MLA-SDF-MLA-SDF 2025-26 Mananthavady LAC Kundala Attachira Seventh mile Road in Panamaram Grama panchayath Mananthavady constituency wayanad district -work-General Civil Work

2.2:Clearing grass and removal of rubbish up to a distance of 50 metres outside the periphery of the area

3.19.2:Loosening, leveling and Compacting original ground supporting embankment to facilitate placement of first layer of embankment, scarified to a depth of 150 mm, mixed with water at OMC and then compacted by rolling so as to achieve minimum dry density as given in Table 300-2 for embankment construction.

4.1.B.3:Granular Sub-Base with Close Graded Material (Table:- 400-1):- By Mix in Place Method - For Grading - III Material Construction of granular sub-base by providing close graded material, spreading in uniform layers with a motor grader on a prepared surface, mixing by mix in-place method with rotavator at OMC, and compacting with a vibratory roller to achieve the desired density, complete as per clause 401

4.12:Providing, laying, spreading and compacting graded stone aggregate to Wet Mix Macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.

5.1.a:Providing and applying primer coat with bitumen emulsion ( SS) on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.70 - 1.0 kg/sqm using mechanical means.

5.2.a:Providing and applying tack coat with bitumen emulsion( RS) using emulsion pressure distributor at the rate of 0.20 - 0.30 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.

OD168368/2025-2026:Providing, laying and rolling of close-graded premix surfacing material of 20 mm thickness composed of 11.2 mm to 0.09 mm (Type-A) aggregates using penetration grade bitumen using V G 30 to the required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a Smooth wheeled roller 8-10 tonne capacity, and finishing to required level and grade. as per Technical Specification Clause 509 of MORD

3.18:Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2

OD168369/2025-2026:Providing and fixing of Project name board for MLA-ADF works with non-retro-reflectorized vinyl sign with 1 year warrenty(manufacture with vinyl printed sheeting fixed over 4 mm thick aluminum composite panel material consisting of 3 mm thick FR grade mineral core sandwiched between two aluminium sheets (each 0.5 mm thick) with area not exceeding 0.9 sqm , with suitable back supporting frame of MS angle 25x25x3 and supported on GI pipe pole 50 mm NB confirming to IS 1239 firmly fixed to the ground by means of properly designed foundation with M15 grade cement concrete min size 30cmx30cmx 45cm, 45 cm below ground level including painting over epoxy primer and as per aproved drawing and clause 801 including lettering symbols etc........