Construction of new Toilet near Bank of India in West Land estate area at OFK.

Amount

Excavation in over area n. exc. 1.5m deep in hard/dense soil and getting out. Removing excavated material n. exc. 50.0M and deposited where directed.

Excavation in over area exc. 1.5m but n exc 3.0m deep in hard/dense soil and getting out. Removing excavated material n. exc. 50.0M and deposited where directed.

Excavation in hard/ dence soil in trenches,n.exc 1.5 m wide and n.exc 1.5m in depth & getting out.Removing excavated material n. exc. 50.0M and deposited where directed.

Surface excavation in hard/ dence soil ,n.exc 30 cm deep and averaging 15 cm deep and getting out.

Boring holes 300mm dia. & 3.00m deep in soil for under reamed piles and getting out and disposal of soil to a distance of n exc. 50m.

M & L Stone dust filling in floors or pavings, laid in layers n. exc. 15 cm thick, spread and levelled and rammed including watering.

M & L hardcore of broken stone or boulder of gauge n. exc. 63mm, deposited, spread,and levelled in layers n. exc. 15 cm thick, watered and rammed to true surface.

Providing cement concrete type C-2, 1:3:6 (40mm graded aggregate)for foundation filling and mass concrete.

S&F 10 mm dia. And over TMT bar cut to length,bent to shape required including cranking, bending etc.and binding with MS wire (annealed) n-less than 0.9mm dia.

S&F 8mm dia.TMT bar cut to length,bent to shape required including cranking, bending etc.and binding with MS wire (annealed) n-less than 0.9mm dia.

S&F 5mm dia. and over up to and including 10 mm in stirrups, spacers and binders.

Form work to side of plinth beams, Rough finished surfaces of concrete Flat.

Form work to side of shelves, lintels, roof beams, Rough finished surfaces of concrete Flat.

Form work to chajjas including edges, Rough finished surfaces of concrete Flat.

Form work to side of Square, rectangular column, Rough finished surfaces of concrete Flat.

Form work to soffits of suspended slabs such as roof slabs, n. exceeding 200 mm, Rough finished surfaces of concrete Flat.

Form work to side of walls of Nalla, surfaces of concrete Flat.

Providing Reinforced cement conc. M-20 (20mm graded aggregate) in plinth beams and foundation.

Providing Reinforced cement conc. M-20 (20mm graded aggregate) in shelves,lintels and Roof beams.

Providing Reinforced cement conc. M-20 (20mm graded aggregate) in Columns.

Providing Reinforced cement conc. M-20 (20mm graded aggregate) in slabs supported on beams and columns.

Providing Reinforced cement concrete M-20 (20mm graded aggregate) for Walls etc.

M&L Brick work with subclass‘B’bricks straight orcurved on planexc 6 m mean radius with 1:4 cement mortor in straight.

M&L Brickwork with subclass‘B’ bricks, straight or curved on plan to any radius in half brick thick walls built in 1:4 cement mortor

M&L Brickwork with sub class‘B’ bricks in one brick thick honey comb walling, built in in one brick thick honey comb work with 1:4 cement mortor.

M & L Loose filling of broken bricks gauge 80 to 150mm in soakage pits.

Providing cement concrete type B-1, 1:2:4 (20mm graded aggregate) for coping.

Providing 55 mm thick cement concrete type B-1, 1:2:4 (20mm graded aggregate) in floors. Surfaces is to be finished even and smooth with using extra cement.

Providing 75 mm thick cement concrete type B-2, 1:2:4 (40mm graded aggregate) in floors. Surfaces is to be finished even and smooth without using extra cement.

Providing 100 mm thick cement concrete type B-2, 1:2:4 (40mm graded aggregate) in floors. Surfaces is to be finished even and smooth without using extra cement.

Rendering 15mm thick cement plastering of 1:4 cement mortar on fair faces of brick work or concrete surfaces and rendreing is to be neeru finished.

Rendering 10mm thick cement plastering of 1:4 cement mortar in ceiling, Rendreing is to be finished even and smooth without using extra cement.

Rendering 15mm thick cement plastering of 1:4 cement mortar on fair faces of brick work or concrete surfaces and rendreing is to be finished even and smooth without using extra cement.

Providing Precast cement concrete Type B-1 1:2:4 (20 mm graded aggregate) for cover slabs, and set in 1:4 cement mortar.

