PROVN OF GDCC AND QRT REST ROOM ALONG WITH

Amount

NOTE: Schedule ‘A’ Part I to XI under Ser No. 1.00 to 10.00 here in after are Prepriced by MES. Bidders shall insert their lumpsum amount in the Green coloured field under Col-6 only.

Lump sum price worked out for BUILDING/ STRUCTURE as listed in Sch 'A’ Part I.

Lump sum price worked out for EXCAVATION & EARTH WORK as listed in Sch 'A’ Part II.

Lump sum price worked out for INTERNAL WATER SUPPLY as listed in Sch 'A’ Part III.

Lump sum price worked out for INTERNAL ELECTRIFICATION as listed in Sch 'A’ Part IV.

Lump sum price worked out for PATH/ HARD STANDING as listed in Sch 'A’ Part V.

Lump sum price worked out for SEWAGE DISPOSAL as listed in Sch 'A’ Part VI.

Lump sum price worked out for AREA DRAINAGE as listed in Sch 'A’ Part VII.

Lump sum price worked out for EXTERNAL WATER SUPPLY as listed in Sch 'A’ Part VIII.

Lump sum price worked out for EXTERNAL ELECTRIFICATION as listed in Sch 'A’ Part IX.

Sch 'A’ Part X. BLANK

Lump sum price worked out for COOLING APPLIANCES as listed in Sch 'A’ Part XI

SCHEDULE `A' PART-XII MISCELLANEOUS ITEMS (Note for following items- The contractor shall quote his rate for each of these items separately. The estimated rate is left blank since the same is not prepriced by MES)

INTERNAL ELECTRIFICATION

S&F Lamp holder including 8 Watt LED Lamp suitable for PVC/Polycarbonate type with back plate

S & F MCB FP of rating 100 Amp, 240 Volt, 10 KA, 'C' series.

S & F MCB FP of rating 63 Amp, 240 Volt, 10 KA, 'C' series.

S & F MCB DP of rating 40 Amp, 240 Volt, 10 KA, 'C' series.

S & F MCB SP of rating, 06 to 32 Amp,240 volt, 10 KA 'B' Series.

S & F LED light fittings 18W, 230 Volt, 6000K, wall mounted LED batten & LED Rod seperate, extruded aluminium heat sink provided for efficient heat dissipation & integrated electronic driver, LED rod complete with all accessories internallly prewired and including connecting up with twin core twisted flexible copper conductor cable with suitable size complete all as specified

S&F LED Building light luminaire 1x25W having IP-65 protection,di-cast, aluminium alloy for housing having heat dissipation fins,sturdiness & corrision resistant,roadway luminaire powered by an integral driver , high power LED as light source, minimum lemen efficacy of 100 lm/w including bracket of suitable size with all accessories all as specified

S&F Exhaust fan 300 mm sweep 240 V AC single phase complete with lovers and shutters of any sweep including provision of flexible three core copper conductor cable of 23/0.0076 up to ceiling rose and grouting 04 Nos full threaded bolts and nuts etc all as specified

S&F Ceiling fan 1200 mm sweep complete with blade, canopy and down rod and connecting up to and including provision of flexible three core copper conductor cable 23/0.0076 from ceiling rose to connector block complete all as specified

EXTERNAL WATER SUPPLY

M & L Boring of holes up to 50 mm dia under road pavement, hard standing, etc by trench- less technology using ultra sound technique complete all as specified

EXTERNAL ELECTRIFICATION

M & L Boring of holes up to 80 mm dia under road pavement, hard standing, etc by trench- less technology using ultra sound technique complete all as directed by Engineer-in- charge. Note:- Pipe for protection of cable shall be measured and paid separately.

Supply, install, test and commisioning in replacement of LT panel duly powder coated of suitable size outdoor cubical type factory made, weather & vermin proof made out of CRCA sheet 3.15mm (outdoor type) thick machine pressed CPRI approved with bottom frame made out of angle iron 50mm x 50mm x 6mm and 600mm long 4 legs duly painted with 2 coats of synthetic enamel paint over a coat of red oxide primer on exposed surfaces grouted in PCC 1:2:4 type B1 using 20mm graded stone aggregate blocks of size 30cm x 30cm x 60cm and 100mm thick PCC (1:2:4) type B1 floor over 100mm thick sub base of brick hardcore extended 100mm on all sides below panel body complete and suitable for 415 Volt AC 3 phase, 4 strip having insulated copper bus bar 250 Amps from pole with openable double shutter on both sides (rear and front side) with locking arrangment duly pre-wired with suitable size of copper conductor cable fitted with proper size copper lugs/thimbless and connecting the incoming and outgoing MCCBs with suitable size strip duly bended and drilled and fixed with nuts, bolts & washers from bus bar to MCCBs etc duly fitted with and including the following accesories, complete all as specified and directed by Engineer-in-Charge:- Incoming (i) MCCB 160 Amps, four pole with fixed thermal magnetic release, 415 V AC supply, having rupturing capacity 35 KA - 01 No Outgoing (ii) MCCB 100 Amps, three pole with fixed thermal magnetic release, 415 volts having rupturing capacity 25 KA - 1 Nos (iii) MCCB 63 Amps, three pole with fixed thermal magnetic release, 415 volts having rupturing capacity 25 KA - 2 Nos (iv) Indicating lamps set RYB - 01 Set (v) Ammeter Digital type,0-200 Amp with necessary CT's-01 Nos(vi)Voltmeter Digital type,0-500 Volts,01 Nos

COOLING APPLIANCES

Supply and install hi wall split units indoor/outdoor complete with cordless remote control unit and within built air ioniser and Plasma filterfor better indoor air quality with minimum 3 star rating and EER 3.2 of capacity 1.5 TR.Copper condenser,eco friendly refrigerant ,AC (outdoor & indoor unit)suitable for wall mounted with and including MS powder coated brackets and making/breaking hole through the wall for and passing the suction/discharge line including excess copper tubing if required beyond the length supplied with AC unit but not more than 5.00m and PVC conduit of 15mm dia not exceeding 2.5 m. long in concealed surface of wall for drainage of water, making good to disturbed surfaces with cement mortor of ratio 1:3 over complete all as directed. Note :- Rate for MS powder coated stand and extra copper pipe required shall be deemed to be include in quoted rates.

Supply and install hi wall split units indoor/outdoor complete with cordless remote control unit and within built air ioniser and Plasma filterfor better indoor air quality with minimum 3 star rating and EER 3.2 of capacity 2.0 TR.Copper condenser,eco friendly refrigerant ,AC (outdoor & indoor unit)suitable for wall mounted with and including MS powder coated brackets and making/breaking hole through the wall for and passing the suction/discharge line including excess copper tubing if required beyond the length supplied with AC unit but not more than 5.00m and PVC conduit of 15mm dia not exceeding 2.5 m. long in concealed surface of wall for drainage of water, making good to disturbed surfaces with cement mortor of ratio 1:3 over complete all as directed. Note :- Rate for MS powder coated stand and extra copper pipe required shall be deemed to be include in quoted rates.

S&F Voltage stabilizer for automatic operation single phase naturally air cooled designed for input voltage variation 170 to 280V output voltage stabilized 230V with accuracy of 2.5% and of capacity 3KVA complete all as specified

DMA PROJECTS

M/s SK Traders

S S Infrazone