Repair to roof sheet of Milan Mandir

Dismantling Asbestos cement (corrugated, semicorrugated, etc.) sheets in roof coverings .

Demolition cement concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level).

Demolition cement concrete is reinforced (reinforcement cut as required to facilitate demolition) Roofs, floors (other than ground floors), beams, staircases, landing, chajjas and similar suspended work ,

Surface excavation n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out-soft/ loose soil .

Cement concrete in Foundation filling and mass concrete Type D2 1:4:8 ( 40 mm graded aggregate )

Rendering 12 mm thick cement mortar 1:4 on fair faces of brick work or concrete surfaces, finished even and smooth (without using extra cement)

S & F Rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates made with Fe 410 W (Gde-E 250 quality-A)

S & F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete

S&F, Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall,Valley gutter fixed with self tapping screws as specified. Make: TATA/JINDAL/JSW

S&F, Framed work such as grills, gratings, etc. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165

Mild steel barrel tower bolts, stove enamelled black, with bright bolt and fixed 100mm

Preparation of new surface or previously untreated surface and applying two coat synthetic enamel paint (ordinary tint) over one coat of red oxide, zinc chrome primer on steel and iron surface of any description, over 10 cm in width or girth, not otherwise described.

Taking down cement or cement lime plaster, any description on brick or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water, etc.

M & L Vitrified Ceramic tiles light shade 8 mm to10 mm thick (square/ rectangular) polished, area of each tiles exceeding 0.36 sqm but not exceeding 0.42 sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match

Screed bed or bedding layer of mortar 15 mm thick for laying floor finishes, cement plaster 1:4

M & L 75mm thick Cement concrete type B- 2, 1:2:4 (40mm graded aggregate)

M & L 75mm thick Cement concrete type D- 2, 1:4:8 (40mm graded aggregate)

Supply and fixing factory made single extruded WPC (Wood Polymer Composite) solid decorative type flush door shutter of size 30mm thick comprising of virgin polymer of K value 58-60 (Suspension Grade), calcium carbonate and natural fibers (wood powder/ rice husk/ wheat husk) and non toxic additives (maximum toxicity index of 12 for 100 gms) having minimum density of 650 kg/cum and screw withdrawal strength of 1800 N (Face) & 900 N (Edge), minimum compressive strength 50 N/mm2, modulus of elasticity 850 N/mm2 and resistance to spread of flame of Class A category with property of being termite/borer proof, water/moisture proof and fire retardant. WPC to be laminated with PVC foil of minimum 14 microns thick of approved design pasted with hot melt adhesive on both faces of shutter and fixing with stainless steel butt hinges of required size with necessary full body threaded star headed counter sunk S.S screws, all as per direction of Engineer- In- Charge. including: stainless steel butt hinges and necessary S.S screws .

Preparing old surfaces plastered or unplastered and finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shade: New work/old (Two or more coats applied @ 1.43 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm) Make:- Water proof paint Apex (Ultima) Asian/Dulux weathermax/Nerolac

Preparing new surfaces plastered or unplastered and applying two coat of oil emulsion on wall and ceiling, white or tinted make: Asian ( Tractor emulsion) /Nerolac/ICI Dulux.

3mm thick wall care putty on wall & ceiling make JK/BIRLA WHITE CARE/ASIAN/JK LAKHMI

Cutting holes in brick walls in cement mortar or cement lime mortar and stone walls buit in lime mortar, for inserting holdfasts and making good dismantled portion in cement mortar 1:3 or cement concrete 1:2:4 Type B-1 as required, exc half brick but n exc one brick of embeded portion of holdfasts or lugs.

M & L Non asbestos fibre cement building boards 4 mm thick fixed or laid/ inserted to timber/GI/Aluminium framework with screwsfixed in ceiling flat or sloping

S & F Size of grid 605 x 605mm Gl frame work for seamless ceiling comprising of Gl perimeter channnel 0.55 mm thick with two unequal flanges of 20 and 30 mm and web of 27 mm fixed to surrounding wall using nylon sleeves and screws at 450 mm centre to centre/intermediate channel 0.9 mm thick having two equal flanges of 15 mm each and web of 45 mm suspended from soffit at approx 900 mm centre to centre with Gl cleat and steel expansion fasteners with and including ceiling section (not exc 1.2 m length) of 0.55 mm thickness having kurled web of 50 mm and flange of 26 mm each with lips of 10.5 mm fixed to the intermediate channel with connecting clips across the intermediate channel at 457 mm centre to centre. Hangers 6 mm dia. G.I. (upto 1200mm length) adjusting level fixed to roof slabs by means of ceilling cleats made out of G.I. flat 40 x 3 mm size 60mm long and expansion hold fasteners 12.5mm dia. 40mm long complete all as specified

Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips TMT bar.

