Sustainability of LWSS Thural Bharanta (Panjlehar Source) Covered under LWSS Thural Bharanta

Amount

Excavation in foundation for digging well in dry excavation from GL upto the level,where well curb is placed from natyral surface to 1.50 metre depth . as directed by the Engineer-in-charge clear from the edge of the excavation and then returning the stacked soil in 15cm layers, when required into plinths, sides of foundation etc. consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as directed by the Engineer-in-charge.

Wet well sinking gravel including all pumping ,soring etc. complete in all respec as per direction and to the entire satisfaction of the Engineer-in-charge.

From spring level to 3.00 metre depth as per direction and to the entire satisfaction of the Engineer-in-charge.

From spring level to 3.00 metre to 6.00 metre depth as per direction and to the entire satisfaction of the Engineer-in-charge.

Steel work in single section i/c cutting ,hoisting & fixing in position etc.in RS Joists,channel ,angles & tees etc.as per direction and to the entire satisfaction of the Engineer-in-charge.

Lowering of well curb complete in all respect as per direction of Engineer in charge

Providing and laying cement concrete 1:1.5:3(1cement:1.5 sand:3 graded stone aggregate 20 mm nominal size)and curing complete excluding the cost of form work and reinforcement for reinforced concrete work in:-

Flat surfaces such as soffits & suspended floors,roofs landing and the like. complete in all respect as per direction and to the entire satisfaction of the Engineer-in-charge.

Columns,Pillars & Post etc.complete in all respect as per direction and to the entire satisfaction of the Engineer-in-charge.

Prividing and laying no fine concrete 1:4 (1cement :4 stone concrete ) complete in all respect as per direction and to the entire satisfaction of the Engineer-in-charge.

Providing form work with steel plated 3.15mm thick welded with angle iron in frame 30x30x5mm, so as to give a fair finish including centring,shuttering,strutting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor to ceiling not exceeding 4 meters and removal of the same for insitu-reinforced concrete and plain.

Vertical surfaces such as walls(any thickness) partitions and the like including attached pilasters, buttresses, plinth and string courses and the like complete in all respect as per direction and to the entire satisfaction of the Engineer-in-charge.

Beam cantilevers,gireder & lintels,sides & soffits of beams,Hunching ,cantilevers,bressumers 1.00 mtrs in depth in all heights from floor

Dead wall above no Fine Concrete complete in all respect as per direction and to the entire satisfaction of the Engineer-in-charge.

Flat surfaces such as soffits & suspended floors,roofs landing and the like. complete in all respect as per direction and to the entire satisfaction of the Engineer-in-charge.

Providing mild or tor steel reinforcement for RCC. Work including bending binding and placing in position complete upto floor two level Tor steel in all leads and lifts.

Providing 200 mm wide CI Rungs with chequered or ribbed non slip surface i/c fixing in structure with 200x200x100 mm cement concrete 1:3;6( 1cement :3sand :6graded stone aggregate 20 mm nominal size ) complete in all respect as per direction of Engineer in charge

Boulder /stone filling dry hand packed tightly complete under lean conrete to prevent the entry of surfacr water complete in all respect as per direction of Engineer in charge

VINAY KUMAR GOVT CONT

KARAN BEDI GOVT CONT

RAJE ENGINNERING WORKS

SUNIL KUMAR