Improvement of perifery road of Banamalipur Dighir Par inc Connected road SH Development of road by providing BM, BC etc

Maintenance of Earthen shoulder (filling with fresh selectedsoil) Making up loss of material / irregularities on shoulders tothe design level by adding fresh approved selected soil andcompacting it with appropriate equipment at OMC upto alead of 1000 m as per MoRT&H technical specificationClause 3003

Maintenance of Earthen shoulder (Stripping of excess soil)Stripping excess soil from the shoulder surface to achievethe approved level and compacting with plate compactor atOMC as per drawing and MoRT&H technical specificationClause 3003.

Prime Coat Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.90- 1.20 kg/sqm using mechanical means as per MoRD Technical Specification Clause 502

Tack Coat Providing and applying tack coat with bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.30 to 0.35 kg per sqm on the prepared non-bituminous surfaces (cement concrete pavement) cleaned with Hydraulic broom as per MoRD Technical Specification Clause 503.

Bituminous Macadam Providing and laying bituminous macadam with hot mixplant using crushed aggregates of grading as perTable500.4 premixed with bituminous binder, transported to siteupto a lead of 1000 m laid over a previously preparedsurface with paver finisher to the required grade, level andalignment and rolled to achieve the desired compaction asper MoRD Technical Specification Clause 504 i. With Viscosity Graded Bitumen of VG-30

Providing and laying bituminous concrete with higher capacitybatch type hot mix plant using crushed aggregates of specifiedgrading, premixed with bituminous binder @ 5.40 Percent of mixand filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the requiredgrade, level and alignment, rolling with smooth wheeled,vibratory and tandem rollers to achieve the desired compaction asper MORTH specification clause No. 507 complete in all respects. Greading-II

Maintenance of bituminous surface road Repair to pot holes by removal of failed material, trimming the sides to vertical and levelling the bottom, cleaning the same with compressed air or any appropriate method, filled with 75 mm B.M, after applying bitumen emulsion prime coat at the bottom and bitumen emulsion tack coat on sides and on bottom as per MoRD technical specification Clauses 1900, 502, 503 and 504.

Road marking strips (retro-reflective) of specified shade/colour using Hot Applied Thermoplastic material withProviding and applying 2.5 mm thick thick road markingstrips (retro-reflective) of specified shade/ colour using hotthermoplastic material including reflectorising glass beads@ 250 gms per sqm area by fully/ semi automaticthermoplastic paint applicator machine fitted with profileshoe, glass beads dispenser, propane tank heater andprofile shoe heater including cost of cleaning the roadsurface of all dirt, seals, oil, grease and foreign materialetc, thickness of 2.5 mm is exclusive of surface appliedglass beads as per IRC:35. The finished surface to be level,uniform and free from streaks and holes as per MoRT&HTechnical Specification Clause 803.Reflectorising Glass Beads on Bituminous Surface