NIeT- 16 OF 2025-2026

Cost of MS longitudinal welded pipe in Bare condition as per IS : 3589-2002, Gr- Fe410, per Meter length of different diameter and thickness including cost of loading, unloading and freight charges @ 1480 KM from factory to delivery at site, excluding GST and Cess Thickness 8 mm 150 mm dia. (internal)

Fabrication and supplying slip (ii) 150 mm dia (ID)

a)Supplying of flange soket tail piece i) 100 mm dia

ii) 150 mm dia

b) flange reducer 150 x 100

Supply and application of paint on the surface of grill net flat bar railing round barand other M.S structural member such as joist channel and angle with application of one coat of epoxy primer ( 100 micron th.) and two finish coat of epoxy paint (100 micron th.) of Berjer or equivalent mark including scrapping brushing and cleaning with necessary tools and tackles as per dirrection of EIC

Making flange joint to C.I. pipes, specials and valves where necessary with supply of necessary rubber insertion, bolts, nuts, washers etc. of approved quality and type and painting complete as per specification and direction of the Engineer-In-Charge. i) 100 mm Dia (ID)

ii) 150 mm Dia (ID)

Cutting DI pipe (all class & type) to required length with cutting device etc. and grinding the cutting portion with file as per direction and satisfaction of EIC. a) 100 mm dia

b) 150mm.dia. to 200mm.dia pipe

Chamfering the spigot end of all type/class of DI pipe for proper using of push joint by means of grinder set at site for proper joint etc. all complete as per direction of EIC. a) 100mm dia.

b) 150mm dia.

Lowring MS pipe and Specials in trench upto a depth of 3.0 meter below GL, laying and jointing the same inside the trench / Over ground by means of Granty / Hydra and field joint by means of Electric arc welding using standerd Electrodes per IS specification etc. all complete i) 150 mm Dia

Bailing out water by pump including all leads lifts and including making all arrangements for disposal where continuous flow or seepage of water is encountered an rating of pumps and hours of operation is specifically ascertained as per direction of Engineer-in-Charge.

Hire Charges of JCB for cutting of road and concrete, lifting heavy specils and anyother works related to water supply.

Cutting to requisite length or shape departmental R.S. joists, channels, angles, tees, plates etc. Payment to be made on area of cut surface) 150mm, dia pipe (ID)

Welding in M.S. structural work with gas or electric: (i) Continuous weld.

Hire and labour charges for shoring work including necessary close plank walling, framing, sal bullah pilling, strutting etc.) omplete as per direction of the Engineer-in-charge for foundation excavation in trenches, rafts etc. (vertical surface of ontact area with supporting earth to be measured. Payment fior penetration will not be allowed. (This item shall be executed only after getting approval from the Engineer-in-charge) Depth upto 1.50 m.

above 1.50 mtr

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction. (a) For works in foundation, basement and upto roof of ground floor/upto 4 m (i) Tor steel/Mild Steel (a) SAIL/ TATA/RINL

Hire & labour charges for shuttering with centering and necessary staging upto 4 mt. using stout props and thick hard hard wood planks with approved thickness with required bracing for concrete work either curved or straight includingfitting, fixing and striking out after completion of work. a) 25mm to 30mm shuttering without staging.

Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. (i) Pakur Variety

(A) Filling in foundation or plinth by fine sand in layers not exceeding 150 mm as directed and consolidating the same by thorough saturation withwater, ramming complete including the cost of supplyof sand. (payment to be made on measurement off finished quantity

Making lighting arrangement for continuation work during night including all charges (Applicable exclusively for emergency situation and as per direction of EIC.)

Extra labour Engaged for cleaning mud etc and any other works as directed.

Any other necessary items as per prevailing current P.W.D. & P.H.E. approved Schedule of rates of Kolkata/24Pgs.(N&S)/ New Town W/S. Circle/Area of Kalyani Sub-Division (Building & Plumbing) w.e.f. 01.11.2017 & latest modified corrigendum, thereof and approved schedule of P.H.E. Dte will be applicable.

Add GST @18%

Add Cess @1%

Please Enable Macros to View BoQ information