S & F, Glazed ceramic coloured joint free tiles in vertical surface 350x 250x 7 mm /450x 350x 7 mm thick set and jointed in neat cement slurry and pointed in white or colour cement to match over 10 mm thick cement plaster of 1:4 cement mortar.

S&F Non skid ceramic coloured tiles 7 to 8 mm thick area of each tile exc. 0.06 sqm but n. exc. 0.11 sqm Over 15 mm thick Screed bed or bedding layer of 1:4 cement mortar. in floors etc., set and jointed in neat cement slurry and pointed in coloured cement to match.

Forming square grooves in plaster n. exc. 12mm deep and n. exc. 15 mm on face.

S & F vitreous china wash down water closet ( Pedestal pattern ), White including plastic water closet seat, black, closed pattern with flat bottom and cover and mild steel chromium plated or aluminised hinging device with PVC valveless syphonic action flusing cistern low level white with inlet ball valve, float and handle including brakets, flush pipe of polyethylene of low or high density PVC 32 mm dia .

S & F Vitreous China urinals white colour, half stall type complete including providing and fixing plugs, bedding urinal against wall in cement mortar 1:2, securing urinal to plugs with and including 60mm long brass screws, pointing around urinal back in cement, grating and Union for discharge pipe.

S & F of wash basins, vitreous China (flat back or angle back type) any size 630x450mm, including cuttin for and pinning inn ends of brackets or erecting stand but exculsive of fixing of supply and waste pipe.

S&F Solid PVC Door frame of size 50 mm x 47 mm made out 5 mm plain colour PVC sheet reinforced with M.S. square tube, fixed in opening as per specification & drawing.

S&F factory made Solid PVC Door shutter 30 mm thick ( style) consisting of frame made out of M.S. square tube for top & bottom rails. M.S. frame shall be covered with heat moulded plain colour PVC 'C' channel having a PVC sheet strip of 20 mm width stuck inside with solvent cement for stiles and plain colour PVC sheet for top rail, lock rail & bottom rail on either side etc. & fixing in the frame at site as per specification & drawing.

S&F M.S. butt hinges of 100mm size medium weight, cold rolled mild steel .

S&F Alluminium alloy handles, of 150mm size cast type anodised.

S&F Aluminium, anodised, barrel tower bolts 200mm length of extruded section .

S&F M.S. grills, barred iron doors etc. conforming to Fe 410-O or Fe 310-O.

M&L 75mm dia PVC(SWR) floor trap, plain with grating including jointing with solvent cement.

S&F 110 mm dia PVC (SWR) junction single, ( single T), equal or unequal with access door.

S&F 110 mm dia PVC (SWR) junction single, ( single T), equal or unequal.

S&F 110 mm dia PVC (SWR) bends any radius.

S&F 110 mm dia PVC (SWR) soil, waste and vent pipes single socketed, in any length with rubber ring joints, laid in trenches or in floors.

S&F 110 mm dia PVC (SWR) soil, waste and vent pipes single socketed, in any length with rubber ring joints, fixed to walls.

S&F 110 mm dia PVC (SWR) vent cowl.

S& F of 1000 ltr capacity rotational moulded polyethylene water storage tank (cylinderical vertical with closed top) hoisted and fixed as per specification.

S&F 15 mm medium grade G.I. steel tubes, with all fitting and fixed complete to walls and ceiling or laid in floors.

S&F 15 mm dia Stop valve of PTMT any colour high pressure screwed for iron pipe and fixed.(Minimum weight 15mm-90gms/ 20mm- 92gms), screwed both ends for iron pipe & fixed.

S&F 20 mm medium grade G.I. steel tubes, with all fitting and fixed complete to walls and ceiling or laid in floors.

S&F 20 mm dia stop valve, cast copper alloy, screwed down ,high pressure ,with crutch or butterfly handle, screwed both ends for iron pipe or for union & fixed.

S & F 15 mm Bib taps standard of PTMT any colour high pressure screwed for iron pipe and fixed. (Minimum weight 90 gms)

Preparation of New steel surfaces of any description over 10 cm in width/girth and applying two coat of 1st.Quality Synthetic enamel paint over red oxide priming coat.

Preparation of New wall surfaces and applying two coats of colour washing on unde corated surfaces .

Preparation of New ceiling surfaces and applying two coats of colour washing on unde corated surfaces .

