Providing, installation, testing and commissioning of submersible pumpset 10000 GPH X 130 Mtrs Head along with allied work at D/well DC Bela Colony.

Providing, Installation, testing and commissioning of 10000 GPH X 130 Mtr Head submersible pump-set of reputed make confirming to BIS Standard along with allied works at existing D/well DC Bela Colony. The Pump bowl should be of close grained cast iron with renewable wearing rings of bronze material. The Pump shaft shall be of stainless steel, guided with stainless steel distance sleeves /shaft protection sleeves provided with each bowl above and below the stainless steel impeller. The Casing wearing rings shall be of bronze material. The Coupling shall be of Mesh type rigid sleeve of stainless steel, non-slipping type with matching groove and cotter arrangement to suite keyway provided. The Suction case shall be of close grained cast iron material. The motor should be three phase AC supply having nominal speed of 2900 RPM, 415 Volts + 15% of frequency 50 Hz + 3%. The motor should be totally enclosed squirrel cage induction type, water cooled and sealed against outside water being pumped. The windings shall be wet type water lubricated and provided with metal tilting thrust pad designed to take up all untoward load to most unfavourable running conditions. The upper chamber of the submersible pump shall be duly fitted with an NRV so that during stoppage of submersible pumpset reverse water cannot operate the pumpset in reverse rotation. The job involves fabrication of adopter Nipple/reducer nipple approx 0.5 mtr long fabricated out of MS Pipe, of which bottom end diameter is to be reduced to the delivery of Sub. Pump and threading the Pipe for screwing into the delivery portion to the submersible pump and other end of the adopter nipple is welded with MS flange of required size fabricated out of MS Plate for fixing with the column pipe.2 No nuts of required size are to be welded on opposite size of the proper piece so that clamping bolt of the tie rod can passed through it. Fabrication of the tie rod clamping arrangement for clamping the pump and motor to the upper adopter nipple, fabricated out of 40mmx6mm MS Plate as per required size at site. The upper ends of these flat strips should be welded with full threaded bolt 12mm dia. and 10 cm long. These bolts are to be passed through the nuts welded on the adopter nipple piece, tightening of the 12 mm double nuts on both sides including cost of material and labour charges. The Job includes coupling of pump and motor properly checking of movement of the pump, tightening of the adopter nipple to the delivery side of the pump, tightening of tie rod and testing of the pump set in the testing pit at workshop. Shifting of the submersible pump to work site. Extraction of the old submersible pump by using requisite tools/ tackles and manual labour etc. Lowering of submersible pump set into the dug well along with the column pipes by using special tools and tackles. Making all electrical connections of Submersible Pump set with LT control panel by proper thimbling and crimpling all cable ends and then testing and checking for specified amperage on full load. Complete job includes the cost of material, labour charges, other unforeseen material, transportation charges including manual carriage, hire charges of tools and tackles required for execution of job at site. (Complete Job)

M/S RAGHUNATH MECHANICAL AND ELECTRICAL ENGINEERING WORKS

PERFECT ELECTRICAL WORKS