pump set

OD217238/2024-2025: Supply, erection, testing and commissioning of Brand new Submersible pump set (7.5HP) discharge 250lt/m having ISI mark with suitable motor having sufficient discharge in accordance with the yield of the tube well and against a total head as instructed by the deptl officers, with bronze impellers, SS316 shaft etc working in 3 ph AC main as per IS specification with minimum efficiency of 70% . The rate quoted inclusive of 5m , 80 mm GI B class pipe and specials, 5m 4 sq.mm cable, switch fuse unit rated 100 amps 415 volt of approved manufacturers , fully automatic star delta starter of approved manufacturers , interconnection of outlet with existing distribution line using suitable specials, earthing by using suitable copper wire/plate, supply and fixing standard type floor mounted panel board, supplying copper cable of required length and size, providing cable connection from pannel board to starter and starter to motor etc, supply<br>and fixing suitable type CI D/Sluice valve , reflux valve, pressure gauges, power capacitor(7.5kvr), single phase and dry<br>running preventors, earthing main switch board with all units as per IE Rules, hire for tools, supply of required rope, supplying of best quality floor rubber mat 3 ft x 1 ft 10mm min thikness, supplying ,fabricating and<br>fitting meter box as per KSE I rules for fixing the meter & fuse unit of KSEB etc complete as per the direction of<br>departmental officers.

OD217239/2024-2025: Supply of Brand new stand by Submersible pump set (7.5HP) having ISI mark with suitable motor having discharge of 250 LPM against a total head of 100 Mts with bronze impellers, SS316 shaft etc working in 3 ph AC main as per IS specification with minimum efficiency of 70% .

OD217240/2024-2025:Supply of 80mm UPVC column pipe including coupling

OD217241/2024-2025:OVER VOLTAGE RELAY

OD221272/2024-2025:Supply of best quality 3 core 4 sq.mm flat copper cable for erection work.

OD222122/2024-2025:Supply of Spare MU-G20 fully automatic star delta starter for automation .

23.12:Development of tube well in accordance with IS: 2800 (Part I) and IS : 11189, to establish maximum rate of usable water yield without sand content (beyond permissible limit), with required capacity air compressor, running the compressor for required time till well is fully developed, measuring yield of well by "V" notch method or any other approved method, measuring static level & draw down etc.by step draw down method, collecting water samples & getting tested in approved laboratory, i/c disinfection of tube well, all complete, including hire & labour charges of air compressor, tools & accessories etc., all as per requirement and direction of Engineer - in-charge.

PUMPING MAIN AND ALLIED WORKS

100.1.1:Excavating trenches of required width for pipes, cables, etc., including excavation for sockets, and dressing of sides, ramming of bottoms, depth up to 1.5m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20cm in depth, including consolidating each deposited layer by ramming, watering, etc., and disposing of surplus excavated soil as directed, within a lead of 50m, in all kinds of soil.

100.9.9:Laying uPVC pipes of class 2 to class 6 and specials, lowering to the trenches already made, placing in position aligning the pipeline to the lines and levels and jointing the pipes and specials with solvent cement and testing the pipeline with water to the required test pressure (excluding cost of pipes and specials): 110 mm nominal outside diameter pipes.

100.9.6:Laying uPVC pipes of class 2 to class 6 and specials, lowering to the trenches already made, placing in position aligning the pipeline to the lines and levels and jointing the pipes and specials with solvent cement and testing the pipeline with water to the required test pressure (excluding cost of pipes and specials): 63 mm nominal outside diameter pipes.

100.98.214:Supply of PVC Pipe, 6kg/cm2, 110mm Dia.

100.98.211:Supply of PVC Pipe, 6kg/cm2, 63mm Dia.

OD224691/2024-2025:Interconnecting existing 90mm pvc pipeline to the newly laid pipeline of 90mm after tracing out existing line, cutting and joining with specials

100.98.428:Supply of CI Non Return Valve, Conforming to IS 5312 Part I - 1984, PN 1.6, Size 80mm.

100.98.457:Supply of CI Double Flanged Sluice Valve Conforming to IS 14846 - 2000, Sluice Valve with Cap PN 1.6, Size 80mm.

100.98.505:Supply of CI Plain End Valve Conforming to IS 14846 - 2000, Sluice Valve with Cap PN 1.6, Size 80mm.

100.98.508:Supply of CI Plain End Valve Conforming to IS 14846 - 2000, Sluice Valve with Cap PN 1.6, Size 150mm.

CHLORINATION ARRANGEMENT

OD217244/2024-2025:Providing chlorinator arrangements to the tube well pump house by supplying and fixing1 no synthetic PVC tanks of 500 litre capacity with the platform outside the pump house and supply and erecting 1 HP special type Centrifugal pump with all accessories suitable to pump bleaching powder solution connecting to the 80mm GI pumping main near the well including cost of all materials labour charges etc complete.

SANIL S (BID ID -2423678)

SANTHOSHKUMAR.S (BID ID -2422940)

THAHA.H (BID ID -2422976)

LIJEESH V (BID ID -2423751)

Bidder Name

SANTHOSHKUMAR.S

S.Shaji

SANIL S

LIJEESH V

THAHA.H