REPAIR/RENOVETION OF SERVICE ROAD OF DSP MAIN CANAL FROM KM 1.200 TO KM 2.400 LOT 08

Amount

brick edging with IS class - 150 bricks laid morter in both side of the road 7.5 cm wide including cost of all material and labour T&P etc. required for proper completion of the work.as per PWD SOR ch 20

Construction of Embankment with material obtain from Borrow pits. Construction of Embankment with approved material obtain from Borrow pits with all lift and lead, transporting to site ,spreding grading to required slope and compacting to meet requirement of Table-300-2

W.B.M (Grade-3) Providing, laying, spreading and compacting stone aggregates of specific sizes 53mm to 22.4mm to water bound macadam (G-3) specification including spreading in uniform loose thickness hand packing, rolling with smooth wheel roller 80-100 KN in stages to proper grade and camber, applying and brooming, Stone dust to fill-up the interstices of coarse aggregate, watering and compacting 7.50cm thickness to the required density Grading 3 as per Technical Specification Clause 405.

Providing and applying primer coat with bitumen Emulision (ss-1) on prepared surface of grenular base including clearing of road surface spraying primer at the rate of 0.70 kg/ m² using machanical means as per clause 502 MoRD data book.

Providing and applying tack coat with bitumen VG-10 using bitumen distributor at the rate of 0.35 kg per sqm on the prepared bituminous surface cleaned with hydraulic broom as per Technical Specification Clause 503.

Providing, laying and rolling of open graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 (13.2mm & 11.20mm in 2:1) mm aggregates @0.27cum per 10 sqm either using penetration grade bitumen VG-10 @1.46kg per sqm to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of Type B as per Technical Specification Clause 508.

Seal Coat Type-B Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade cross fall using Type-A, B & Type-C as per Technical Specification Clause 510.

Providing and laying PCC (1:1.5:3)including all material labour and T&P etc

Sudha Associates

KUNWAR AMIT SINGH

BAJRANG ENTERPRISES

SHANKAR DAYAL SINGH