Construction work of 06 No 4x4 m span box culvert on the drain situated between Ramnagar Lahabdi to Ranipurwa link road in Lakhimpur Kheri district

Bridge Portion Excavation for road work in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross ections, and transporting to the embankment location within all lifts and lead up to 1000m

Sand filling in plingth including supply of necessary quantity of sand from a distance not exceeding 8 km. (5 miles) from the site of work and including watering, dressing etc. Rate to include cost of all materials. Labour and T&P etc required for proper completion of the work.

Boring with 100 mm dia casing pipe for dewatering including cost of pipes, other materials, labour charges etc. complete.

Dewatering the ground water for trenches with hire, operational & fuel charges of pump with oprater complete

Plain cement concrement 1:3:6 nominal mix in foundation with crushed aggregate 40 mm nominal size mechanically mixed,placed in foundation and compected by vibration including curing for 14 days.

Providing and laying reinforced cement concrete M 25 grade in superstructure as per drawing and technical specifications clauses 800, 1205.4 and 1205.5

Construction of only plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M 30 (Grade), coarse and fine aggregates conforming to IS: 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints,curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501.

Supplying fitting and placing HYSD bar reinforcement in superstructure complete as per drawing and Technical Specifications clauses 1002, 1010 and 1202

Poviding Weephole in Brick masonry/Plain/Rainforcement concreet slab abutment, wing wall ith 100 mm dia ac pipe extending through the full width of the ructure with slop of IV:20H towards drawing face complete as per and sorcifacation as MORTH Soze 2706 and 2200

Drainage Spouts complete as per drawing and Technical specification

Diversion Construction of embankment (Caried Earth) with approved material bined froin availble land as perinitted and approved by Charge and as per Technical Specitaion Clause 301.3.4.1, with all lifts and leads, spreading, grading to required slope and compacting to meet rewirement of Tables, 300.1 and 300.2 as per Technical Specification Clause 301.5

Supply and laying of RCC Hume pipe 1000mm dia including cost of all material, carriage upto site, loading and unloading, all labour and taxes, work complete as per direction of E/M for cross drainage in route diversion.

Brick soiling with straight over burnt brick laid on edge and dry brick ledging on both sides including preparation of sub grade to required camber, filling joints with local earth spreading blinding coats 1 cm. deep of local earth including all labour T&P etc required for proper completion of work. As Per Sl No 762(b)

Protection Work Providing and laying boulder apron for bed protection with stone boulders of minimum size and weight as per Table 1300.1, no fragment weighing Not less than 25 kg laid dry complete as per drawing and technical specifications Clause 1301

Providing and laying filter material underneath pitching in slopes complete as per drawing and technical specifications Clause 1302

Add Approch road Construction of embankment with approved material obtained from borrow pits(carted earth) with a lift upto 1.5m & lead up to 1000 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 .

Construction of embankment with approved material obtained from availble land as permitted and approved by Engineer-in-Charge and as per Technical Specitaion Clause 301.3.4.1, with all lifts and leads, spreading, grading to required slope and compacti

Excavation for road work in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead up to 1000m

Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401.

Providing ,Laying ,spreading and compacting stone aggregates of 63-45 mm size to water bound macadam specification including spreading in uniform thickness , hand packing ,rolling with Smooth wheel roller 80-100 KN in stages to proper grade and camber ,ap

Providing ,Laying ,spreading and compacting stone aggregates of 53-22.4 mm size to water bound macadam specification including spreading in uniform thickness , hand packing ,rolling with Smooth wheel roller 80-100 KN in stages to proper grade and camber ,

Brick edging on both sides of the road with first class bricks 8 cm wide & 12 cm deep laid with mudmortar including labour & supply of bricks finished to required template and in proper alingment and also including dressing & ramming the excavated earth as directed by the Engineer - in -charge. as per SI No 765

Providing and applying primer coat with bitumen emulsion (SS) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.75kg/sqm usingmannual means .

Providing and applying tack coat with VG-10 using Bitumen distributor at the rate of 0.35 kg per sqm on the prepared surface cleaned with hydraulic broom .

Providing laying & rolling of open graded premix carpet of 20 mm thickness composed of 13.2mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line ,grade and level to serve as wearing course on a previously prepared ba

Providing and laying seal coat 'C' Type sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall .

Construction of Shoulder with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirment of Tables 300.1 and 300.2 with lend upto 1000 m as per Technical

Supply of informatory sign boards size 1200X900 mm fabricated with 18 gauge MS sheet fitted in angle iron frame size 40X40X5 mm & 11 fit long 2 legs and a crosss will be in legs proper all electrically welded and printed flex pasted (mounted) as it all co

Please Enable Macros to View BoQ information