Pavement marking with hot applied thermoplastic paints, fixing of cat eye, bump ahead sign ;boards and CR base road marking paint at different roads of isanpur ward

Name of Work: Pavement marking with hot applied thermoplastic paints, fixing of cat eye, bump ahead sign ;boards

and CR base road marking paint at different roads of isanpur ward

It.No. Qty Item Description Rate Unit Amount

1 7250.00 Road marking with hot applied thermoplastic 364.08 Smt

paints with reflectorising glass beads on bitumin

surface providing and laying a hot applied

thermoplastic compound 2.5 mm thick including

reflectorising glass beads @ 250gms per sqm area,

thickness of 2.5mm is excluding of surface applied glass

beds as per IRC:35-2015. The finished surface to be level,

uniform and free from streaks and holes.zebra patta

/bump patta lane/center line/ edge line/cut patta. The

white color marking should provide liminance coefficinet

on cement road shall be min 130 mcd/m2/lux and

Asphalt road shall be min100mcd/m2/lux during the

service life during the daytime.The marking should

meet the performance criteria for night time

reflectivity,wet reflectivity and skid resistance as

mentioned in the section-15of IRC35-2015.Warranty for

the Retro reflectivity should be two years.

2 250.00 Road marking with hot applied thermoplastic paints with 512.95 Nos.

reflectorising glass beads on bitumin surface providing

and laying a hot applied thermoplastic compound 2.5 mm

thick including reflectorising glass beads @ 250gms per

sqm area, thickness of 2.5mm is excluding of surface

applied glass beds as per IRC:35. The finished surface to

be level, uniform and free from streaks and holes.)

Directional Arrow, Lettering. (AMC approved rate)

3 1718.00 Cat Eye/ Road Stud/ RPM: Supplying of Molded Twin 323.00 Nos.

Shanks Raised Pavement Markers made of polycarbonate

and ABS moulded body and reflective panels with micro

prismatic lens (No glass bed lens) capable of providing

total internal reflection of the light entering the lens face

and shall support a load of 13635 kgs .tested in

accordance to ASTM D 4280 Type Hand complying to

Specifications of Category A of MORTH Circular No

RW/NH/33023/10-97-DO III Dt 11.06.1997 .The height,

width and length shall not exceed 20 mm, 130 mm and

130 mm and with minimum reflective area of 13 Sqcm on

each side and the slope to the base shall be 35 +/-

degree.The strength of detachment of the integrated

cylindrical shanks, (of diameter not less than 19 +/- 2mm

and height not less than 30 +/-2 mm) from the body is to

be a minimum value of 500 Kgf. Fixing will be by drilling

holes on the road for the shanks to go inside,without nails

and using epoxy resin based adhesive as per

manufacturers recommendation and The color of the

marker should be as per the IRC35-2015 and as directed

by Engineer-in-charge. (R & B SOR 2021-22 Item No.

Contractor’s Quoted Rate: -

…………………………..% Above OR % Below

Seal and Signature of the Bidder Addl. City Engineer

Date: (South Zone)