Finishing cement concrete surface even and smooth Without using extra cement

Glass dividing strips, 3 mm thick 28mm width of strip inserted in position, conform to design

Credit (-) old/unserviceable dismentled steel window frames/grills

M&L of point wiring of One light point or one fan / Exhust fan point controlled by one switch with 1.5 sq mm single core FRLS PVC insulated unsheathed Cable, multi stranded copper conductor,(Make-Kalinga/Plaza/Anchor /Havells only, IS: 694-1992 marked).connected with suitable size of copper lugs-ring tong or bottle type end connector and drawn through and including non rigid PVC concealed conduit 25 mm dia or higher complete all PVC conduit accessories such as socket, elbow, junction box bell mouth reducer bend and flexible conduit fittings etc of PCG/Plaza/Anchor/Vimco/Polycab make, and pipe hooks/saddles, ISI marked including 1.0sq mm multi stranded copper conductor PVC insulated green in color of Kalinga/ Plaza/ Anchor/ Havells make and IS: 694-1992 marked only) as continuous earth conductor connect to common earth and earth dolly with all accessories complete all as specified and directed.

S &F 1.00 mm thick Mild steel, plain, black sheet in wall cladding, steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40 mm lap joints with riveted or welded seams, including bending or turning up, mitred angles, etc. as required but in hearths; covering to door shutters; covering to door chowkats (frames);

S&F wiring for circuit / submain wiring alongwith earth wire with the following sizes of FR PVC insulated copper conductor single core cable in surfase /recessed as required 2X6sq.mm+1X6.0 sq.mm earth wire in PVC conduit. Make- Pipe- Kalinga / Polycab / Plaza only. Make Wire-Havells /Polycab /RR.

S&F wiring for circuit / submain wiring alongwith earth wire with the following sizes of FR PVC insulated copper conductor single core cable in surfase /recessed as required 4X6sq.mm+1x6.0 sq.mm earth wire in PVC conduit. Make- Pipe- Kalinga / Polycab / Plaza only. Make Wire-Havells /Polycab /RR.

Cutting chases, pinning in. making good to facings where required and pointing in cement mortar 1:3 to ends or edges of landings, steps, cills, sunshades, shelves, lintels, etc.; and cutting chases for concealed water tubing or concealed conduit wiring etc., and making good, exceeding 10 cm girth but not exc 20 cm

S&F Switch piano, flush type single pole, one way 5 Amp Make:Anchor/Havells / Legrands.

M& L Ceiling rose, 3 phase/PVC/polycarbonate, isolated body.

Supply and fixing 415V 10KA 'C' curve miniature circuit breaker (MCB) TPN 40 To 100 AMP current carrying capacity in the DB complete with connection testing and commissioning Make:Anchor/ Havells / Legrands.

Taking down carefully copper/ aluminium point wiring (light, fan, socket or power) complete, including fitxure and fitting such as switches, ceiling roses, pendent, regulator, sockets, light fitting etc. to be measured separately, removing materials to store for keeping in safe custody or for re Use,it also includes re-connection of the old fan which are hanging on their old position and removal of old DB's,MCBs and other dismentalling as per site requirement.and making good disturbed surfases of walls,floors,etc.( removal of old Sheet metal enclosures of main DBs are also include.)

Supply & Fixing LED luminaire 600 mm x 600 mm, 35/36 watt, 220 V AC recessed / surface type with high efficiency PMMA diffuser soft glare free light complete with driver, holders & LED lamp suitable for roof ceiling including connecting up with driver three core flexible copper conductor cases of suitable size complete.

Supply and fixing LED lights fitting 1x22, 220V, AC decorative box type with driver, holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete Make Havells / Crompton / Philips.