Drawing 11KV Covered Conductor from ThekkekurisuAmbazhakkadPPK Transformer

Dismantling one damaged 11kV PSC/RCC pole after disconnecting stays, strut etc.attached thereon and stacking the same.

Providing concrete muffing of size 0.45x0. 45x1.5m (0.5m above GL and 1m below GL). Excavation 0.45x0.45x1m, concrete (1:3:6, 20mm) 0.45x0.45x1.5m, Plastering (1:3) 12mm 0.45x0.45mx5sides.

Additional rate for refitting/redoing one Disc set while renewing any type of 11kV cut pole.

Fitting and erecting one HT A type Single Pole in position, including fitting cross arm, digging and back filling pit in ordinary soil (as per standards), drawing sufficient length of GI earthing leads from F clamp through V cross arm to the ground for earthing (excluding provision of earthing).

Additional rate for providing one disc set, PG clamp etc. complete, on any type of HT pole for making cut point.

Labour charges for loading HT A type pole from the stacking place and unloading the same at work site (transportation by any vehicle).

Dismantling (without damage) one 11kV PSC/RCC pole after disconnecting stays, strut etc. attached thereon and stacking the same.

Fiting One no MVT on existing cross arm including 2 nos end termination (for One phase) of any rating for 11 kV AB Cable

Transferring LT three phase 4/5 wire OH line to newly erected HT/LT pole including dismantling existing cross arm and insulators, refitting the same on the new pole, binding etc. complete.

Dismantling (without damage) one HT stay including digging pit in all classes of soil and backfilling, and bringing back to section store.