REPAIR AND MAINTENANCE OF SHAHNEHAR PROJECT IN DISTT KANGRA HP

Amount

Excavation in foundation trenches etc. in earth work in all classification of soil such as pick work,jumper work,blasting hard and soft rock including chiselling where blasting prohibited bailing or pumping out water (Dewatering) upto all lifts and depths, stacking the excavated soil upto any lead from the edge of excavation and then returning the stacked soil in 15cm. layers when required into plinths sides of foundation etc.consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as directed by the Engineer-in-Charge.

Providing and laying jointing and commissioning of HDPE( High Density poiyethylene pipe) of following diameter and class confiming to IS 4984-1995 with fusion welding process including all necessary fitting in all leads and lifts to the entire satisfaction of Engineer-in-charge(Earth work in trenches to be measured and paid separately)

HDPE pipe 180 mm Dia PE-80 PN-4

Providing and laying cement concrete 1:3:6 (1cement :3 sand :6 graded stone agg.20mm nominal size) and curing complete excluding the cost of form work in foundation and plinth within all leads and lifts as per the direction and satisfaction of the Enginee

Providing and laying cement concrete lining in 10 cm thick or less for irrigation channel using cement concrete 1:2:4(1cement:2sand:4graded 20mm nominal size) and curing complete exculding the cost of form work for hand mixed concrete lining in side slope and bed including cement concrete lining under water within all leads liftes as per the direction of the Engineer-in-charge

Foundation, footings, bases of columns and the like mass concrete including entire carriage of material with in all leads and lifts and as per direction and satisfaction of the Engineer-in-charge.

Wall (any thickness but not less than 0.10mtr. thickness) including attached pilasters buttresses, plinth and string courses etc.,from top of foundation up to floor two level with in all leads and lifts and as per directions and satisfaction of Engineer-in-charge.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame30x30x5mm so as to give a fair finish i.e centring ,shuttering ,strutting and propping etc with wooden battans and ballies height of propping and centring below supporting floor to ceiling not exceeding 4mtr,and removal of the same for insitu reinforced concrete and plain concrete work in :

Vertical surface such as walls(any thickness ) partitions and the like including attached pilasters , buttresses,plinth and string courses and the like with in all leads and lifts and as per directions and satisfaction of Engineer-in-charge.

Providing tor steel reinforcement for RCC works including bending winding and placing in potion complete upto floor two level including entire carriage of material withen all leads and lifts.

JOGINDER SINGH (BID ID -526962)

mastan ali (BID ID -529151)