Fabrication of Holding plate and blade linkages of Fixed Blade 90 HP Sonalika Make Old.

Amount

Fabrication, Providing and fitting of lower linkage assy. on which up-down hydraulic cylinder is attached. The size of the linkage is 37” by 24”. The linkage has to be fabricated out of 10mm thick plate with 18” by 37” plate on top side and reinforced with struts on lower side. Three number of struts of width 3”, length 31” and thickness 10mm have to be welded on lower side of plate to thwart the bending by up-down movement of hydraulic jack. Four number of struts of width 3”, length 24” and thickness 10mm have to be welded on shorter side of the plate on edges with spacing of 2.5” between two struts on either side. Both the ends of every strip of have to be drilled with 25mm Ø hole. Also, a U-joint fabricated out of 10mm thick plate with 30mm Ø hole is to be welded at the top side of the linkage just opposite to middle strip with height of 3” and base welded to plate of 4” long. After fabrication, the unit has to be painted with red oxide and two coats of branded enamel metallic coats. Complete job including SS Pins 4 Nos. as per sample. Weight of MS Required 63Kgs approximately.

Fabrication, Providing and fitting of road surface harmonizing linkage (H-Shaped) fixed between blade assy. and parallelogram linkage out of 125 mm/65mm/6mm C-channel with running length of channel 7’ and 8mm thick 4” by 4” five numbers plates with 25mm by 65mm slots diagonally. Also triangular cleats out of 10mm plate with base and altitude of 4” are to be welded at joints of channel. After fabrication, the unit has to be painted with red oxide and two coats of branded enamel metallic coats. Weight of MS Required 41 Kgs approximately.

Fabrication and fixing of tool box out of MS 3mm Plate with dimensions of 609mm / 457 mm / 457 mm and 40mm / 40mm / 4mm angle. The job includes providing fitting of hinges, handles & locking arrangement. The job also includes applying red oxide and two coats of branded enamel metallic coats. Complete Job. Weight of MS Required 51Kgs approximately.

Fabrication, Providing and fitting of upper linkage as per sample from 3mm thick plate. The two sides of plate are to be made in cylindrical shape in which inner threaded sleeve fits. After fabrication, the unit has to be painted with red oxide and two coats of branded enamel metallic coats. Complete Job. Weight of MS Required 23Kgs approximately.

Fabrication, Providing and Fitting of Blade Holding Plate out of 12mm Thick Plate with Dimensions 40” by 24”. The plate is to be welded with Two number Trapezoidal Shaped Extensions of parallel sides 20” & 8” and height 30” out of 12mm thick plate. Each extension is to be drilled with six number of holes with diameter of 20mm, so that blade holding plate could be fixed with chassis girders. The job also includes providing and fitting 12 Nos of 19mm dia nut and bolts with washers. After fabrication, the unit has to be painted with red oxide and two coats of branded enamel metallic coats. Complete Job. Weight of MS Required 130 Kgs approximately.

IMPERIAL MOTORS

M/S MEHRAJ AUTOMOBILES

M/s SIMAR ENTERPRISES

M/s Sopore Engineering Works