EXTENSION OF PARKING PLACE AND PROVISION OF CANOPY, STREET LIGHT ETC AT TREK ROUTE FROM ENTRY GATE TO TIGER FALL, CHAKRATA DISTT .DEHRADUN

Amount

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:2:4 (1 cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade :Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size)

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. Hot finished welded type tubes

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer?in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete :Ridges plain (500 - 600mm)

S/F of RCC seating benches complete in all respect

Supply and fixing of Retro reflective Sign board Board made up of Stainless steel heavy frame (304) grade 2"tuber pipe stand,1" Square Double side frame with Alex ACP base and lettring & logo by Retro 3mm reflective tape work completed (Single Side) size 3x4' x10' ht / 3x2'x10'ht

WGSTLMOD point wiring in pvc conduit , with modular type switch : wiring for light / fan point / call bell point with 1.5 sq.mm FR PVC insulated copper conductor core cable im surface recessed pvc conduit with modular switch , modular plate , suitable GF box abd earthing the point with 1.5 sq.mm FR PVC insulated copper conductor single core cable etc as required. Group A

LPACCMOD S/F Light plug point modular type accesorries : each supplying and fixing suitable size GI box with modular plae and cover in front on surface and recess , including providing and fixing 3 pin 5/6 amps modular sockets outlet and 5/6 amps modular socket outlet and 5/6 amps modular switch, connecton ,painting etc. as required .(for light plugs to be used in non residentials buildings)

Wiring for circuit/ submain wiring alongwith earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class PVC conduit as required. 2 x 1.5 sq. mm + 1 x 1.5 sq. mm earth wire

S/ Wiring of submain with following sizes of FRLS PVC insulated copper conductor, single core cable with 3x1.5sqmm through Pole as required.

Supplying and fixing following way, single pole and neutral, sheet steel, MCB distribution board, 240 V, on surface/ recess,complete with tinned copper bus bar, neutral bus bar, earth bar, din bar, interconnections, powder painted including earthing etc. as required. (But without MCB/RCCB/Isolator) : 6 way, Double door

S/F 'B' series, SP MCB Supplying and fixing 5 amps to 32 amps rating, 240 volts, 'B' series, miniature circuit breaker suitable for lighting and other loads of folloeing poles int the existing MCB DB complete with connections, testing and commissioning etc. as required.Single pole

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size direct in ground including excavation and refilling the trench etc as required, but excluding sand cushioning and protective covering. Upto 35 sq.

Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required.

Supplying and laying 6 SWG G.I. wire at 0.50 metre below ground level for conductor earth electrode, including connection/ termination with GI thimble etc. as required.

Supply and fixing of Energy saving Envioramental friendly long life Exclusive innovative die cost alluminimum 30 watt RGB flood liight with hogh power sutiable for high .

Supplying and fixingf of Surface LED light fiting 9W , 830 including complete with making connection and complite with all respect directed /approved by E/I

Supply and fixing of G.I ST pole SP-10 (Bottom Portion hot dip ) 6 Mtr. Long with Clamp ,Nut bolt ,Insulator for pole ,with paint finish Compatible in all respect.

cost of foundation ,Erection & Grouting of pole in cc 1:4:8with size 0.45x0.45x1.5 Mtr digging & refiling of pit & fixing all Accesoty with muffing complete including labour and painting charge L.S

Supply of fixingh of factory eired ISI/ ECRTIFIED LED street light 25 W Capacity pressure dia cast or extruded Aluminium housing with corrossion resistant polyster powder coated side entry type shall consist at separate and control gear campatoment thoughened glass energy afficenvy LP- 18 watt operation voltage 140-270 HZ freequency 140-270 V electronic driver with internal surge protection of 4 KV street light should be protected with short circuit open circuit Reverse polarity and automatic safe shut down after 300 V AC and below 100 V A.C as per direction by E/I complete in all respect.

Suplly of PVC Insulated Armoured Alimnium XLPE sheathed cable 10sq. mm 2 core complete in all respect

Supplying and Fixing of pole PVC/M.S Box encloser type complete with clamp and connection

Supplying and Fixing of 63mm OD & ID 51mm DWC / HDPE pipe Laying in direct in ground around the cable

Supplying /Febrcation/ Instalation of feeder piller, incoming 1 no -63 amp MCCB and Alimnium BusBar Complete with stand 2 feet height with Arrargerment for Protection from Snow & Rain complete with making connections, complete in all respects, as As per direction by E/I.

Supply and fixing of 6 sqmm 2 core weather proof aluminium service cable .complete with connection and all respect.

Provision of 5 KW Electric Connection from UPCL

MAHAVEER SINGH CHAUHAN (BID ID -347145)

Sanjay Joshi (BID ID -347054)