Kallakurichi District Ulundurpet Block Construction of Panchayat Office Building at Sikkadu Panchayat

Amount

Construction of Panchayat Office Building @ Sikkadu

EARTHWORK EXCAVATION for foundation in all soils and sub soils and to full depth as may be directed except in rock requiring blasting but inclusive of shoring, strutting and baling out water wherever necessary and refilling the sides of foundation with excavated earth in layers of not more than 15cm thick, well rammed and consolidated and depositing the surplus earth within the compound in places shown by the departmental officers with initial lead and lift etc.,including levelling the sites complete complying with standard specifications and as directed.

Supplying and filling in with Gravel for basement including ramming, watering and compacting etc.complete complying to standard specification

CEMENT CONCRETE 1:4:8 mix using 40mm gauge hand broken hard granite stone jelly for FOUNDATION including dewatering if found necessary and laid in layers of not more than 15cm thick, well rammed etc., complete complying with standard specification.

BRICK WORK in cement mortar 1:5 (One cement and five sand) using second class country bricks of size 23cm x 11cm x 7cm for the following including curing etc., complete complying with standard specifications. (Masonry projections wherever necessary for obtaining required elevation shall be done without extra cost).

Supplying and erecting CENTERING for sides and soffits including supports and strutting upto 3.29 m high for plane surfaces such as RCC SLABS, RECTANGULAR BEAMS, TEE or ELL BEAMS, LINTELS, BED BLOSKS. STAIRCASE WAIST and landing slabs, landing beams, canopy etc., in all floors with all cross bracings using mild steel sheets of size 90cm * 60cm and BG 10 stiffened with welded mild steel angles of size 25mm * 25mm * 3mm for boarding laid over countrywood joists of size 10cm * 6.50cm spaced at about 90cm centre to centre and supported by Casuarian props of 10cm to 13cm dia spaced at 75cm centre to centre etc., complete and as directed.

Centering below Ground level

Rate for column post

Rate for roof slab, lintel, beam

Rate for Sunshade

Supplying, fabricating and placing in position mild steel/Ribbed tor steel rods for all RCC works including cost of steel and binding wire also in all floors, complete complying with standard specfication.

Reinforced CEMENT CONCRETE 1:1.5:3 mix using 20mm machine crushed 20mm gauge hard broken granite stone jelly for all reinforced cement concrete works connected to this work excluding cenetering, shuttering and cost of reinforcement grills placed in position, but including laying, vibrating, curing and finishing, fixing fan clamps in the RCC floor and roof slab works wherever necessary and bearing surfaces of the wall at the sides and bottom of the slab, beams shall be finished smooth with cement mortar 1:3 (One cement and three sand ) and Kraft paper laid without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers.

PLASTERING with cement mortar 1:5 (one cement and five sand)12mm thick in all floors complying with standard specifications.

SPECIAL CEILING PLASTERING and finishing all the RCC exposed surfaces such as RCC slabs, sunshades, canopies, staircase steps, landing slabs, etc. with cement mortar 1:3 (one cement and three sand) 10mm thick and including hacking the surfaces and providing necessary cem,ent mortar nosing beading as per size, specification wherever necessary using the same mix as directed by the departmental officers etc.,complete complying with standard specification.

Granolithic floor finish in cement mortar 1:2:4 using 12mm chips thick and pointing with same colour including cost and conveyance of all materials to site and all labour charges etc com

Terrace flooring with one course of pressed tiles size of 20 x 20 x 2cm using CM1:3 mixed with crude oil 10% by weight of cement and pointed with cement mortor 1:3 over one coarse of Brick jelly lime concrete of 75mm average thick etc., complete

Paving the Floor with best quality Ceramic Tiles of Size 600 mm x 600 mm of approved colour, shade and quality laid in cement mortor 1 : 3 (one cement and three sand ) 20 mm thick in all floors and the top pointed with the white cement mixed with same colouring Pigments and as directed by the departmental officers etc complete complying with standard specification

Paving the Floor with best quality Anti Skid Tiles of Size approved colour, shade and quality laid in cement mortor 1 : 3 (one cement and three sand ) 20 mm thick in all floors and the top pointed with the white cement mixed with same colouring Pigments and as directed by the departmental officers etc complete complying with standard specification

Dadooing of walls with colour glazed tiles of size 300x200x6 mm of best qualityincluding cost and conveyance of all materials to site and all labour charges etc complete.

Supply of Mild Steel Door of size 1.10 m x 2.10 m with Two leaf. Outer frame o f40 x 40 x 6 mm equal MS Angle , Shutter frame made of 35 x325 x 5 mm equal MS Angle for horizontal and vertical members and the shutter frame strengthened by stiffners of one horizontal for each shutter using MS Plate of size 20 x 5 mm fully covered with 18 Gauge plain MS full sheet welded with shutter frame neatly and also fixin by welding ,Tower Bolts 30 cm long , Butt Hinges two nos of locking handles fixing the shutter including painting the whole unit with one coat of best quality red oxide Primer .

Supply of Rolling Shutter of size 1.20 m x 2.10 m with frame and locking arrangements etc complete

Supply of Mild Steel Door of size 0.75 m x 2.10 m with Two leaf. Outer frame o f40 x 40 x 6 mm equal MS Angle , Shutter frame made of 35 x325 x 5 mm equal MS Angle for horizontal and vertical members and the shutter frame strengthened by stiffners of one horizontal for each shutter using MS Plate of size 20 x 5 mm fully covered with 18 Gauge plain MS full sheet welded with shutter frame neatly and also fixin by welding ,Tower Bolts 30 cm long , Butt Hinges two nos of locking handles fixing the shutter including painting the whole unit with one coat of best quality red oxide Primer .

