Project no220/26- Construction of women wellness centre

MAINTENANCE WORK

2.32:Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared.

2.8.1:Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.4:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (1 Cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 40 mm nominal size derived from natural sources)

10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes

10.16.2:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished seamless type tubes

OD443246/2025-2026:Providing and fixing precoated galvanised iron profile sheets ( size , shape and pitch of corrugation as aprroved by Engineer in charge ) 0.35 mm (+0.05%) total coated thickness with zinc coating 120 grams per sqm as per IS:277 in 240 mpa steel grade 5-7 microns epoxy primer on both side of the steel and polyster top coat 15-18 microns . Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12 m or as desired by Engineer in charge . The sheet shall be fixed using self drilling / self tapping screws of size (5.5x 55 mm ) with EDPM seal complete up to any pitch in horizontal / vertical or curved surfaces , excluding the cost of purlins , rafters and trusses and including cutting to size and shape wherever required

OD476890/2025-2026:Supplying & fixing half spit PVC Gutter160mm size with M S Flats 200*5mm size @60 cm c/c fixing on roof members(purlin & rafter) ,bolts,nuts & washers etc including making necessary connections with rain water pipes complete.

OD476893/2025-2026:Engaging man & mazdoor