LAC-ADS-Neyyatinkkara LAC-Work Proposed by Sri. K Ansalan MLA- Project No. 24198- Construction of Turf in GHSS Boys in Neyyattinkara, Thiruvananthapuram District-General

Amount

Turf Base Preparation

4.11.2 Granular sub-base/base/surface course with local materials (Table 400.13) by mix in place method normal. Construction of granular sub-base by providing local material spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at once and compacting with smooth wheel roller to achieve the desired density complete as per Clause 401.4 as per Technical Specification Clause 408. (ii) Using Gravel mix soil.

OD26722/2025-2026 Supplaying and laying two layer of 45- 22.4 mm grade broken stone (70%) and 22.4-2.36 mm graded broken stone (30%) as base course above GSB including spreading ,rolling etc complete for the proper draining of water and proper base of Turf laying.

Turf Construction

2.8.1 Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

OD26723/2025-2026 Supplying and laying non wooven geo textile of 200 gsm over the compacted layer of 12 mm to avoid veeds and getting cushion and reinforcing effect to turf formation. The rate inclusive of geo textile, laying , fevicol SR 998 for pasting etc complete.

4.1.8 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources)

50.6.1.1 Solid block masonry using pre cast solid blocks ( factory made) of size 40x20x20cm or nearest available size confirming to IS 2185 part 1 of 1979 for foundation and plinth with thickness 20 cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etc complete

4.1.6 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources : 6 graded stone aggregate 40 mm nominal size derived from natural sources)

5.1.2 Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size derived from natural sources)

5.22.6 Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more

10.1 Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

4.3.1 Centering and shuttering including strutting, propping etc. and removal of form work for:Foundations, footings, bases for columns

13.1.1 12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

60.7.2 DR PACKING Under foundation - Dry stone packing under foundation with good quality blasted rubble including conveyance of material and labour charges etc. complete as per direction of departmental officers at site.

OD26724/2025-2026 Supplying laying and fixing RCC rings of 1.20m dia , 30cm depth and 75mm thick for soak pit

50.10.2 Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

10.16.2 Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished seamless type tubes

50.18.9.9.1 Providing and fixing PVC pipes includings jointing of pipes with one step PVC solvent cement, trenching, refilling & testing of Joints complete as per direction of engineer in charge.110 mm dia 6Kgf/cm2

OD26726/2025-2026 Providing and fixing PVC pipes includings jointing of pipes with one step PVC solvent cement, Laying complete as per direction of engineer in charge.110 mm dia 6Kgf/cm2

OD26727/2025-2026 Supplying and laying FIFA approved Turf of bellin Turf grass / Royal grass /Tiger grass/Mavery or equalent etc of duel or single colour of detex of 14000 or equalent with stiches not less than 14 stiches per 10 cm and backing double PP+PV . The rate inclusive of joining with seaming tape ,joining with gum of good quality and making good alignment, and providing white lines for football purposes etc complete

OD26728/2025-2026 Supplying and laying Silica granules above the Turf @ 20-24 Kg/m2.

OD26725/2025-2026 Supplying and laying Rubber granules above the Turf @ 7.50 Kg/m2 including placing , brushing etc complete.

OD26729/2025-2026 Supplying and laying 50x50mm square nylon net all around the turf and top roof covering using 2.50, 1 mm nylon thread net and tying with nylonerope etc complete.

13.61.1 Painting with synthetic enamel paint of approved brand and manufacture to give an even shade:Two or more coats on new work

OD33719/2025-2026 S/F Name board of size 75*60cm installed in approprate place visibile to the public made of brick wall with granite plaque incerted an engraving letters completeas per direction of deptl. officers at sit .

LS Amount for Electrification

EXCLUSIVE OF GST

Note :1 All materials, Items, Equipment shall be best branded items with IS and approved by client/KEL

2:Rate should be inclusive of Insurance,Transportation, delivery and installation cost for all items

3.Rate should be Exclusive of GST.

4.Work should be executed as per DSR/PWD specification and direction of Engineer at site.

5.CEMENT: Make use Malabar cement only as per Govt. direction and in case of non availabilty of Malabar cement use Ultra Tech, Dalmia, Ramco or eq. brand in the order of preference.

6.RCC: (Assessment of strength of concrete by Cube testing at Approved Govt labs as per IS) Cement make: Use Malabar cement only as per Govt. direction and in case of non availabilty of Malabar cement use Ultra Tech, Dalmia, Ramco or eq. brand in the order of preference.

7.STEEL REINFORCEMENT: Make: Tata,Vaishak, SAIL, JSW or eq primary make in the order of preference

8.CENTERING & SHUTTERING: (Centering and shuttering for different category of work may be considered separately.)

9. SOLID BLOCK MASONRY: Min. average compressive strength as per IS shall be 40-50kg/cm2 and has to be assessed by testing at Govt. lab. ( Variation in rate due to change in size of block and level of floor as per DSR/PRICE has to be considered)

10.Rigid PVCPipes/Casing & Capping - A-ONE/REPUTED MAKE with ISI , Precession, Balco, GEO

GRANULAR SUB BASE: Quantity by level calculation & reporting to CTE as per norms

meconconstructions (BID ID -2273655)

Shyja Suresh K (BID ID -2273605)