Supply of Mild Steel Window of size 1.20 m x 1.30 m with Two leaf. Outer frame of 35 x 35 x 5 mm equal MS Angle , Mullion section made of 35 x 35 x 5 mm equal Tee section , Shutter frame made of 25 x 25 x 5 mm equal MS Angle for horizontal and vertical members and the shutter frame strengthened by stiffners of one horizontal for each shutter using MS Plate of size 20 x 5 mm fully covered with 18 Gauge plain MS full sheet welded with shutter frame neatly and also fixin by welding , protective grill with 12 mm square M S rods at an interval of not greater than 10 cm centre to centre to the outer frame , two nos peg stays with hole for keeping the windows open in different positions , two nos of locking handles fixing the shutter with four nos of hinges hold fasts , six nos of hinges with outter frame of the window including painting the whole unit with one coat of best quality red oxide Primer .

Supply and fabrication of Steel Grill Gate of over all size of 1.50 m x 2.10 m using structural steel etc complete in all respects as directed

Supply and Fixing of Rcc Jolly of size 0.60 m x 0.45 m including cost and labour charges etc complete

Supply and fixing of Cuddappa slab including cost and conveyance of cuddappa slab and labour charges for fixing etc, complete

Distembering one coats with best approved oil bound distember including cost of painting priming coat over new plastered surface and conveyance of all materials to site and all labour charges

Painting Two coat approved cement paint over the plastered surface including cost and all other charges etc.,

PAINTING NEW IRON WORKS for doors, windows and Ventilators, Iron bars, Weldmesh, wiremesh, screen, steel bars, flats and other similar works etc., with TWO COATS of approved first quality of synthetic enamel paint over the existing red oxide primer in all floors. The rate is inclusive of cost of all materials and labour, brushes and scaffolding charges etc., complete complying with standard specification. (The paint to be used should be got approved by the engineer before use on work.

Provision for Rain water arrangements

Suppling and fixing in position of Indian Water Closet Coloured of size 580 mm x 440 mm , white Glazed earthen ware of approved quality with P trap or S trap confirming to is:2556 - Part XII with sand cushion and forming the closet using 40mm broken jelly lime concrete etc complete

Suppling and fixing in position of European Water Closet Coloured with " P " or " S " Trap with Double Flapped seat and seat cover with Brass Hinges and 10 Litre capacity PVC Low level Flushing Tank with all internal fittings of size 580 mm x 440 mm , white Glazed earthen ware of approved quality with P trap or S trap confirming to is:2556 - Part XII with sand cushion and forming the closet using 40mm broken jelly lime concrete etc complete

Supply and Fixing of Coloured Wash Hand Basin with Pedestal of Size 550 mm x 400 mm with all accessories such as cast iron Brackets , 32 mm dia CP Waste coupling , rubber plug and chain , 32 mm dia " B " Class G I waste pipe, 15 mm dia GM wheel valve , 15 mm dia nylon connection , 15 mm dia brass nipples , 15 mm CP . Pillar Tap etc complete .

Hand Rails Stainless Steel by Manufacturing , Suppying and Fixing of Stailess Steel Hand Rails for staircase near wet riser using 50 mm dia 304 L Grade Stainless Steel pipe of 1.60 mm thick will be provided with Tubular supports made of 304 L Grade Stainless Steel pipe of 25 mm dia of 1.60 mm thick welded to the railing. The supports will be grouted into the wall and provided with 93 mm thick Stainless Steel Circular base plate of 304 Grade . the rate shall included for Grouting into concrete with necessary supporting arrangements the Hand Rail in Floor polishing buffing ,bonding , cutting , grinding , conveyance welding charges , electrical charges etc complete .

)Wiring with2*1.5 mm2 (22/.3) pvc insulated unsheathed sc Cu . Conductor of 1100 v grade in suitable PVC ridged pipe on wall and ceiling with PVC accessories with tw switch box inflush with wall covered hylum sheet of 3 mm thick with painting of suitable

Wiring with2*1.5 mm2 (22/.3) pvc insulated unsheathed sc Cu . Conductor of 1100 v grade in suitable PVC ridged pipe on wall and ceiling with PVC accessories with tw switch box inflush with wall covered hylum sheet of 3 mm thick with painting of suitable

Supply and fixing CFL light fittng and all labor charges tc complete

Supplying and fixing of 16AMS DPI Switch of 500volt with fuse and Neutral (side handle) on suitable TW/PWD Earthing SD135 Service main

Supply and runoff 2 of 6 mm2 (84/0.3) pvc insulated SC unsheathed Cu.conductor of 1100 v on 7/20 Gi bearer wire for service connection main

)Supply and runoff 2*1.5 mm2 PVCinsulated SC unsheathed Cu.conductor of 1100 V garde in 25 mm dia GI pipe (class B) suitably bent at both end with necessary angle iron upright and end support for mains .

Supply and fixing of water tight Bulk head fitting with guard suitable for incandascent bulb

Supplying and fixing of 1200mm(40")AC Ceiling fan with stepped electronic 300W regulator with 1m down rod on the existing clamp

TNEB meter

Provision for EB Service Connetion

Provision for Rain water Harvesting structure

Providing Name board including Painting and lettering etc complete.

Provision for photograpic charges

Provision forQCC 1

Provision for GST , 18%

SURUTHI ENTERPRISES (BID ID -1306013)