Preparation of new plastered surfaces and applying two coat of cement paint .

One light point controlled by one switch, point wiring will be done with 1100 Volts grade PVC insulated sheathed single core 1.5 Sq.mm stranded copper wire, drawn in surface/recessed rigid Steel stove enamalled conduit ISI marked. 16 gauge with steel terminal boxes sunk on wall/ M.S. structure for mounting of switches and including fittings such as bends elbows, coupling and others accessories and as per IS fixed with spacers, saddles, screws, coupling with 14 SWG continous GI earth wire . complete all as specified and directed with M & L. Make of wire- Havells/Finolex/Polycab/sterlite or equivalent (Maximum 5 point in one circuit, separate wiring for each circuit & individual switch for each point ).

S & F switch piano type flush button 5A SP one way Make : SSK/Havell's/Polycab/C&S/HPL/ Anchor or equivalent

S & F Lamp Holder PVC/ polycorbonate type with back plate suitable for battan fitting complete.ISI Marked Make : SSK/Havell's/Polycab/C&S/HPL/ Anchor or equivalent

S & F Ceiling rose, 3 phase/PVC/polycorbonate, isolated body with material and labour.Make : SSK/Havell's/Polycab/C&S/HPL/ Anchor or equivalent

S & L of 2 core XLPE insulated and armoured heavy duty cable with stranded Al conductor, 1100 voltage grade, size 10 sq mm including termination both the ends with proper lugs, glands. Make : Havells/Finolex/Polycab/sterlite/KEI/Unistar or equivalent

Excavation in trenches not exceeding 0.5m wide and 0.75m depth and getting it out in hard/dense soil for laying of U/G cable.

Sand cushioning in cable trench 15 cm thick including material and labour.

M & L reinforced precast concrete cable cover class LV Type 2 flate size 300mmx180mmx40mm.

Returning filling in including spreading, watering and well raming in layers not exceeding 25cm.

S & L Tube medium grade galvanised 50 mm dia IS marked with all fittings ror protection u/g cables Make : TATA/Jindal/Zenith/Swastic or equivalent

S & F( with suitable size MS bracing with nutbolt) of SPN DB 4 way IP 42 protection, metal double door, universal mounting with 200 Amps rated Bus bar, neutral bar, Earth bar and cable ties for cable management, top & bottom removable gland plates with blanking plates & all connections with copper lugs ISI Marked . DB consist of the following : (a) Incommer MCB DP 32 Amps, 240/415 voltsAC, 10 KA ISI marked confermed to IS 8828 /IEC 60898 Qty 1 Nos (b) Out going Isolator MCB SP 6 to 40 Amps 240/415 volt AC, 10KA ISI marked confermed to IS 8828 /IEC 60898 Qty 2 Nos. Make: Legrand/C&S/Polycab/SSK/Havell's/Anchor/Standard or equivalent .

S&F of 20W-4FT. White LED self ballasted, 230V, AC, 50Hz, color temp. (K) 5500-6700, 1700 Flux , retrofit T8 tube light with powder coated CRCA Patti. Complete with all accessories internally pre-wired and including connecting up with twin core twisted flexible copper conductor cable with suitable size. Make: C&S/Phillips/Havells/Bajaj/CG/Osram or equivalent . Test certificate & Warranty certificate from OEM to be submitted with material.

Earthing complete (including excavation of soil) with GI plate electrode 600x600x6.3mm thick burried directly in ground (earth plate not less than 2.25m below ground level) with top edge of the plate not less than 1.5m below normal ground level and duly filled with alternate layer of char coal & salt from 150mm below the plate to 150mm above the plate (total 900mm thick) connected to GI earth strip size 25x4mm in GI protection pipe of size 40mm dia upto 7.5m long by means of nuts, bolts, washers, check nuts of GI steel, fitted with funnel complete all as per procedure and as shown in SSR electrical plate No. 5 connected to earth test point/earth bus (to be provided near incoming mains) all as specified and testing including RCC earth pit chamber duly cement plaster finished and RCC pit cover 1mX1mX150mm, PCC hard standing surrounding the earth pit chamber, location of the earth pit marked on the nearest wall to be written with paint (for distance & value of earth pit) with material and labour. Earth pit chamber will be made 0.5m above the ground level.

SHRI KRISHNA CONSTRUCTION (BID ID -743826)